| 1. |
- Fan, Qunping, 1989, et al.
(författare)
-
A Non-Conjugated Polymer Acceptor for Efficient and Thermally Stable All-Polymer Solar Cells
- 2020
-
Ingår i: Angewandte Chemie - International Edition. - : Wiley. - 1433-7851 .- 1521-3773. ; 59:45, s. 19835-19840
-
Tidskriftsartikel (refereegranskat)abstract
- A non-conjugated polymer acceptor PF1-TS4 was firstly synthesized by embedding a thioalkyl segment in the mainchain, which shows excellent photophysical properties on par with a fully conjugated polymer, with a low optical band gap of 1.58 eV and a high absorption coefficient >105 cm−1, a high LUMO level of −3.89 eV, and suitable crystallinity. Matched with the polymer donor PM6, the PF1-TS4-based all-PSC achieved a power conversion efficiency (PCE) of 8.63 %, which is ≈45 % higher than that of a device based on the small molecule acceptor counterpart IDIC16. Moreover, the PF1-TS4-based all-PSC has good thermal stability with ≈70 % of its initial PCE retained after being stored at 85 °C for 180 h, while the IDIC16-based device only retained ≈50 % of its initial PCE when stored at 85 °C for only 18 h. Our work provides a new strategy to develop efficient polymer acceptor materials by linkage of conjugated units with non-conjugated thioalkyl segments.
|
|
| 2. |
|
|
| 3. |
- Shangguan, Zhichun, et al.
(författare)
-
A rechargeable molecular solar thermal system below 0 °C
- 2022
-
Ingår i: Chemical Science. - : Royal Society of Chemistry (RSC). - 2041-6539 .- 2041-6520. ; 13:23, s. 6950-6958
-
Tidskriftsartikel (refereegranskat)abstract
- An optimal temperature is crucial for a broad range of applications, from chemical transformations, electronics, and human comfort, to energy production and our whole planet. Photochemical molecular thermal energy storage systems coupled with phase change behavior (MOST-PCMs) offer unique opportunities to capture energy and regulate temperature. Here, we demonstrate how a series of visible-light-responsive azopyrazoles couple MOST and PCMs to provide energy capture and release below 0 degrees C. The system is charged by blue light at -1 degrees C, and discharges energy in the form of heat under green light irradiation. High energy density (0.25 MJ kg(-1)) is realized through co-harvesting visible-light energy and thermal energy from the environment through phase transitions. Coatings on glass with photo-controlled transparency are prepared as a demonstration of thermal regulation. The temperature difference between the coatings and the ice cold surroundings is up to 22.7 degrees C during the discharging process. This study illustrates molecular design principles that pave the way for MOST-PCMs that can store natural sunlight energy and ambient heat over a wide temperature range.
|
|
| 4. |
- Shetty, Naveen, 1988, et al.
(författare)
-
Ultralow 1/f noise in epigraphene devices
- 2024
-
Ingår i: Applied Physics Letters. - 0003-6951 .- 1077-3118. ; 124:9
-
Tidskriftsartikel (refereegranskat)abstract
- We report the lowest recorded levels of 1/ f noise for graphene-based devices, at the level of S V / V 2 = S I / I 2 = 4.4 × 10 − 16 (1/Hz), measured at f = 10 Hz ( S V / V 2 = S I / I 2 < 10 − 16 1/Hz for f > 100 Hz) in large-area epitaxial graphene on silicon carbide (epigraphene) Hall sensors. This performance is made possible through the combination of high material quality, low contact resistance achieved by edge contact fabrication process, homogeneous doping, and stable passivation of the graphene layer. Our study explores the nature of 1/ f noise as a function of carrier density and device geometry and includes data from Hall sensors with device area range spanning over six orders of magnitude, with characteristic device length ranging from L = 1 μm to 1 mm. In optimized graphene Hall sensors, we demonstrate arrays to be a viable route to improve further the magnetic field detection: a simple parallel connection of two devices displays record-high magnetic field sensitivity at room temperature, with minimum detectable magnetic field levels down to B min = 9.5 nT/√Hz. The remarkable low levels of 1/ f noise observed in epigraphene devices hold immense capacity for the design and fabrication of scalable epigraphene-based sensors with exceptional performance.
|
|
| 5. |
- Shetty, Naveen, 1988, et al.
(författare)
-
Ultralow 1/f noise in epigraphene devices
- 2024
-
Ingår i: Applied Physics Letters. - : American Institute of Physics Inc.. - 0003-6951 .- 1077-3118. ; 124:9
-
Tidskriftsartikel (refereegranskat)abstract
- We report the lowest recorded levels of 1/ f noise for graphene-based devices, at the level of S V / V 2 = S I / I 2 = 4.4 × 10 − 16 (1/Hz), measured at f = 10 Hz ( S V / V 2 = S I / I 2 < 10 − 16 1/Hz for f > 100 Hz) in large-area epitaxial graphene on silicon carbide (epigraphene) Hall sensors. This performance is made possible through the combination of high material quality, low contact resistance achieved by edge contact fabrication process, homogeneous doping, and stable passivation of the graphene layer. Our study explores the nature of 1/ f noise as a function of carrier density and device geometry and includes data from Hall sensors with device area range spanning over six orders of magnitude, with characteristic device length ranging from L = 1 μm to 1 mm. In optimized graphene Hall sensors, we demonstrate arrays to be a viable route to improve further the magnetic field detection: a simple parallel connection of two devices displays record-high magnetic field sensitivity at room temperature, with minimum detectable magnetic field levels down to B min = 9.5 nT/√Hz. The remarkable low levels of 1/ f noise observed in epigraphene devices hold immense capacity for the design and fabrication of scalable epigraphene-based sensors with exceptional performance. © 2024 Author(s).
|
|
| 6. |
- Zhang, Zhao Yang, et al.
(författare)
-
Photochemical Phase Transitions Enable Coharvesting of Photon Energy and Ambient Heat for Energetic Molecular Solar Thermal Batteries That Upgrade Thermal Energy
- 2020
-
Ingår i: Journal of the American Chemical Society. - : American Chemical Society (ACS). - 1520-5126 .- 0002-7863. ; 142:28, s. 12256-12264
-
Tidskriftsartikel (refereegranskat)abstract
- Discovering physicochemical principles for simultaneous harvesting of multiform energy from the environment will advance current sustainable energy technologies. Here we explore photochemical phase transitions - a photochemistry-thermophysics coupled regime - for coharvesting of solar and thermal energy. In particular, we show that photon energy and ambient heat can be stored together and released on demand as high-temperature heat, enabled by room-temperature photochemical crystal↔liquid transitions of engineered molecular photoswitches. Integrating the two forms of energy in single-component molecular materials is capable of providing energy capacity beyond that of traditional solar or thermal energy storage systems based solely on molecular photoisomerization or phase change, respectively. Significantly, the ambient heat that is harvested during photochemical melting into liquid of the low-melting-point, metastable isomer can be released as high-temperature heat by recrystallization of the high-melting-point, parent isomer. This reveals that photon energy drives the upgrading of thermal energy in such a hybrid energy system. Rationally designed small-molecule azo switches achieve high gravimetric energy densities of 0.3-0.4 MJ/kg with long-term storage stability. Rechargeable solar thermal battery devices are fabricated, which upon light triggering provide gravimetric power density of about 2.7 kW/kg and temperature increases of >20 °C in ambient environment. We further show their use as deicing coatings. Our work demonstrates a new concept of energy utilization - combining solar energy and low-grade heat into higher-grade heat - which unlocks the possibility of developing sustainable energy systems powered by a combination of natural sunlight and ambient heat.
|
|
