| 1. |
- Abdesselam, A., et al.
(författare)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
| 2. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
| 3. |
- Casado, M. P., et al.
(författare)
-
The ATLAS tau trigger
- 2009
-
Ingår i: Nuclear physics B, Proceedings supplements. - : Elsevier BV. - 0920-5632 .- 1873-3832. ; 189, s. 291-298
-
Tidskriftsartikel (refereegranskat)abstract
- The implementation of a trigger for hadronically decaying tau leptons at the Large Hadronic Collider (LHC) is challenging due to the high background rate, on the other hand it increases tremendously the discovery potential of ATLAS in searches for Standard Model (SM) or Supersymmetric (SUSY) Higgs or other more exotic final states. In this paper we describe the ATLAS tau trigger system, focusing on the early data taking period, and present results from studies based oil GEANT 4 simulated events, including trigger rates and the acceptance of tau leptons from SM processes. In order to cope with the rate and optimize the efficiency of important physics channels, the results of the current simulation studies indicate that ATLAS tau triggers should include either relatively high transverse momentum single tau signatures, or low transverse momentum tau signatures in combination with other signatures, such as missing transverse energy, leptons, or jets.
|
|
| 4. |
- Brenner, Richard, et al.
(författare)
-
The ATLAS tau trigger and planned trigger efficiency studies with early data
- 2009
-
Ingår i: Proceedings of CHarged2008. - Trieste : Proceedings of Science. ; , s. 1-7
-
Konferensbidrag (refereegranskat)abstract
- The tau trigger system of the ATLAS detector has been developed to increase the sensitivity ofthe detector to the Higgs boson and searches for physics beyond the Standard Model. A trigger system split in three levels has been designed for hadronically decaying tau leptons optimized for efficiency and good background rejection. At the first level the trigger uses only information from the calorimeters while the other two levels include also information from the tracking. Both energy and shape variables for the hadronic tau jets are used in the trigger algorithms. The very intense QCD background, however, makes it a challenge to develop an efficient trigger with high purity at low transverse momentum. Thus the tau trigger is best used in combination with other trigger variables such as missing transverse energy or jets. Before the tau trigger can be used in searches, it has to be commissioned with data and the efficiency and background rejectionof QCD has to be studied in detail.
|
|
| 5. |
- Ma, Li-Jun, et al.
(författare)
-
Genomic analysis of the basal lineage fungus Rhizopus oryzae reveals a whole-genome duplication.
- 2009
-
Ingår i: PLoS genetics. - : Public Library of Science (PLoS). - 1553-7404. ; 5:7, s. e1000549-
-
Tidskriftsartikel (refereegranskat)abstract
- Rhizopus oryzae is the primary cause of mucormycosis, an emerging, life-threatening infection characterized by rapid angioinvasive growth with an overall mortality rate that exceeds 50%. As a representative of the paraphyletic basal group of the fungal kingdom called "zygomycetes," R. oryzae is also used as a model to study fungal evolution. Here we report the genome sequence of R. oryzae strain 99-880, isolated from a fatal case of mucormycosis. The highly repetitive 45.3 Mb genome assembly contains abundant transposable elements (TEs), comprising approximately 20% of the genome. We predicted 13,895 protein-coding genes not overlapping TEs, many of which are paralogous gene pairs. The order and genomic arrangement of the duplicated gene pairs and their common phylogenetic origin provide evidence for an ancestral whole-genome duplication (WGD) event. The WGD resulted in the duplication of nearly all subunits of the protein complexes associated with respiratory electron transport chains, the V-ATPase, and the ubiquitin-proteasome systems. The WGD, together with recent gene duplications, resulted in the expansion of multiple gene families related to cell growth and signal transduction, as well as secreted aspartic protease and subtilase protein families, which are known fungal virulence factors. The duplication of the ergosterol biosynthetic pathway, especially the major azole target, lanosterol 14alpha-demethylase (ERG11), could contribute to the variable responses of R. oryzae to different azole drugs, including voriconazole and posaconazole. Expanded families of cell-wall synthesis enzymes, essential for fungal cell integrity but absent in mammalian hosts, reveal potential targets for novel and R. oryzae-specific diagnostic and therapeutic treatments.
|
|
