| 1. |
- Schael, S, et al.
(författare)
-
Precision electroweak measurements on the Z resonance
- 2006
-
Ingår i: Physics Reports. - : Elsevier BV. - 0370-1573 .- 1873-6270. ; 427:5-6, s. 257-454
-
Forskningsöversikt (refereegranskat)abstract
- We report on the final electroweak measurements performed with data taken at the Z resonance by the experiments operating at the electron-positron colliders SLC and LEP. The data consist of 17 million Z decays accumulated by the ALEPH, DELPHI, L3 and OPAL experiments at LEP, and 600 thousand Z decays by the SLID experiment using a polarised beam at SLC. The measurements include cross-sections, forward-backward asymmetries and polarised asymmetries. The mass and width of the Z boson, m(Z) and Gamma(Z), and its couplings to fermions, for example the p parameter and the effective electroweak mixing angle for leptons, are precisely measured: m(Z) = 91.1875 +/- 0.0021 GeV, Gamma(Z) = 2.4952 +/- 0.0023 GeV, rho(l) = 1.0050 +/- 0.0010, sin(2)theta(eff)(lept) = 0.23153 +/- 0.00016. The number of light neutrino species is determined to be 2.9840 +/- 0.0082, in agreement with the three observed generations of fundamental fermions. The results are compared to the predictions of the Standard Model (SM). At the Z-pole, electroweak radiative corrections beyond the running of the QED and QCD coupling constants are observed with a significance of five standard deviations, and in agreement with the Standard Model. Of the many Z-pole measurements, the forward-backward asymmetry in b-quark production shows the largest difference with respect to its SM expectation, at the level of 2.8 standard deviations. Through radiative corrections evaluated in the framework of the Standard Model, the Z-pole data are also used to predict the mass of the top quark, m(t) = 173(+10)(+13) GeV, and the mass of the W boson, m(W) = 80.363 +/- 0.032 GeV. These indirect constraints are compared to the direct measurements, providing a stringent test of the SM. Using in addition the direct measurements of m(t) and m(W), the mass of the as yet unobserved SM Higgs boson is predicted with a relative uncertainty of about 50% and found to be less than 285 GeV at 95% confidence level. (c) 2006 Elsevier B.V. All rights reserved.
|
|
| 2. |
- Abdesselam, A., et al.
(författare)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
| 3. |
- Abate, E., et al.
(författare)
-
Combined performance tests before installation of the ATLAS Semiconductor and Transition Radiation Tracking Detectors
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS (A Toroidal LHC ApparatuS) Inner Detector provides charged particle tracking in the centre of the ATLAS experiment at the Large Hadron Collider (LHC). The Inner Detector consists of three subdetectors: the Pixel Detector, the Semiconductor Tracker (SCT), and the Transition Radiation Tracker (TRT). This paper summarizes the tests that were carried out at the final stage of SCT+TRT integration prior to their installation in ATLAS. The combined operation and performance of the SCT and TRT barrel and endcap detectors was investigated through a series of noise tests, and by recording the tracks of cosmic rays. This was a crucial test of hardware and software of the combined tracker detector systems. The results of noise and cross-talk tests on the SCT and TRT in their final assembled configuration, using final readout and supply hardware and software, are reported. The reconstruction and analysis of the recorded cosmic tracks allowed testing of the offline analysis chain and verification of basic tracker performance parameters, such as efficiency and spatial resolution, in combined operation before installation.
|
|
| 4. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
| 5. |
- Abdesselam, A., et al.
(författare)
-
The barrel modules of the ATLAS semiconductor tracker
- 2006
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 568:2, s. 642-671
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes the silicon microstrip modules in the barrel section of the SemiConductor Tracker (SCT) of the ATLAS experiment at the CERN Large Hadron Collider (LHC). The module requirements, components and assembly techniques are given, as well as first results of the module performance on the fully assembled barrels that make up the detector being installed in the ATLAS experiment.
|
|
| 6. |
|
|
| 7. |
- James, P., et al.
