1. |
- Schael, S, et al.
(författare)
-
Precision electroweak measurements on the Z resonance
- 2006
-
Ingår i: Physics Reports. - : Elsevier BV. - 0370-1573 .- 1873-6270. ; 427:5-6, s. 257-454
-
Forskningsöversikt (refereegranskat)abstract
- We report on the final electroweak measurements performed with data taken at the Z resonance by the experiments operating at the electron-positron colliders SLC and LEP. The data consist of 17 million Z decays accumulated by the ALEPH, DELPHI, L3 and OPAL experiments at LEP, and 600 thousand Z decays by the SLID experiment using a polarised beam at SLC. The measurements include cross-sections, forward-backward asymmetries and polarised asymmetries. The mass and width of the Z boson, m(Z) and Gamma(Z), and its couplings to fermions, for example the p parameter and the effective electroweak mixing angle for leptons, are precisely measured: m(Z) = 91.1875 +/- 0.0021 GeV, Gamma(Z) = 2.4952 +/- 0.0023 GeV, rho(l) = 1.0050 +/- 0.0010, sin(2)theta(eff)(lept) = 0.23153 +/- 0.00016. The number of light neutrino species is determined to be 2.9840 +/- 0.0082, in agreement with the three observed generations of fundamental fermions. The results are compared to the predictions of the Standard Model (SM). At the Z-pole, electroweak radiative corrections beyond the running of the QED and QCD coupling constants are observed with a significance of five standard deviations, and in agreement with the Standard Model. Of the many Z-pole measurements, the forward-backward asymmetry in b-quark production shows the largest difference with respect to its SM expectation, at the level of 2.8 standard deviations. Through radiative corrections evaluated in the framework of the Standard Model, the Z-pole data are also used to predict the mass of the top quark, m(t) = 173(+10)(+13) GeV, and the mass of the W boson, m(W) = 80.363 +/- 0.032 GeV. These indirect constraints are compared to the direct measurements, providing a stringent test of the SM. Using in addition the direct measurements of m(t) and m(W), the mass of the as yet unobserved SM Higgs boson is predicted with a relative uncertainty of about 50% and found to be less than 285 GeV at 95% confidence level. (c) 2006 Elsevier B.V. All rights reserved.
|
|
2. |
- Abate, E., et al.
(författare)
-
Combined performance tests before installation of the ATLAS Semiconductor and Transition Radiation Tracking Detectors
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS (A Toroidal LHC ApparatuS) Inner Detector provides charged particle tracking in the centre of the ATLAS experiment at the Large Hadron Collider (LHC). The Inner Detector consists of three subdetectors: the Pixel Detector, the Semiconductor Tracker (SCT), and the Transition Radiation Tracker (TRT). This paper summarizes the tests that were carried out at the final stage of SCT+TRT integration prior to their installation in ATLAS. The combined operation and performance of the SCT and TRT barrel and endcap detectors was investigated through a series of noise tests, and by recording the tracks of cosmic rays. This was a crucial test of hardware and software of the combined tracker detector systems. The results of noise and cross-talk tests on the SCT and TRT in their final assembled configuration, using final readout and supply hardware and software, are reported. The reconstruction and analysis of the recorded cosmic tracks allowed testing of the offline analysis chain and verification of basic tracker performance parameters, such as efficiency and spatial resolution, in combined operation before installation.
|
|
3. |
- Abdesselam, A., et al.
(författare)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
4. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
5. |
- Abdesselam, A., et al.
(författare)
-
The barrel modules of the ATLAS semiconductor tracker
- 2006
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 568:2, s. 642-671
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes the silicon microstrip modules in the barrel section of the SemiConductor Tracker (SCT) of the ATLAS experiment at the CERN Large Hadron Collider (LHC). The module requirements, components and assembly techniques are given, as well as first results of the module performance on the fully assembled barrels that make up the detector being installed in the ATLAS experiment.
|
|
6. |
|
|
7. |
- Palumbo, A., et al.
