| 1. |
- Lang, J. J. K., et al.
(författare)
-
Tin-stabilized (1 x 2) and (1 x 4) reconstructions on GaAs(100) and InAs(100) studied by scanning tunneling microscopy, photoelectron spectroscopy, and ab initio calculations
- 2011
-
Ingår i: Surface Science. - : Elsevier BV. - 0039-6028 .- 1879-2758. ; 605:9-10, s. 883-888
-
Tidskriftsartikel (refereegranskat)abstract
- Tin (Sn) induced (1 x 2) reconstructions on GaAs(100) and InAs(100) substrates have been studied by low energy electron diffraction (LEED), photoelectron spectroscopy, scanning tunneling microscopy/spectroscopy (STM/STS) and ab initio calculations. The comparison of measured and calculated STM images and surface core-level shifts shows that these surfaces can be well described with the energetically stable building blocks that consist of Sn-III dimers. Furthermore, a new Sn-induced (1 x 4) reconstruction was found. In this reconstruction the occupied dangling bonds are closer to each other than in the more symmetric (1 x 2) reconstruction, and it is shown that the (1 x 4) reconstruction is stabilized as the adatom size increases.
|
|
| 2. |
- Lang, J. J. K., et al.
(författare)
-
Ab initio and scanning tunneling microscopy study of an indium-terminated GaAs(100) surface : An indium-induced surface reconstruction change in the c(8x2) structure
- 2010
-
Ingår i: Physical Review B. Condensed Matter and Materials Physics. - 1098-0121 .- 1550-235X. ; 81:24, s. 245305-
-
Tidskriftsartikel (refereegranskat)abstract
- Technologically useful indium- (In) terminated c(8 x 2)-reconstructed GaAs(100) substrate surface has been studied by first-principles calculations and scanning tunneling microscopy (STM) measurements. Our total-energy calculations demonstrate the stability of four different so-called zeta a structures with In monomer rows and In coverage between 0.5 and 2 monolayers on the GaAs(100) substrate. Thus, we introduce a surface system, which stabilizes the zeta a reconstruction. Furthermore, an interesting trend is found. Atomic structure of the c(8 x 2) reconstruction depends on the surface-layer cation and substrate volumes, which, in principle, allows to tune the surface structure by cation adsorption. This phenomenon is related to the peculiar c(8 x 2) atomic surface structure, which shows mixed surface layer, including both anions and cations, and uncommon metallic-type cations in the zeta a structure, which do not show covalent bonds. Our results predict a structural transition from the zeta structure to the zeta a structure as the surface cation size is increased at 0 K. The found transition is probably related to the disordered surface structures (consisting of zeta and zeta a building blocks) found experimentally by x-ray diffraction at room temperature. Comparison of the STM images, calculated for various c(8 x 2) models, with the former and present measured STM images of In/GaAs(100) c(8 x 2) supports the presence of stable zeta a reconstructions.
|
|
| 3. |
- Laukkanen, P., et al.
(författare)
-
Bismuth-stabilized c(2X6) reconstruction on a InSb(100) substrate : Violation of the electron counting model
- 2010
-
Ingår i: Physical Review B. Condensed Matter and Materials Physics. - 1098-0121 .- 1550-235X .- 2469-9950 .- 2469-9969. ; 81:3
-
Tidskriftsartikel (refereegranskat)abstract
- By means of scanning tunneling microscopy/spectroscopy (STM/STS), photoelectron spectroscopy, and first-principles calculations, we have studied the bismuth (Bi) adsorbate-stabilized InSb(100) substrate surface which shows a c(2X6) low-energy electron diffraction pattern [thus labeled Bi/InSb(100)c(2X6) surface] and which includes areas with metallic STS curves as well as areas with semiconducting STS curves. The first-principles phase diagram of the Bi/InSb(100) surface demonstrates the presence of the Bi-stabilized metallic c(2X6) reconstruction and semiconducting (4X3) reconstruction depending on the chemical potentials, in good agreement with STS results. The existence of the metallic c(2X6) phase, which does not obey the electron counting model, is attributed to the partial prohibition of the relaxation in the direction perpendicular to dimer rows in the competing reconstructions and the peculiar stability of the Bi-stabilized dimer rows. Based on (i) first-principles phase diagram, (ii) STS results, and (iii) comparison of the measured and calculated STM and photoemission data, we show that the measured Bi/InSb(100)c(2X6) surface includes metallic areas with the stable c(2X6) atomic structure and semiconducting areas with the stable (4X3) atomic structure.
|
|
| 4. |
- Laukkanen, P., et al.