(författare)
-
Towards an integrated understanding of green space in the European built environment
- 2009
-
Ingår i: Urban Forestry & Urban Greening. - : Elsevier BV. - 1618-8667 .- 1610-8167. ; 8:2, s. 65-75
-
Tidskriftsartikel (refereegranskat)abstract
- In recent years social, economic and environmental considerations have led to a reevaluation of the factors that contribute to sustainable urban environments. Increasingly, urban green space is seen as an integral part of cities providing a range of services to both the people and the wildlife living in urban areas. With this recognition and resulting from the simultaneous provision of different services, there is a real need to identify a research framework in which to develop multidisciplinary and interdisciplinary research on urban green space. In order to address these needs, an iterative process based on the delphi technique was developed, which comprised email-mediated discussions and a two-day symposium involving experts from various disciplines. The two outputs of this iterative process were (i) an integrated framework for multidisciplinary and interdisciplinary research and (ii) a catalogue of key research questions in urban green space research. The integrated framework presented here includes relevant research areas (i.e. ecosystem services, drivers of change, pressures on urban green space, human processes and goals of provision of urban green space) and emergent research themes in urban green space studies (i.e. physicality, experience, valuation, management and governance). Collectively these two outputs have the potential to establish an international research agenda for urban green space, which can contribute to the better understanding of people's relationship with cities.
|
|
| 8. |
- Abdesselam, A., et al.
(författare)
-
The detector control system of the ATLAS SemiConductor Tracker during macro-assembly and integration
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3, s. P02007-
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is one of the largest existing semiconductor detectors. It is situated between the Pixel detector and the Transition Radiation Tracker at one of the four interaction points of the Large Hadron Collider (LHC). During 2006-2007 the detector was lowered into the ATLAS cavern and installed in its final position. For the assembly, integration and commissioning phase, a complete Detector Control System (DCS) was developed to ensure the safe operation of the tracker. This included control of the individual powering of the silicon modules, a bi-phase cooling system and various types of sensors monitoring the SCT environment and the surrounding test enclosure. The DCS software architecture, performance and operational experience will be presented in the view of a validation of the DCS for the final SCT installation and operation phase.
|
|
| 9. |
- Tree, Jai J, et al.
(författare)
-
Characterization of the effects of salicylidene acylhydrazide compounds on type III secretion in Escherichia coli O157 : H7
- 2009
-
Ingår i: Infection and immunity. - 1098-5522. ; 77:10, s. 4209-20
-
Tidskriftsartikel (refereegranskat)abstract
- Recent work has highlighted a number of compounds that target bacterial virulence by affecting gene regulation. In this work, we show that small-molecule inhibitors affect the expression of the type III secretion system (T3SS) of Escherichia coli O157:H7 in liquid culture and when this bacterium is attached to bovine epithelial cells. Inhibition of T3SS expression resulted in a reduction in the capacity of the bacteria to form attaching and effacing lesions. Our results show that there is marked variation in the abilities of four structurally related compounds to inhibit the T3SS of a panel of isolates. Using transcriptomics, we performed a comprehensive analysis of the conserved and inhibitor-specific transcriptional responses to these four compounds. These analyses of gene expression show that numerous virulence genes, located on horizontally acquired DNA elements, are affected by the compounds, but the number of genes significantly affected varied markedly for the different compounds. Overall, we highlight the importance of assessing the effect of such "antivirulence" agents on a range of isolates and discuss the possible mechanisms which may lead to the coordinate downregulation of horizontally acquired virulence genes.
|
|
| 10. |
- Rebeiz, A. G., et al.
(författare)
-
Comparison of ST-segment resolution with combined fibrinolytic and glycoprotein IIb/IIIa inhibitor therapy versus fibrinolytic alone (data from four clinical trials)
- 2005
-
Ingår i: Am J Cardiol. - 0002-9149. ; 95:5, s. 611-4
-
Tidskriftsartikel (refereegranskat)abstract
- We compared combination fibrinolytic plus glycoprotein IIb/IIIa inhibitor therapy with stand-alone fibrinolysis with respect to speed and stability of reperfusion in patients who had acute ST-segment elevation myocardial infarction; data were obtained from 654 patients in 4 trials (Integrilin to Manage Platelet Aggregation to Combat Thrombosis in Acute Myocardial Infarction, Platelet Aggregation Receptor Antagonist Dose Investigation and Reperfusion Gain in Myocardial Infarction, Integrilin and Tenecteplase in Acute Myocardial Infarction, and the Fifth Global Use of Strategies to Open Occluded Coronary Arteries) that compared thrombolytics plus lamifiban, eptifibatide, or abciximab with standard thrombolysis. We found significantly faster and more stable ST-segment recovery with combination therapy starting at 60 minutes (56.7% vs 48.0% with >/=50% ST-segment resolution, p = 0.03) and sustained over 180 minutes after drug administration; this transient benefit may suggest a time frame when more optimal percutaneous coronary intervention can be performed.
|
|
