| 1. |
- Forrest, ARR, et al.
(författare)
-
A promoter-level mammalian expression atlas
- 2014
-
Ingår i: Nature. - : Springer Science and Business Media LLC. - 1476-4687 .- 0028-0836. ; 507:7493, s. 462-
-
Tidskriftsartikel (refereegranskat)
|
|
| 2. |
- Al-Zoubi, Noura, et al.
(författare)
-
Tetragonality of carbon-doped ferromagnetic iron alloys : A first-principles study
- 2012
-
Ingår i: Physical Review B. Condensed Matter and Materials Physics. - 1098-0121 .- 1550-235X. ; 85:1, s. 014112-
-
Tidskriftsartikel (refereegranskat)abstract
- Using density-functional theory in combination with the exact muffin-tin orbital (EMTO) method and coherent potential approximation, we investigate the alloying effect on the tetragonality of Fe-C solid solution forming the basis of steels. In order to assess the accuracy of our approach, first we perform a detailed study of the performance of the EMTO method for the Fe(16)C(1) binary system by comparing the EMTO results to those obtained using the projector augmented wave method. In the second step, we introduce different substitutional alloying elements (Al, Cr, Co, Ni) into the Fe matrix and study their impact on the structural parameters. We demonstrate that a small amount of Al, Co, and Ni enhances the tetragonal lattice ratio of Fe(16)C(1) whereas Cr leaves the ratio almost unchanged. The obtained trends are correlated with the single-crystal elastic parameters calculated for carbon-free alloys.
|
|
| 3. |
- Broqvist, Natalia, et al.
(författare)
-
On wear resistance of tool steel
- 2012
-
Ingår i: Journal of Manufacturing Processes. - : Elsevier BV. - 1526-6125. ; 14:3, s. 195-198
-
Tidskriftsartikel (refereegranskat)abstract
- Maintaining a reasonably low cutting tool wear when producing forming tools is a general challenge in the development of new forming tool materials. The tool life of a hot forming tool steel (H13) has been significantly improved by reducing its Si-content from 1.0 to 0.06 wt.%. However, this modified H13 (MH13) also displays a reduced cutting tool life due to higher cutting forces and a stronger tendency to form built up layers (BUE) on the cutting edge. This paper explains why.Gleeble tests of MH13 revealed a significantly higher flow stress in the 820–900 °C temperature interval in MH13 compared to H13. Thermo-Calc simulations showed that when reducing the Si-content from 1.0 to 0.06 wt.% the initial temperature for ferrite-to-austenite transformation (A1) was reduced from 900 °C to 820 °C. Knowing that austenite has totally different mechanical and thermal properties than ferrite, the difference in A1 between the two steels explains the higher cutting forces and higher tendency for BUE-formation. The conclusion is that the difference in machinability between H13 and MH13 is primarily related to their difference in A1.An attempt was also made to find a new tool material composition that can combine the wear resistance of MH13 and the good machinability of H13. Thermo-Calc simulations were performed with slightly modified alloying content without changing its properties as a good forming tool material, with the aim to increase A1. For instance, reducing the Mn content from 0.5 to 0.05 wt.% proved to increase A1 from 820 to 850 °C.
|
|
| 4. |
|
|
