| 1. |
- Pegourie, B., et al.
(författare)
-
Deuterium inventory in Tore Supra : Coupled carbon-deuterium balance
- 2013
-
Ingår i: Journal of Nuclear Materials. - : Elsevier BV. - 0022-3115 .- 1873-4820. ; 438:Suppl., s. S120-S125
-
Tidskriftsartikel (refereegranskat)abstract
- This paper presents an analysis of the carbon-deuterium circulation and the resulting balance in Tore Supra over the period 2002-2007. Carbon balance combines the estimation of carbon gross erosion from spectroscopy, net erosion and deposition using confocal microscopy, lock-in thermography and SEM, and a measure of the amount of deposits collected in the vacuum chamber. Fuel retention is determined from post-mortem (PM) analyses and gas balance (GB) measurements. Special attention was paid to the deuterium outgassed during the nights and weekends of the experimental campaign (vessel under vacuum, Plasma Facing Components at 120 degrees C) and during vents (vessel at atmospheric pressure, PFCs at room temperature). It is shown that this outgassing is the main process reconciling the PM and GB estimations of fuel retention, closing the coupled carbon-deuterium balance. In particular, it explains why the deuterium concentration in deposits decreases with increasing depth.
|
|
| 2. |
- Malaquias, A., et al.
(författare)
-
Development of ITER relevant laser techniques for deposited layer characterisation and tritium inventory
- 2013
-
Ingår i: Journal of Nuclear Materials. - : Elsevier BV. - 0022-3115 .- 1873-4820. ; 438:Suppl., s. S936-S939
-
Tidskriftsartikel (refereegranskat)abstract
- Laser Induced Breakdown Spectroscopy (LIBS) is a potential candidate to monitor the layer composition and fuel retention during and after plasma shots on specific locations of the main chamber and divertor of ITER. This method is being investigated in a cooperative research programme on plasma devices such as TEXTOR, FTU, MAGNUM-PSI and in other various laboratorial experiments. In this paper LIBS results from targets of D-H-rich carbon films and mixed W-Al-C deposits on bulk tungsten substrates are reported (simulating ITER-like deposits with Al as proxy for Be). Two independent methods, one to determine the relative elemental composition and the other the absolute contents of the target based on the experimental LIBS signals are proposed. The results show that LIBS has the capability to provide the relative concentrations of the elements on the deposited layer when the experimental conditions on the targets surface are identical to the calibration samples.
|
|
| 3. |
- Coad, J. P., et al.
(författare)
-
Surface analysis of tiles and samples exposed to the first JET campaigns with the ITER-like wall
- 2014
-
Ingår i: Physica Scripta. - 0031-8949 .- 1402-4896. ; T159, s. 014012-
-
Tidskriftsartikel (refereegranskat)abstract
- This paper reports on the first post-mortem analyses of tiles removed from JET after the first campaigns with the ITER-like wall (ILW) during 2011-12 [1]. Tiles from the divertor have been analysed by ion beam analysis techniques and by secondary ion mass spectrometry to determine the amount of beryllium deposition and deuterium retention in the tiles exposed to the scrape-off layer. Films 10-20 mu m thick were present at the top of tile 1, but only very thin films (<1 mu m) were found in the shadowed areas and on other divertor tiles. The total amount of Be found in the divertor following the ILW campaign was a factor of similar to 9 less than the material deposited in the 2007-09 carbon campaign, after allowing for the longer operations in 2007-09.
|
|
| 4. |
|
|
| 5. |
- Ohlsson, P. D., et al.
(författare)
-
Acoustophoresis separation of bacteria from blood cells for rapid sepsis diagnostics
- 2013
-
Ingår i: 17th International Conference on Miniaturized Systems for Chemistry and Life Sciences, MicroTAS 2013. - 9781632666246 ; 2, s. 1320-1322
-
Konferensbidrag (refereegranskat)abstract
- We present a significantly improved acoustophoresis method to separate bacteria from red and white blood cells. As much as 98% of the bacteria were recovered, while only 0.06 % of the red and white blood cells remained. This 1600-fold relative enrichment was achieved by adjusting the center medium density, tightly controlling the chip temperature and stabilizing the fluid flows. This is a crucial sample preparation step facilitating downstream bacteria identification for sepsis diagnostics.
|
|
| 6. |
- Petersson, P., et al.
(författare)
-
Wound dehiscence: outcome comparison for sutured and mesh reconstructed patients
- 2014
-
Ingår i: Hernia. - : Springer Science and Business Media LLC. - 1248-9204 .- 1265-4906. ; 18:5, s. 681-689
-
Tidskriftsartikel (refereegranskat)abstract
- Treatment guidelines for abdominal wound dehiscence (WD) are lacking. The primary aim of the study was to compare suture to mesh repair in WD patients concerning incisional hernia incidence. Secondary aims were to compare recurrent WD, morbidity, mortality and long-term abdominal wall complaints. A retrospective chart review of 46 consecutive patients operated for WD between January 2010 and August 2012 was conducted. Physical examination and a questionnaire enquiry were performed in January 2013. Six patients were treated by vacuum-assisted wound closure and mesh-mediated fascial traction (VAWCM) before definitive closure. Three patients died early resulting in 23 patients closed by suture and 20 by mesh repair. Five sutured, but no mesh repair patients had recurrent WD (p = 0.051) with a mortality of 60 %. Finally, 18 sutured and 21 mesh repair patients were eligible for follow-up. The incidence of incisional hernia was higher for the sutured patients (53 vs. 5 %, p = 0.002), while mesh repair patients had a higher short-term morbidity rate (76 vs. 28 %, p = 0.004). Abdominal wall complaints were rare in both groups. Suture of WD was afflicted with a high incidence of recurrent WD and incisional hernia formation. Mesh repair overcomes these problems at the cost of more wound complications. VAWCM seems to be an alternative for treating contaminated patients until definitive closure is possible. Long-term abdominal wall complaints are uncommon after WD treatment.
|
|
| 7. |
|
|
| 8. |
- Philipps, V., et al.
(författare)
-
Development of laser-based techniques for in situ characterization of the first wall in ITER and future fusion devices
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 53:9, s. 093002-
-
Tidskriftsartikel (refereegranskat)abstract
- Analysis and understanding of wall erosion, material transport and fuel retention are among the most important tasks for ITER and future devices, since these questions determine largely the lifetime and availability of the fusion reactor. These data are also of extreme value to improve the understanding and validate the models of the in vessel build-up of the T inventory in ITER and future D-T devices. So far, research in these areas is largely supported by post-mortem analysis of wall tiles. However, access to samples will be very much restricted in the next-generation devices (such as ITER, JT-60SA, W7-X, etc) with actively cooled plasma-facing components (PFC) and increasing duty cycle. This has motivated the development of methods to measure the deposition of material and retention of plasma fuel on the walls of fusion devices in situ, without removal of PFC samples. For this purpose, laser-based methods are the most promising candidates. Their feasibility has been assessed in a cooperative undertaking in various European associations under EFDA coordination. Different laser techniques have been explored both under laboratory and tokamak conditions with the emphasis to develop a conceptual design for a laser-based wall diagnostic which is integrated into an ITER port plug, aiming to characterize in situ relevant parts of the inner wall, the upper region of the inner divertor, part of the dome and the upper X-point region.
|
|
| 9. |
|
|
| 10. |
|
|
