| 1. |
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
- Hergott, JF, et al.
(författare)
-
XUV interferometry using high-order harmonics: Application to plasma diagnostics
- 2001
-
Ingår i: Laser and Particle Beams. - 0263-0346. ; 19:1, s. 35-40
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper, we present and compare the two different XUV interferometric techniques using high-order harmonics that have been developed so far. The first scheme is based on the interference between two spatially separated phase-locked harmonic sources while the second uses two temporally separated harmonic sources. These techniques have been applied to plasma diagnostics in feasibility experiments where electron densities up to a few 1020 e[minus sign/cm3 have been measured with a temporal resolution of 200 fs. We present the main characteristics of each technique and discuss their respective potentials and limitations.
|
|
| 5. |
|
|
| 6. |
- Högberg, Hans, et al.
(författare)
-
Deposition of transition metal carbides and superlattices using C-60 as carbon source
- 2000
-
Ingår i: JOURNAL OF THE ELECTROCHEMICAL SOCIETY. - 0013-4651. ; 147:9, s. 3361-3369
-
Tidskriftsartikel (refereegranskat)abstract
- Thin films of TiC, VC, and NbC have been deposited on MgO(001) by coevaporation of the metals and C-60 It was found that these metals induced a decomposition of the C-60 molecule and that carbide films can be formed at a temperature as low as 100 degrees
|
|
| 7. |
- Jansson, U, et al.
(författare)
-
Low temperature epitaxial growth of metal carbides using fullerenes
- 2001
-
Ingår i: Surface & Coatings Technology. - 0257-8972 .- 1879-3347. ; 142-144, s. 817-822
-
Tidskriftsartikel (refereegranskat)abstract
- Epitaxial transition metal carbides can be deposited at low temperatures by simultaneous evaporation of C60 and either metal e-beam evaporation or metal d.c. magnetron sputtering. Hitherto, epitaxial films of TiC, VC, NbC, MoC, W2C and WC have been deposited on MgO(100), MgO(111) and in some cases 6H- and 4H-SiC(0001). Epitaxial TiC films with a good quality have been deposited at temperatures as low as 100°C with metal sputtering, while somewhat higher temperatures (> 200°C) are required for the other metals. In general, the plasma-assisted process allows lower deposition temperatures than the co-evaporation process. Most carbides can be deposited in a wide range of compositions within their homogeneity ranges by a fine-tuning of the Me/C60 flux. However, the results suggest that the formation of free surface carbon can be a limiting factor. The processes have also been used to deposit superlattices of TiC/NbC and TiC/VC at 400-500°C as well as epitaxial ternary Tix V1-xCy films. Furthermore, epitaxial films of ternary carbides with well-controlled metal concentration profiles can be deposited at temperatures below 500°C. © 2001 Elsevier Science B.V. All rights reserved.
|
|
| 8. |
- Merdji, H., et al.
(författare)
-
Coherence properties of high-order harmonics : Application to high-density laser-plasma diagnostic
- 2000
-
Ingår i: Laser and Particle Beams. - 0263-0346. ; 18:3, s. 495-502
-
Tidskriftsartikel (refereegranskat)abstract
- We present two interferometry schemes in the extreme ultraviolet, based on either the wave-front division of a unique harmonic beam (1st scheme) or two spatially separated, phase-locked harmonic sources (2nd scheme). In the first scheme using a Fresnel bimirror interferometer, we measure the degree of spatial coherence of the 13 th harmonic generated in xenon, as a function of different parameters. A high degree of coherence, larger than 0.5, is found for the best conditions in almost the full section of the beam. Then, we demonstrate that the second scheme can be used for interferometry measurements with an ultrahigh time resolution. The 11th harmonic is used to study the spatial variation of the electron density of a laser-produced plasma. Electronic densities higher than 2.10 20 cm -3 are measured.
|
|
| 9. |
|
|
| 10. |
|
|
