SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Plogmaker Stefan) srt2:(2011)"

Sökning: WFRF:(Plogmaker Stefan) > (2011)

  • Resultat 1-6 av 6
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  • Cappel, Ute B., et al. (författare)
  • Characterization of the Interface Properties and Processes in Solid State Dye-Sensitized Solar Cells Employing a Perylene Sensitizer
  • 2011
  • Ingår i: The Journal of Physical Chemistry C. - : American Chemical Society (ACS). - 1932-7447 .- 1932-7455. ; 115:10, s. 4345-4358
  • Tidskriftsartikel (refereegranskat)abstract
    • We recently reported on a perylene sensitizer, ID176, which performs much better in solid state dye-sensitized solar cells than in those using liquid electrolytes with iodide/tri-iodide as the redox couple (J. Phys. Chem. C2009, 113, 14595-14597). Here, we present a characterization of the sensitizer and of the TiO2/dye interface by UV-visible absorption and fluorescence spectroscopy, spectroelectrochemistry, photoelectron spectroscopy, electroabsorption spectroscopy, photoinduced absorption spectroscopy, and femtosecond transient absorption measurements. We report that the absorption spectrum of the sensitizer is red-shifted by addition of lithium ions to the surface due to a downward shift of the excited state level of the sensitizer, which is of the same order of magnitude as the downward shift of the titanium dioxide conduction band edge. Results from photoelectron spectroscopy and electrochemistry suggest that the excited state is largely located below the conduction band edge of TiO2 but that there are states in the band gap of TiO2 which might be available for photoinduced electron injection. The sensitizer was able to efficiently inject into TiO2, when a lithium salt was present on the surface, while injection was much less effective in the absence of lithium ions or in the presence of solvent. In the presence of the hole conductor 2,2-,7,7-tetrakis-(N,N-di-p-methoxyphenyl-amine)-9,9-spirobifluorene (spiro-MeOTAD) and LiTFSI, charge separation was monitored by the emergence of a Stark shift of the dye in transient absorption spectra, and both injection and regeneration appear to be completed within 1 ps. Regeneration by spiro-MeOTAD is therefore several orders of magnitude faster than regeneration by iodide, and ID176 can even be photoreduced by spiro-MeOTAD.
  •  
2.
  • Cappel, Ute, et al. (författare)
  • Energy Alignment and Surface Dipoles of Rylene Dyes adsorbed to TiO2 nanoparticles
  • 2011
  • Ingår i: Physical Chemistry, Chemical Physics - PCCP. - : Royal Society of Chemistry (RSC). - 1463-9076 .- 1463-9084. ; 13:32, s. 14767-14774
  • Tidskriftsartikel (refereegranskat)abstract
    • The energy loss in dye-sensitized solar cells calculated from the energy difference between the lowest electronic transition of the dye and the obtained open-circuit voltage is often 1 eV or even more. To minimize this loss, it is important to accurately determine the energy alignment at the TiO2/dye/redox-mediator interface. In this study, we compared the results from electrochemistry and photoelectron spectroscopy for determining the energy alignment of three rylene dyes, two of which absorb relatively far in the red. The trends observed with the methods were different, as in the former, the energy alignment is measured relative to an external reference and includes contributions from solvent reorganization energies, while in the latter, it is measured relative to the energetics of the TiO2 and is lacking such contributions. The influence of the dyes' dipole moments on the energetics of the TiO2 was also measured and explained some of the differences in trends. Finally, we compared the injection efficiencies of the two red-absorbing dyes and found that the differences in injection efficiencies can be better explained using the energy alignment determined from photoelectron spectroscopy. This shows that the method for measuring the energetics of a DSC should be chosen according to what process one intends to study.
  •  
3.
  • Eland, John H. D., et al. (författare)
  • Triple ionization of CO(2) by valence and inner shell photoionization
  • 2011
  • Ingår i: Journal of Chemical Physics. - : AIP Publishing. - 0021-9606 .- 1089-7690. ; 135:13, s. 134309-
