| 1. |
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
-
- 2019
-
Tidskriftsartikel (refereegranskat)
|
|
| 6. |
- Bentham, James, et al.
(författare)
-
A century of trends in adult human height
- 2016
-
Ingår i: eLIFE. - 2050-084X. ; 5
-
Tidskriftsartikel (refereegranskat)abstract
- Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.522.7) and 16.5 cm (13.319.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries.
|
|
| 7. |
- Bentham, James, et al.
(författare)
-
A century of trends in adult human height
- 2016
-
Ingår i: eLIFE. - : eLife Sciences Publications Ltd. - 2050-084X. ; 5
-
Tidskriftsartikel (refereegranskat)abstract
- Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.5–22.7) and 16.5 cm (13.3– 19.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8– 144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries.
|
|
| 8. |
- Jing, Shuping, et al.
(författare)
-
Household Transmission of Human Adenovirus Type 55 in Case of Fatal Acute Respiratory Disease
- 2019
-
Ingår i: Emerging Infectious Diseases. - : Centers for Disease Control and Prevention (CDC). - 1080-6040 .- 1080-6059. ; 25:9, s. 1756-1758
-
Tidskriftsartikel (refereegranskat)abstract
- We identified a case of fatal acute respiratory disease from household transmission of human adenovirus type 55 (HAdV-55) in Anhui Province, China. Computed tomography showed severe pneumonia. Comparative genomic analysis of HAdV-55 indicated the virus possibly originated in Shanxi Province, China. More attention should be paid to highly contagious HAdV-55.
|
|
| 9. |
- Tang, Zheng, et al.
(författare)
-
Relating open-circuit voltage losses to the active layer morphology and contact selectivity in organic solar cells
- 2018
-
Ingår i: Journal of Materials Chemistry A. - : Royal Society of Chemistry (RSC). - 2050-7488 .- 2050-7496. ; 6:26, s. 12574-12581
-
Tidskriftsartikel (refereegranskat)abstract
- We demonstrate that voltage losses due to both radiative and non-radiative recombination of charge carriers are strongly dependent on D/A phase separation. By processing the active layer with various solvent additives, we create distinct morphologies that lead to significantly different device open-circuit voltages (VOC), even though the charge transfer state energy (ECT) of the D/A blend remains rather constant. We find that radiative recombination losses are significantly increased for a finely intermixed morphology, due to the large D/A interface area. This leads to a total recombination loss of ECT - qVOC ≈ 0.7 eV. However, considerably smaller losses (0.5 eV), due to suppressed non-radiative recombination, are possible in solar cells where the D/A materials are organized to only allow for selective charge carrier extraction. Using a drift diffusion model, we show that the origin of the reduced non-radiative recombination losses is related to an effect which has not been considered for 'optimized' solar cells-the suppression of minority carrier diffusion to the 'wrong' contact. Our results suggest that the built-in field is not sufficiently strong even in 'optimized' organic solar cells and that selective carrier extraction is critical for further improvements in VOC.
|
|
| 10. |
- An, Di, et al.
(författare)
-
Additive manufacturing and characterization of complex Al2O3 parts based on a novel stereolithography method
- 2017
-
Ingår i: International Journal of Applied Ceramic Technology. - : Wiley. - 1546-542X .- 1744-7402. ; 14:5, s. 836-844
-
Tidskriftsartikel (refereegranskat)abstract
- In this work, we prepared Al2O3 ceramic green parts with complex geometry and architecture using an additive manufacturing process based on stereolithography. The rheological and thermal behavior of Al2O3 slurry was firstly examined and used to establish the conditions for molding and debinding. As opposed to previous researches that only focused on manufacture techniques, the sintering behavior and densification process were systematically investigated. In addition, special attentions were paid to the evolution of microstructure between green bodies and sintered parts. The results showed that debound parts were equipped with uniform particle packing and narrow pore size distribution. The dimensions of the Al2O3 parts changed anisotropically with the different processing steps. The densification process was greatly accelerated by the decrease in pore size and annihilating of interconnected pores in which significant grain growth was observed above 1450 degrees C. The sintered part also had a homogeneous microstructure and no interface between adjacent layers. High densification (relative density of 99.1%) and much desirable Vickers hardness (17.9 GPa) of Al2O3 parts were achieved at the sintering temperature of 1650 degrees C.
|
|
