| 1. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 2. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 3. |
- Giaccari, U., et al.
(författare)
-
Anisotropy studies in the cosmic ray proton flux with the PAMELA experiment
- 2013
-
Ingår i: Proceedings of the 9th workshop on Science with the New Generation of High Energy Gamma-ray Experiments: From high energy gamma sources to cosmic rays, one century after their discovery. - : Elsevier. ; , s. 123-128
-
Konferensbidrag (refereegranskat)abstract
- Using data taken by the Pamela experiment during 5 years of operation we studied the anisotropy in the arrival direction distribution of cosmic ray protons with rigidity above 40 GV. In this survey we used two different and independent techniques to investigate the large and medium anisotropy patterns in the proton spectrum. With both methods the observed distribution of arrival directions is consistent with the isotropic expectation and no significant evidence of strong anisotropies has been observed.
|
|
| 4. |
- Adriani, O., et al.
(författare)
-
The PAMELA Mission : Heralding a new era in precision cosmic ray physics
- 2014
-
Ingår i: Physics reports. - : Elsevier BV. - 0370-1573 .- 1873-6270. ; 544:4, s. 323-370
-
Forskningsöversikt (refereegranskat)abstract
- On the 15th of June 2006, the PAMELA (Payload for Antimatter Matter Exploration and Light-nuclei Astrophysics) satellite-borne experiment was launched onboard the Russian Resurs-DK1 satellite by a Soyuz rocket from the Baikonur space centre. The satellite was placed in a quasi-polar 70 degrees inclination orbit at an altitude varying between 350 km and 600 km. New results on the antiparticle component of the cosmic radiation were obtained. The positron energy spectrum and positron fraction were measured from 400 MeV up to 200 GeV revealing a positron excess over the predictions of commonly used propagation models. This can be interpreted either as evidence that the propagation models should be revised or in terms of dark matter annihilation or a pulsar contribution. The antiproton spectrum was measured over the energy range from 60 MeV to 350 GeV. The antiproton spectrum is consistent with secondary production and significantly constrains dark matter models. The energy spectra of protons and helium nuclei were measured up to 1.2 TV. The spectral shapes of these two species are different and cannot be described well by a single power law. For the First time the electron spectrum was measured up to 600 GeV complementing the information obtained from the positron data. Nuclear and isotopic composition was obtained with unprecedented precision. The variation of the low energy proton, electron and positron energy spectra was measured from July 2006 until December 2009 accurately sampling the unusual conditions of the most recent solar minimum activity period (2006-2009). Low energy particle spectra were accurately measured also for various solar events that occurred during the PAMELA mission. The Earth's magnetosphere was studied measuring the particle radiation in different regions of the magnetosphere. Energy spectra and composition of sub-cutoff and trapped particles were obtained. For the first time a belt of trapped antiprotons was detected in the South Atlantic Anomaly region. The flux was found to exceed that for galactic cosmic-ray antiprotons by three order of magnitude.
|
|
| 5. |
- Papp, Gergely, 1985, et al.
(författare)
-
The effect of the ITER-like wall on runaway electron generation in JET
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 53:12
-
Tidskriftsartikel (refereegranskat)abstract
- This paper investigates the effect of the ITER-like wall (ILW) on runaway electron (RE) generation through a comparative study of similar slow argon injection JET disruptions, performed with different wall materials. In the carbon wall case, a RE plateau is observed, while in the ITER-like wall case, the current quench is slower and the runaway current is negligibly small. The aim of the paper is to shed light on the reason for these differences by detailed numerical modelling to study which factors affected the RE formation. The post-disruption current profile is calculated by a one-dimensional model of electric field, temperature and runaway current taking into account the impurity injection. Scans of various impurity contents are performed and agreement with the experimental scenarios is obtained for reasonable argon and wall impurity contents. Our modelling shows that the reason for the changed RE dynamics is a complex, combined effect of the differences in plasma parameter profiles, the radiation characteristics of beryllium and carbon, and the difference of the injected argon amount. These together lead to a significantly higher Dreicer generation rate in the carbon wall case, which is less prone to being suppressed by RE loss mechanisms. The results indicate that the differences are greatly reduced above ~50% argon content, suggesting that significant RE current is expected in future massive gas injection experiments on both JET and ITER.
|
|
| 6. |
|
|
| 7. |
- Thomser, C., et al.