(författare)
-
Prevention of thalidomide- and lenalidomide-associated thrombosis in myeloma
- 2008
-
Ingår i: Leukemia. - : Springer Science and Business Media LLC. - 1476-5551 .- 0887-6924. ; 22:2, s. 414-423
-
Tidskriftsartikel (refereegranskat)abstract
- The incidence of venous thromboembolism (VTE) is more than 1%omicron annually in the general population and increases further in cancer patients. The risk of VTE is higher in multiple myeloma (MM) patients who receive thalidomide or lenalidomide, especially in combination with dexamethasone or chemotherapy. Various VTE prophylaxis strategies, such as low-molecular-Weight heparin (LMWH), warfarin or aspirin, have been investigated in small, uncontrolled clinical studies. This manuscript summarizes the available evidence and recommends a prophylaxis strategy according to a risk-assessment model. Individual risk factors for thrombosis associated with thalidomide/lenalidomide-based therapy include age, history of VTE, central venous catheter, comorbidities (infections, diabetes, cardiac disease), immobilization, surgery and inherited thrombophilia. Myeloma-related risk factors include diagnosis and hyperviscosity. VTE is very high in patients who receive high-dose dexamethasone, doxorubicin or multiagent chemotherapy in combination with thalidomide or lenalidomide, but not with bortezomib. The panel recommends aspirin for patients with <= 1 risk factor for VTE. LMWH (equivalent to enoxaparin 40 mg per day) is recommended for those with two or more individual/myeloma-related risk factors. LMWH is also recommended for all patients receiving concurrent high-dose dexamethasone or doxorubicin. Full-dose warfarin targeting a therapeutic INR of 2-3 is an alternative to LMWH, although there are limited data in the literature with this strategy. In the absence of clear data from randomized studies as a foundation for recommendations, many of the following proposed strategies are the results of common sense or derive from the extrapolation of data from many studies not specifically designed to answer these questions. Further investigation is needed to define the best VTE prophylaxis.
|
|
8. |
- Giralt, S., et al.
(författare)
-
International myeloma working group (IMWG) consensus statement and guidelines regarding the current status of stem cell collection and high-dose therapy for multiple myeloma and the role of plerixafor (AMD 3100)
- 2009
-
Ingår i: Leukemia. - : Springer Science and Business Media LLC. - 1476-5551 .- 0887-6924. ; 23:10, s. 1904-1912
-
Tidskriftsartikel (refereegranskat)abstract
- Multiple myeloma is the most common indication for high-dose chemotherapy with autologous stem cell support (ASCT) in North America today. Stem cell procurement for ASCT has most commonly been performed with stem cell mobilization using colony-stimulating factors with or without prior chemotherapy. The target CD34+ cell dose to be collected as well as the number of apheresis performed varies throughout the country, but a minimum of 2 million CD34+ cells/kg has been traditionally used for the support of one cycle of high-dose therapy. With the advent of plerixafor (AMD3100) (a novel stem cell mobilization agent), it is pertinent to review the current status of stem cell mobilization for myeloma as well as the role of autologous stem cell transplantation in this disease. On June 1, 2008, a panel of experts was convened by the International Myeloma Foundation to address issues regarding stem cell mobilization and autologous transplantation in myeloma in the context of new therapies. The panel was asked to discuss a variety of issues regarding stem cell collection and transplantation in myeloma especially with the arrival of plerixafor. Herein, is a summary of their deliberations and conclusions. Leukemia (2009) 23, 1904-1912; doi: 10.1038/leu.2009.127; published online 25 June 2009
|
|
9. |
- Palumbo, A., et al.
(författare)
-
International Myeloma Working Group guidelines for the management of multiple myeloma patients ineligible for standard high-dose chemotherapy with autologous stem cell transplantation
- 2009
-
Ingår i: Leukemia. - : Springer Science and Business Media LLC. - 1476-5551 .- 0887-6924. ; 23:10, s. 1716-1730
-
Forskningsöversikt (refereegranskat)abstract
- In 2005, the first guidelines were published on the management of patients with multiple myeloma (MM). An expert panel reviewed the currently available literature as the basis for a set of revised and updated consensus guidelines for the diagnosis and management of patients with MM who are not eligible for autologous stem cell transplantation. Here we present recommendations on the diagnosis, treatment of newly diagnosed non-transplant-eligible patients and the management of complications occurring during induction therapy among these patients. These guidelines will aid the physician in daily clinical practice and will ensure optimal care for patients with MM. Leukemia (2009) 23, 1716-1730; doi: 10.1038/leu.2009.122; published online 4 June 2009
|
|
10. |
|
|