(författare)
-
Core-level shifts of the c(8 x 2)-reconstructed InAs(100) and InSb(100) surfaces
- 2010
-
Ingår i: Journal of Electron Spectroscopy and Related Phenomena. - : Elsevier BV. - 0368-2048 .- 1873-2526. ; 177:1, s. 52-57
-
Tidskriftsartikel (refereegranskat)abstract
- We have studied In-stabilized c(8 2)-reconstructed InAs(1 0 0) and InSb(1 0 0) semiconductor surfaces, which play a key role in growing improved III-V interfaces for electronics devices, by core-level photoelectron spectroscopy and first-principles calculations. The calculated surface core-level shifts (SCLSs) for the zeta and zeta a models, which have been previously established to describe the atomic structures of the III-V(1 00)c(8 x 2) surfaces, yield hitherto not reported interpretation for the As 3d, In 4d, and Sb 4d core-level spectra of the III-V(1 00)c(8 x 2) surfaces, concerning the number and origins of SCLSs. The fitting analysis of the measured spectra with the calculated zeta and zeta a SCLS values shows that the InSb spectra are reproduced by the zeta SCLSs better than by the zeta a SCLSs. Interestingly, the zeta a fits agree better with the InAs spectra than the zeta fits do, indicating that the zeta a model describes the InAs surface better than the InSb surface. These results are in agreement with previous X-ray diffraction data. Furthermore, an introduction of the complete-screening model, which includes both the initial and final state effects, does not improve the fitting of the InSb spectra, proposing the suitability of the initial-state model for the SCLSs of the III-V(1 0 0)c(8 x 2) surfaces. The found SCLSs are discussed with the ab initio on-site charges.
|
|
| 5. |
- Laukkanen, P., et al.
(författare)
-
Ultrathin (1x2)-Sn layer on GaAs(100) and InAs(100) substrates : A catalyst for removal of amorphous surface oxides
- 2011
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 98:23, s. 231908-1-231908-3
-
Tidskriftsartikel (refereegranskat)abstract
- Amorphous surface oxides of III-V semiconductors are harmful in many contexts of device development. Using low-energy electron diffraction and photoelectron spectroscopy, we demonstrate that surface oxides formed at Sn-capped GaAs(100) and InAs(100) surfaces in air are effectively removed by heating. This Sn-mediated oxide desorption procedure results in the initial well-defined Sn-stabilized (1x2) surface even for samples exposed to air for a prolonged time. Based on ab initio calculations we propose that the phenomenon is due to indirect and direct effects of Sn. The Sn-induced surface composition weakens oxygen adsorption.
|
|
| 6. |
- Punkkinen, Marko Patrick John, et al.
(författare)
-
Oxidized In-containing III-V(100) surfaces : Formation of crystalline oxide films and semiconductor-oxide interfaces
- 2011
-
Ingår i: Physical Review B. Condensed Matter and Materials Physics. - 1098-0121 .- 1550-235X. ; 83:19, s. 195329-
-
Tidskriftsartikel (refereegranskat)abstract
- Previously found oxidized III-V semiconductor surfaces have been generally structurally disordered and useless for applications. We disclose a family of well-ordered oxidized InAs, InGaAs, InP, and InSb surfaces found by experiments. The found epitaxial oxide-III-V interface is insulating and free of defects related to the harmful Fermi-level pinning, which opens up new possibilities to develop long-sought III-V metal-oxide-semiconductor transistors. Calculations reveal that the early stages in the oxidation process include only O-III bonds due to the geometry of the III-V(100)c(8 x 2) substrate, which is responsible for the formation of the ordered interface. The found surfaces provide a different platform to study the oxidation and properties of oxides, e. g., the origins of the photoemission shifts and electronic structures, using surface science methods.
|
|
| 7. |
- Punkkinen, Marko P. J., et al.
(författare)
-
Structure of ordered oxide on InAs(100) surface
- 2012
-
Ingår i: Surface Science. - : Elsevier BV. - 0039-6028 .- 1879-2758. ; 606:23-24, s. 1837-1841
-
Tidskriftsartikel (refereegranskat)abstract
- It was recently found that oxygen induces ordered reconstructions on several III-V surfaces. The most oxygen-rich reconstruction shows (3x1) periodicity. Based on first-principles investigations, a detailed atomic model is presented for this reconstruction. The uncommon periodicity is attributed to the highly stable In - O - In trilayer below surface which also leads to stabilizing additional bonds within the surface layer. The strain induced by the trilayer is more effectively accommodated within the (3 x 1) reconstruction than within the competing (2 x 1) reconstruction due to smaller number of dimers. It is proposed that the experimentally found semiconductivity is reached by substitutional atoms within the surface layer. Suitable substitution preserves the magnitude of the bulk band gap. (C) 2012 Elsevier B.V. All rights reserved.
|
|
| 8. |
- Puustinen, J., et al.
(författare)
-
1.22 µm GaInNAs saturable absorber mirrors with tailored recovery time
- 2010
-
Ingår i: Emerging trends and novel materials in photonics. - : American Institute of Physics (AIP). - 9780735408432 ; , s. 200-203
-
Konferensbidrag (refereegranskat)abstract
- The effect of in-situ N-ion irradiation on the recombination dynamics of GaInNAs/GaAs semiconductor saturable absorber mirrors has been studied. The samples were fabricated by molecular beam epitaxy using a radio frequency plasma source for nitrogen incorporation in the absorber layers as well as for the irradiation. The recombination dynamics of irradiated samples were studied by pump-probe measurements. The recombination time of the absorbers could be reduced by increasing the irradiation time. The effect of the reduced recombination time on the pulse dynamics of a mode-locked laser setup was studied with a Bi-doped fibre laser. The pulse quality was found to improve with increased irradiation time and reduced recombination time, demonstrating the potential of the in-situ irradiation method for device applications.
|
|
