| 1. |
- Ongena, J., et al.
(författare)
-
Recent progress on JET towards the ITER reference mode of operation at high density
- 2001
-
Ingår i: Plasma Physics and Controlled Fusion. - 0741-3335 .- 1361-6587. ; 43, s. A11-A30
-
Tidskriftsartikel (refereegranskat)abstract
- Recent progress towards obtaining high density and high confinement in JET as required for the ITER reference scenario at Q = 10 is summarized. Plasmas with simultaneous confinement H-98(y.2) = 1 and densities up to n/n(Gw) similar to 1 are now routinely obtained. This has been possible (i) by using plasmas at high (delta similar to 0.5) and medium (delta similar to 0.3-0.4) triangularity with sufficient heating power to maintain Type I ELMs, (ii) with impurity seeded plasmas at high (delta similar to 0.5) and low (delta less than or equal to 0.2) triangularity, (iii) with an optimized pellet injection sequence, maintaining the energy confinement and raising the density, and (iv) by carefully tuning the gas puff rate leading to plasmas with peaked density profiles and good confinement at long time scales. These high performance discharges exhibit Type I ELMs, with a new and more favourable behaviour observed at high densities, requiring further studies. Techniques for a possible mitigation of these ELMs are discussed, and first promising results are obtained with impurity seeding in discharges at high triangularity. Scaling studies using the new data of this year show a strong dependence of confinement on upper triangularity, density and proximity to the Greenwald limit. Observed MHD instabilities and methods to avoid these in high density and high confinement plasmas are discussed.
|
|
| 2. |
- Zastrow, K. D., et al.
(författare)
-
Tritium transport experiments on the JET tokamak
- 2004
-
Ingår i: Plasma Physics and Controlled Fusion. - 0741-3335 .- 1361-6587. ; 46, s. B255-B265
-
Tidskriftsartikel (refereegranskat)abstract
- An overview is given of the experimental method, the analysis technique and the results for trace tritium experiments conducted on the JET tokamak in 2003. Observations associated with events such as sawtooth collapses, neo-classical tearing modes and edge localized modes are described. Tritium transport is seen to approach neo-classical levels in the plasma core at high density and low q(95), and in the transport barrier region of internal transport barrier (ITB) discharges. Tritium transport remains well above neo-classical levels in all other cases. The correlation of the measured tritium diffusion coefficient and convection velocity for normalized minor radii r/a = [0.65, 0.80] with the controllable parameters q95 and plasma density are found to be consistent for all operational regimes (ELMy H-mode discharges with or without ion cyclotron frequency resonance heating, hybrid scenario and ITB discharges). Scaling with local physics parameters is best described by gyro-Bohm scaling with an additional inverse beta dependence.
|
|
| 3. |
- Bilger, R, et al.
(författare)
-
Spectator tagging in quasi-free pn-reactions on deuterium at PROMICE/WASA, CELSIUS
- 2000
-
Ingår i: Nuclear Physics A. - : Elsevier Science B.V. Holland. ; , s. 1053c-1056c
-
Konferensbidrag (refereegranskat)abstract
- A set of silicon detectors has been added to the PROMICE/WASA (P/W) experiment at CELSIUS. These detectors have been used for spectator-proton tagging in proton deuteron collisions to investigate proton-neutron reactions at intermediate energies. The perf
|
|
| 4. |
- Philipps, V., et al.
(författare)
-
Comparison of tokamak behaviour with tungsten and low-Z plasma facing materials
- 2000
-
Ingår i: Plasma Physics and Controlled Fusion. - 0741-3335 .- 1361-6587. ; 42, s. B293-B310
-
Tidskriftsartikel (refereegranskat)abstract
- Graphite wall materials are used in present day fusion devices in order to optimize plasma core performance and to enable access to a large operational space. A large physics database exists for operation with these plasma facing materials, which also indicate their use in future devices with extended burn times. The radiation from carbon impurities in the edge and divertor regions strongly helps to reduce the peak power loads on the strike areas, but carbon radiation also supports the formation of MARFE instabilities which can hinder access to high densities. The main concerns with graphite are associated with its strong chemical affinity to hydrogen, which leads to chemical erosion and to the formation of hydrogen-rich carbon layers. These layers can store a significant fraction of the total tritium fuel, which might prevent the use of these materials in future tritium devices. High-Z plasma facing materials are much more advantageous in this sense, but these advantages compete with the strong poisoning of the plasma if they enter the plasma core. New promising experiences have been obtained with high-Z wall materials in several devices, about which a survey is given in this paper and which also addresses open questions for future research and development work.
|
|
| 5. |
- Valovic, M., et al.
(författare)
-
Density peaking in low collisionality ELMy H-mode in JET
- 2004
-
Ingår i: Plasma Physics and Controlled Fusion. - : IOP Publishing. - 0741-3335 .- 1361-6587. ; 46:12, s. 1877-1889
-
Tidskriftsartikel (refereegranskat)abstract
- Low collisionality, low particle source. ELMy H-modes (type-III) with sawteeth are produced in JET in order to address the question of density profile evolution in the reference q(95) = 3 ITER scenario. The paper focuses on particle transport in the core zone around the mid-radius. The pedestal region including ELMs and the region affected by sawteeth are not considered. By replacing a significant part of the neutral beam heating by RF power the beam particle flux at mid-radius has been reduced to Gamma(Beam)/n(e) = 0.07 m s(-1). The additional flux due to wall neutrals is estimated as Gamma(Wall)/n(e) = 0.12 m s(-1). Density profiles are found to be modestly peaked under these conditions with a relative density difference of Deltan/(n) = 0.23 across the zone not affected by sawteeth and ELMs. In a region around the mid-radius the ratio of effective particle diffusivity to electron thermal diffusivity is found to be D-e,D-eff/chi(e) approximate to 0.2, which might indicate an anomalous pinch provided the particle diffusivity D-e is sufficiently lame. The measured values of D-e,D-eff/chi(e) are at the lower end of the range used in ITER models.
|
|
