| 1. |
- Badelek, B, et al.
(författare)
-
The photon collider at TESLA
- 2004
-
Ingår i: International Journal of Modern Physics A. - 0217-751X. ; 19:30, s. 5097-5186
-
Forskningsöversikt (refereegranskat)abstract
- High energy photon colliders (gammagamma,gammae) are based on e(-)e(-) linear colliders where high energy photons are produced using Compton scattering of laser light on high energy electrons just before the interaction point. This paper is a part of the Technical Design Report of the linear collider TESLA.(1) Physics program, possible parameters and some technical aspects of the photon collider at TESLA are discussed.
|
|
| 2. |
- Laux, M., et al.
(författare)
-
Arcing at B4C-covered limiters exposed to a SOL-plasma
- 2003
-
Ingår i: Journal of Nuclear Materials. - 0022-3115 .- 1873-4820. ; 313, s. 62-66
-
Tidskriftsartikel (refereegranskat)abstract
- Plasma sprayed B4C-layers considered as wall coatings for the W7X stellarator have been studied during and after exposure to TEXTOR and after arcing experiments in vacuum. Arcing through the B4C layer occurred favoured by high power fluxes and not restricted to less stable phases. But this arcing implies an especially noisy scrape-off layer (SOL). Instead of moving retrograde in the external magnetic field, the arc spot on the B4C-layer sticks to the same location for its whole lifetime. Consequently, the arc erodes the entire B4C layer, finally burning down to the Cu substrate. In the neighbourhood of craters the surface contains Cu originating from those craters. This material, hauled to the surface by the arc, is subject to subsequent erosion, transport, and redeposition by the SOL-plasma. The behaviour of arcs on B4C is Most probably caused by the peculiar temperature dependences of the electrical and heat conductivity of B4C.
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
- Huber, A., et al.
(författare)
-
In-situ measurement of trapped hydrogen by laser desorption in TEXTOR-94
- 2001
-
Ingår i: Physica scripta. T. - 0281-1847. ; T94, s. 102-105
-
Tidskriftsartikel (refereegranskat)abstract
- First measurements on laser induced desorption of deuterium incorporated in a boron layer formed by plasma chemical vapor deposition on tungsten and graphite limiter surfaces have been performed. A ruby laser (lambda = 694 nm) with maximum energy of 50 J and a pulse length of about 0.5 ms was used as a heat source. The desorbed deuterium was detected by mass spectroscopy and total pressure analysis in the residual gas. The amount of desorbed deuterium is about 10(17) D atoms cm(-2). The majority of the deuterium is released during the first laser pulse. The limiter heads were investigated post-mortem by means of ion beam analysis to determine the spatial distribution of boron and deuterium and to investigate the effect of the laser pulse on the release of deuterium and sublimation of boron in the laser spot. All the deuterium has been released by the laser pulse. The boron is sublimated partly from the graphite and removed nearly completely from the tungsten surface.
|
|
| 8. |
- Ickenstein, Ludger M., et al.
(författare)
-
Disc formation in cholesterol-free liposomes during phase transition
- 2003
-
Ingår i: Biochimica et Biophysica Acta - Biomembranes. - 0005-2736 .- 1879-2642. ; 1614:2, s. 135-138
-
Tidskriftsartikel (refereegranskat)abstract
- Cryogenic transmission electron microscopy (cryo-TEM) images of lysolipid-containing thermosensitive liposomes (LTSL) revealed that open liposomes and bilayer discs appeared when liposomes were cycled through the gel (Lbeta') to liquid-crystalline (Lalpha) phase transition. The amount of bilayer discs generated was dependent on the combined presence of PEG-lipid and lysolipid in the membrane. We hypothesize that micelle-forming membrane components stabilize the rim of bilayer openings and membrane discs that form when liposomes are cycled through TC.
|
|
| 9. |
|
|
| 10. |
- Mayer, M., et al.
(författare)
-
Hydrogen inventories in nuclear fusion devices
- 2001
-
Ingår i: Journal of Nuclear Materials. - 0022-3115 .- 1873-4820. ; 290, s. 381-388
-
Tidskriftsartikel (refereegranskat)abstract
- Hydrogen retention in tokamaks is due to implantation into plasma-facing materials and trapping in deposited layers. In the limiter tokamak TEXTOR-94 hydrogen-rich deposited layers with thicknesses up to 1 mm are observed on recessed parts of the limiters, areas perpendicular to the magnetic field in the scrape-off layer (SOL), neutralizer plates of the pumped limiter and inside the pumping ducts. In the divertor tokamak JET the main deposition is observed in the divertor, additional deposits are observed in the main chamber on the sides of the guard limiters. Codeposition of carbon ions with hydrogen is the major mechanism of layer growth at areas with direct plasma contact. At remote areas without direct plasma contact, sticking of neutral hydrocarbon radicals seems to play an important role for hydrogen trapping.
|
|