  • Tidskriftsartikel (refereegranskat)abstract
    • Spectra of triply ionized CO(2) have been obtained from photoionization of the molecule using soft x-ray synchrotron light and an efficient multi-electron coincidence technique. Although all states of the CO(2)(+++) trication are unstable, the ionization energy for formation of molecular ions at a geometry similar to that of the neutral molecule is determined as 74 +/- 0.5 eV.
  •  
4.
  • Fredin, Kristofer, et al. (författare)
  • Solid state dye-sensitized solar cells prepared by infiltrating a molten hole conductor into a mesoporous film at a temperature below 150 degrees C
  • 2011
  • Ingår i: Synthetic metals. - : Elsevier BV. - 0379-6779 .- 1879-3290. ; 161:21-22, s. 2280-2283
  • Tidskriftsartikel (refereegranskat)abstract
    • Infiltration of a molten hole conductor in a mesoporous film at an elevated temperature exhibits good wetting performance and the procedure is therefore suitable as part of the preparation method for solid state dye-sensitized solar cells. Herein, we present a system prepared by infiltrating 4-(diethylamino)benzaldehyde-1,1)-diphenyl-hydrazone in its molten form at a temperature below 150 degrees C. The system displays a maximum photon-to-current conversion efficiency of about 35%, a value corresponding to an increase of about 5 times in comparison with a previously published system prepared by infiltrating a molten hole-conductor at a temperature exceeding 250 degrees C. By means of comparing charge transport and recombination with the results measured for a liquid analogue, we conclude that whereas the transport rates are similar, recombination is significantly more rapid in the solid-state device.
  •  
5.
  • Hahlin, Maria, et al. (författare)
  • Mapping the frontier electronic structures of triphenylamine based organic dyes at TiO2 interfaces
  • 2011
  • Ingår i: Physical Chemistry, Chemical Physics - PCCP. - : Royal Society of Chemistry (RSC). - 1463-9076 .- 1463-9084. ; 13:8, s. 3534-3546
  • Tidskriftsartikel (refereegranskat)abstract
    • The frontier electronic structures of a series of organic dye molecules containing a triphenylamine moiety, a thiophene moiety and a cyanoacrylic acid moiety have been investigated by photoelectron spectroscopy (PES), X-ray absorption spectroscopy (XAS), X-ray emission spectroscopy (XES) and resonant photoelectron spectroscopy (RPES). The experimental results were compared to electronic structure calculations on the molecules, which are used to confirm and enrich the assignment of the spectra. The approach allows us to experimentally measure and interpret the basic valence energy level structure in the dye, including the highest occupied energy level and how it depends on the interaction between the different units. Based on N 1s X-ray absorption and emission spectra we also obtain insight into the structure of the excited states, the molecular orbital composition and dynamics. Together the results provide an experimentally determined energy level map useful in the design of these types of materials. Included are also results indicating femtosecond charge redistribution at the dye/TiO2 interface.
  •  
6.
  • Walle, L. E., et al. (författare)
  • Mixed Dissociative and Molecular Water Adsorption on Anatase TiO2(101)
  • 2011
  • Ingår i: The Journal of Physical Chemistry C. - : American Chemical Society (ACS). - 1932-7447 .- 1932-7455. ; 115:19, s. 9545-9550
  • Tidskriftsartikel (refereegranskat)abstract
    • The adsorption properties of water on the stoichiometric (101) surface of anatase TiO2 in the temperature range 160-400 K has been studied by synchrotron radiation core level photoelectron spectroscopy. O 1s spectra give clear evidence for the formation of a first layer of water that comprises both H2O and OH. The composition is 0.77 +/- 0.05 ML H2O and 0.47 +/- 0.05 ML OH. Decreasing the coverage by heating leads to a decreased H2O/OH ratio. The results are very similar to those recently reported for water on rutile TiO2(110) and show that the previously proposed model of molecular adsorption only on anatase TiO2(101) must be revised.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-6 av 6

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy