| 1. |
- Abazov, V. M., et al.
(författare)
-
The upgraded DO detector
- 2006
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 565:2, s. 463-537
-
Tidskriftsartikel (refereegranskat)abstract
- The DO experiment enjoyed a very successful data-collection run at the Fermilab Tevatron collider between 1992 and 1996. Since then, the detector has been upgraded to take advantage of improvements to the Tevatron and to enhance its physics capabilities. We describe the new elements of the detector, including the silicon microstrip tracker, central fiber tracker, solenoidal magnet, preshower detectors, forward muon detector, and forward proton detector. The uranium/liquid -argon calorimeters and central muon detector, remaining from Run 1, are discussed briefly. We also present the associated electronics, triggering, and data acquisition systems, along with the design and implementation of software specific to DO.
|
|
| 2. |
- Fairweather-Tait, S, et al.
(författare)
-
The usefulness of in vitro models to predict the bioavailability of iron and zinc: A consensus statement from the HarvestPlus Expert Consultation
- 2005
-
Ingår i: International Journal for Vitamin and Nutrition Research. - : Hogrefe Publishing Group. - 0300-9831 .- 1664-2821. ; 75:6, s. 371-374
-
Tidskriftsartikel (refereegranskat)abstract
- A combination of dietary and host-related factors determines iron and zinc absorption, and several in vitro methods have been developed as preliminary screening tools for assessing bioavailability. An expert committee has reviewed evidence for their usefulness and reached a consensus. Dialyzability (with and without simulated digestion) gives some useful information but cannot predict the correct magnitude of response and may sometimes predict the wrong direction of response. Caco-2 cell systems (with and without simulated digestion) have been developed for iron availability, but the magnitude of different effects does not always agree with results obtained in human volunteers, and the data for zinc are too limited to draw conclusions about the validity of the method. Caco-2 methodologies vary significantly between laboratories and require experienced technicians and good quality cell culture facilities to obtain reproducible results. Algorithms can provide semi-quantitative information enabling diets to be classified as high, moderate, or low bioavailability. While in vitro methods can be used to generate ideas and develop hypotheses, they cannot be used alone for important decisions concerning; food fortification policy, selection of varieties for plant breeding programs, or for new product development in the food industry. Ultimately human studies are required for such determinations.
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
- Petrache, C. M., et al.
(författare)
-
Triaxiality at high spins in Nd nuclei
- 2006
-
Ingår i: Physica Scripta. - 0031-8949. ; T125, s. 212-213
-
Tidskriftsartikel (refereegranskat)abstract
- The level structure of Nd-140(80) has been established up to spin 48 by in-beam gamma-ray spectroscopy using the Zr-96(Ca-48, 4n) reaction. High-fold gamma-ray coincidences were measured with the EUROBALL spectrometer. Twelve new rotational bands have been discovered at high spins, showing the change from a spherical single-particle behaviour at low spins to a deformed regime with stable triaxiality at high spins. Possible configurations are assigned to the observed bands on the basis of configuration-dependent cranked Nilsson-Strutinsky calculations.
|
|
| 6. |
|
|
| 7. |
- Bhatt, Pramod, et al.
(författare)
-
High temperature annealing effect on structural and magnetic properties of Ti/Ni multilayer
- 2006
-
Ingår i: Applied Surface Science. - : Elsevier BV. - 0169-4332. ; 253:5, s. 2572-2580
-
Tidskriftsartikel (refereegranskat)abstract
- High temperature annealing effect on structural and magnetic properties of Ti/Ni multilayer (ML) up to 600 °C have been studied and reported in this paper. Ti/Ni multilayer samples having constant layer thicknesses of 50 Å each are deposited on float glass and Si(1 1 1) substrates using electron-beam evaporation technique under ultra-high vacuum (UHV) conditions at room temperatures. The micro-structural parameters and their evolution with temperature for as-deposited as well as annealed multilayer samples up to 600 °C in a step of 100 °C for 1 h are determined by using X-ray diffraction (XRD) and grazing incidence X-ray reflectivity techniques. The X-ray diffraction pattern recorded at 300 °C annealed multilayer sample shows interesting structural transformation (from crystalline to amorphous) because of the solid-state reaction (SSR) and subsequent re-crystallization at higher temperatures of annealing, particularly at ≥400 °C due to the formation of TiNi3 and Ti2Ni alloy phases. Sample quality and surface morphology are examined by using atomic force microscopy (AFM) technique for both as-deposited as well as annealed multilayer samples. In addition to this, a temperature dependent dc resistivity measurement is also used to study the structural transformation and subsequent alloy phase formation due to annealing treatment. The corresponding magnetization behavior of multilayer samples after each stage of annealing has been investigated by using Magneto-Optical Kerr Effect (MOKE) technique and results are interpreted in terms of observed micro-structural changes.
|
|
