| 1. |
- Chai, Gaoda, et al.
(författare)
-
Deciphering the Role of Chalcogen-Containing Heterocycles in Nonfullerene Acceptors for Organic Solar Cells
- 2020
-
Ingår i: ACS Energy Letters. - : AMER CHEMICAL SOC. - 2380-8195. ; 5:11, s. 3415-3425
-
Tidskriftsartikel (refereegranskat)abstract
- The field of organic solar cells has experienced paradigm-shifting changes in recent years because of the emergence of nonfullerene acceptors (NFAs). It is critically important to gain more insight into the structure-property relationship of the emerging A-DAD-A-type NFAs. In this Letter, a family of NFAs named BPF-4F, BPT-4F, and BPS-4F incorporating various chalcogen-containing heterocycles, i.e., furan, thiophene, and selenophene, respectively, was designed and synthesized. These NFAs exhibited dramatic differences in their photovoltaic performances with device efficiencies of 16.8% achieved by the thiophene-based cells, which was much higher than the furan-based ones (12.6%). In addition, the selenophene-based NFA showed a red-shifted absorption relative to the furan- and thiophene-based ones and obtained a decent efficiency of 16.3% owing to an improved J(SC). The reasons why these NFAs performed differently are systematically studied by comparing their optoelectronic properties and film morphology, which provides new understandings of the molecular design of high-performance NFAs.
|
|
| 2. |
- Luo, Zhenghui, et al.
(författare)
-
Fine-Tuning Energy Levels via Asymmetric End Groups Enables Polymer Solar Cells with Efficiencies over 17%
- 2020
-
Ingår i: Joule. - : CELL PRESS. - 2542-4351. ; 4:6, s. 1236-1247
-
Tidskriftsartikel (refereegranskat)abstract
- Generally, it is important to fine-tune the energy levels of donor and acceptor materials in the field of polymer solar cell (PSCs) to achieve a minimal highest occupied molecular orbital (HOMO) energy offset, which yet is still sufficient for charge separation. Based on the high-performance small-molecule acceptor (SMA) of BTP-4F, we modified the end groups of BTP-4F from IC-2F to CPTCN-Cl. It was found that when both end groups were substituted by CPTCN-Cl, the energy level upshift was too large that caused unfavorable energetic alignment, thus poor device performance. By using the strategy of asymmetric end groups, we were able to achieve near optimal energy level match, resulting in higher open-circuit voltage (V-OC) and power conversion efficiency (PCE) compared with those given by the PM6:BTP-4F system. Our strategy can be useful and potentially applied to othermaterial systems for maximizing efficiency of non-fullerene PSCs.
|
|
| 3. |
- Ma, Ruijie, et al.
(författare)
-
Adding a Third Component with Reduced Miscibility and Higher LUMO Level Enables Efficient Ternary Organic Solar Cells
- 2020
-
Ingår i: ACS Energy Letters. - : American Chemical Society (ACS). - 2380-8195. ; 5:8, s. 2711-2720
-
Tidskriftsartikel (refereegranskat)abstract
- It is widely known that the miscibility between donor and acceptor is a crucial factor that affects the morphology and thus device performance of nonfullerene organic solar cells (OSCs). In this Letter, we show that incorporating a third component with lower miscibility and higher lowest unoccupied molecular orbital (LUMO) level into the state-of-the-art PM6:Y6 system can significantly enhance the performance of devices. The best results of the ternary devices are achieved by adding a small molecular acceptor named ITCPTC (similar to 5% w/w), which significantly improves the power conversion efficiency (PCE) of the host system from 16.44% to 17.42%. The higher LUMO of the third component increases the open-circuit voltage (V-oc), while the low miscibility enlarges the domains and leads to improved short-circuit current density (J(sc)) and fill factor (FF). The efficacy of this strategy is supported by using other nonfullerene third components including an asymmetric small molecule (N7IT) and a polymer acceptor (PF2-DTC), which play the same role as ITCPTC and boost the PCEs to 16.96% and 17.04%, respectively. Our approach can be potentially applied to a wide range of OSC material systems and should facilitate the development of the OSC field.
|
|
