| 1. |
|
|
| 2. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
| 3. |
- Abdesselam, A., et al.
(författare)
-
The barrel modules of the ATLAS semiconductor tracker
- 2006
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 568:2, s. 642-671
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes the silicon microstrip modules in the barrel section of the SemiConductor Tracker (SCT) of the ATLAS experiment at the CERN Large Hadron Collider (LHC). The module requirements, components and assembly techniques are given, as well as first results of the module performance on the fully assembled barrels that make up the detector being installed in the ATLAS experiment.
|
|
| 4. |
- Wilson, J. A., et al.
(författare)
-
The optical links of the ATLAS SemiConductor tracker
- 2007
-
Ingår i: Journal of Instrumentation. - 1748-0221 .- 1748-0221. ; 2, s. 1-28
-
Tidskriftsartikel (refereegranskat)abstract
- Optical links are used for the readout of the 4088 silicon microstrip modules that make up the SemiConductor Tracker of the ATLAS experiment at the CERN Large Hadron Collider (LHC). The optical link requirements are reviewed, with particular emphasis on the very demanding environment at the LHC. The on-detector components have to operate in high radiation levels for 10 years, with no maintenance, and there are very strict requirements on power consumption, material and space. A novel concept for the packaging of the on-detector optoelectronics has been developed to meet these requirements. The system architecture, including its redundancy features, is explained and the critical on-detector components are described. The results of the extensive Quality Assurance performed during all steps of the assembly are discussed.
|
|
| 5. |
- Skeie, G., et al.
(författare)
-
Use of dietary supplements in the European Prospective Investigation into Cancer and Nutrition calibration study
- 2009
-
Ingår i: European Journal of Clinical Nutrition. - : Springer Science and Business Media LLC. - 1476-5640 .- 0954-3007. ; 63:4s, s. 226-238
-
Tidskriftsartikel (refereegranskat)abstract
- Background: Dietary supplement use is increasing, but there are few comparable data on supplement intakes and how they affect the nutrition and health of European consumers. The aim of this study was to describe the use of dietary supplements in subsamples of the 10 countries participating in the European Prospective Investigation into Cancer and Nutrition (EPIC). Methods: Specific questions on dietary supplement use were asked as a part of single 24-h recalls performed on 36 034 men and women aged 35-74 years from 1995 to 2000. Results: Between countries, the mean percentage of dietary supplement use varied almost 10-fold among women and even more among men. There was a clear north-south gradient in use, with a higher consumption in northern countries. The lowest crude mean percentage of use was found in Greece (2.0% among men, 6.7% among women), and the highest was in Denmark (51.0% among men, 65.8% among women). Use was higher in women than in men. Vitamins, minerals or combinations of them were the predominant types of supplements reported, but there were striking differences between countries. Conclusions: This study indicates that there are wide variations in supplement use in Europe, which may affect individual and population nutrient intakes. The results underline the need to monitor consumption of dietary supplements in Europe, as well as to evaluate the risks and benefits. European Journal of Clinical Nutrition (2009) 63, S226-S238; doi: 10.1038/ejcn.2009.83
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
- van Bakel, M. M. E., et al.
(författare)
-
Dietary glycaemic index and glycaemic load in the European Prospective Investigation into Cancer and Nutrition
- 2009
-
Ingår i: European Journal of Clinical Nutrition. - : Springer Science and Business Media LLC. - 1476-5640 .- 0954-3007. ; 63:4s, s. 188-205
-
Tidskriftsartikel (refereegranskat)abstract
- Objectives: To describe dietary glycaemic index (GI) and glycaemic load (GL) values in the population participating in the European Prospective Investigation into Cancer and Nutrition (EPIC) study according to food groups, nutrients and lifestyle characteristics. Methods: Single 24-h dietary recalls (24-HDRs) from 33 566 subjects were used to calculate dietary GI and GL, and an ad hoc database was created as the main reference source. Mean GI and GL intakes were adjusted for age, total energy intake, height and weight, and were weighted by season and day of recall. Results: GI was the lowest in Spain and Germany, and highest in the Netherlands, United Kingdom and Denmark for both genders. In men, GL was the lowest in Spain and Germany and highest in Italy, whereas in women, it was the lowest in Spain and Greece and highest in the UK health-conscious cohort. Bread was the largest contributor to GL in all centres (15-45%), but it also showed the largest inter-individual variation. GL, but not GI, tended to be lower in the highest body mass index category in both genders. GI was positively correlated with starch and intakes of bread and potatoes, whereas it was correlated negatively with intakes of sugar, fruit and dairy products. GL was positively correlated with all carbohydrate components and intakes of cereals, whereas it was negatively correlated with fat and alcohol and with intakes of wine, with large variations across countries. Conclusions: GI means varied modestly across countries and genders, whereas GL means varied more, but it may possibly act as a surrogate of carbohydrate intake. European Journal of Clinical Nutrition (2009) 63, S188-S205; doi: 10.1038/ejcn.2009.81
|
|
| 10. |
|
|