(författare)
-
Plasma facing materials for the jet iter-like wall
- 2012
-
Ingår i: Fusion science and technology. - 1536-1055 .- 1943-7641. ; 62:1, s. 1-8
-
Tidskriftsartikel (refereegranskat)abstract
- The chosen materials for plasma facing components for the deuterium/tritium phase of ITER are beryllium and tungsten. These materials have already been widely investigated in various devices like ion beam or electron beam tests. However, the operation of this material combination in a large tokamak including plasma wall interaction, material degradation, erosion and material mixing has not been proven yet. The ITER-like Wall, which has been recently installed in JET, consists of a combination of bulk tungsten and tungsten coated CFC divertor tiles as well as bulk beryllium and beryllium coated INCONEL in the main chamber. The experiments in JET will provide the first fully representative test of the ITER material choice under relevant conditions. This paper concentrates on material research and developments for the materials of the JET ITER-like Wall with respect to mechanical and thermal properties. The impact of these materials and components on the JET operating limits with the ITER-like Wall and implications for the ongoing scientific program will be summarised.
|
|
| 8. |
- Andersson, P., et al.
(författare)
-
An upgrade of the SCANDAL setup for measurements of elastic neutron scattering at 175 MeV
- 2010
-
Ingår i: RADIATION MEASUREMENTS. - : Elsevier BV. ; 45:10, s. 1142-1144
-
Konferensbidrag (refereegranskat)abstract
- The experimental setup SCANDAL used for measurements of the differential cross section for elastic and inelastic neutron scattering, has recently been upgraded with larger CsI scintillating detectors to enable measurements at energies up to 175 MeV. Measurements on Fe. Bi and Si have been carried out using the quasi mono-energetic neutron beam at the The Svedberg Laboratory, and data is under analysis. The experimental setup can be used for measurements on a wide range of target nuclei, including C and O, which are important for dosimetry applications. SCANDAL can also run in proton mode, for measurements of the (n,p) reaction. This paper describes the new experimental setup, and reports on its properties, such as energy resolution.
|
|
| 9. |
- Bevilacqua, Riccardo, et al.
(författare)
-
Light-Ion Production in the Interaction of 175 MeV Neutrons with Iron and Bismuth
- 2011
-
Ingår i: Journal of the Korean Physical Society. - : Korean Physical Society. - 0374-4884 .- 1976-8524. ; 59:2, s. 1701-1704
-
Tidskriftsartikel (refereegranskat)abstract
- We have measured double-differential (angle and energy) cross sections for light-ion (p, d, t, (3)He, and a) production in the interaction of quasi-monoenergetic 175 MeV neutrons with iron and bismuth. Measurements have been performed at the The Svedberg Laboratory, Uppsala (Sweden), using the Medley setup which allows low-energy thresholds and wide energy and angular ranges. Medley is a spectrometer system consisting of eight three-element telescopes placed at angles from 20 degrees to 160 degrees, in steps of 20 degrees. Each telescope is composed of two silicon surface barrier detectors and a CsI(Tl) scintillator, to perform particle identification, fully stop the produced light-ions and measure their kinetic energy. The time-of-flight was used to reduce the contribution from the low energy tail in the accepted incident neutron spectrum. We report double-differential production cross sections for protons, deuterons, tritons, (3)He and alpha particles and compare them with model calculations with TALYS-1.2.
|
|
| 10. |
- Bevilacqua, Riccardo, et al.
(författare)
-
Neutron induced light-ion production from iron and bismuth at 175 MeV
- 2010
-
Ingår i: RADIATION MEASUREMENTS. - : Elsevier BV. ; 45:10, s. 1145-1150
-
Konferensbidrag (refereegranskat)abstract
- We have measured light-ion (p, d, t, He-3 and alpha) production in the interaction of 175 MeV neutrons with iron and bismuth with low-energy thresholds and for a wide angular range (from 20 degrees to 160 degrees, in steps of 20 degrees). Measurements have been performed with the Medley setup, semi-permanently installed at the The Svedberg Laboratory, Uppsala (Sweden), where a quasi-monoenergetic neutron beam is available and well characterized. Medley is a conventional spectrometer system and consists of eight telescopes, each of them composed of two silicon surface barrier detectors, to perform particle identification, and a CsI(Tl) scintillator to fully measure the kinetic energy of the produced light-ions. We report preliminary double-differential cross sections for production of protons, deuterons and tritons in comparison with model calculations using TALYS-1.0 code. These show better agreement for the production of protons, while the theoretical calculations seem to overestimate the experimental production of deuterons and tritons.
|
|
