| 1. |
- Ahola-Tuomi, M., et al.
(författare)
-
Properties of self-assembled Bi nanolines on InAs(100) studied by core-level and valence-band photoemission, and first-principles calculations
- 2011
-
Ingår i: Physical Review B. Condensed Matter and Materials Physics. - 1098-0121 .- 1550-235X. ; 83:24, s. 245401-
-
Tidskriftsartikel (refereegranskat)abstract
- We have studied self-assembled bismuth (Bi) nanolines on the Bi-terminated InAs(100) surface by core-level and valence-band photoelectron spectroscopy, and ab initio first-principles calculations. A structural model for this intriguing surface is suggested based on the comparison of the measured and calculated core-level shifts. Also, the atomic origins for the core-level shifts are proposed based on the calculations. A clear peak related to this surface was observed in the valence band 0.34 eV below the Fermi level, which can be used as a "fingerprint" of a well-ordered Bi/InAs(100) nanoline surface.
|
|
| 2. |
- Ataman, Evren, et al.
(författare)
-
Adsorption of L-cysteine on rutile TiO2(110)
- 2011
-
Ingår i: Surface Science. - : Elsevier BV. - 0039-6028. ; 605:1-2, s. 179-186
-
Tidskriftsartikel (refereegranskat)abstract
- We have used X-ray photoelectron spectroscopy to study the adsorption of L-cysteine on a rutile TiO2(110) surface at room temperature and -65 degrees C. For the molecules in direct contact with the surface our results suggest that the molecules bind dissociatively to the fivefold-coordinated Ti atoms of the surface through their deprotonated carboxylic groups. A second, dissociative interaction occurs between the molecular thiol groups and the surface. It is attributed to a dissociative bond to the bridging oxygen vacancies. Most likely, the thiol groups are deprotonated and a bond is formed between the thiolates and defects. In an alternative scenario, the C-S bond is cleaved and atomic sulfur binds to the defects. With regard to the molecular amino groups, they remain neutral at the lowest investigated coverages (0.3-0.5 ML), but already starting from around 0.7 ML nominal coverage protons are being transferred to them. The fraction of protonated amino groups increases with coverage and becomes dominating in multilayers prepared at room temperature and -65 degrees C. In these multilayers the carboxylic groups are deprotonated. (C) 2010 Elsevier B.V. All tights reserved.
|
|
| 3. |
- Ataman, Evren, et al.
(författare)
-
Modification of the Size of Supported Clusters by Coadsorption of an Organic Compound: Gold and l-Cysteine on Rutile TiO(2)(110).
- 2011
-
Ingår i: Langmuir. - : American Chemical Society (ACS). - 0743-7463 .- 1520-5827. ; 27:18, s. 11466-11474
-
Tidskriftsartikel (refereegranskat)abstract
- Using X-ray photoelectron spectroscopy we studied the coadsorption of the amino acid l-cysteine and gold on a rutile TiO(2)(110) surface under ultrahigh vacuum conditions. Irrespective of the deposition order, i.e., irrespective of whether l-cysteine or gold is deposited first, the primary interaction between l-cysteine and the gold clusters formed at the surface takes place through the deprotonated thiol group of the molecule. The deposition order, however, has a profound influence on the size of the gold clusters as well as their location on the surface. If l-cysteine is deposited first the clusters are smaller by a factor two to three compared to gold deposited onto the pristine TiO(2)(110) surface and then covered by l-cysteine. Further, in the former case the clusters cover the molecules and thus form the outermost layer of the sample. We also find that above a minimum gold cluster size the gold cluster/l-cysteine bond is stronger than the l-cysteine/surface bridging oxygen vacancy bond, which, in turn, is stronger than the gold cluster/vacancy bond.
|
|
| 4. |
- Ataman, Evren, et al.
(författare)
-
Unconventional Zwitterionic State of L-Cysteine
- 2011
-
Ingår i: The Journal of Physical Chemistry Letters. - : American Chemical Society (ACS). - 1948-7185. ; 2:14, s. 1677-1681
-
Tidskriftsartikel (refereegranskat)abstract
- We report the signature of an unconventional zwitterion in thick (>40 angstrom) L-cysteine films grown at low temperature (100 K) by means of sublimation in ultrahigh vacuum. Using X-ray photoelectron spectroscopy (XPS) we find that protonated amino groups (57%) are less prevalent than in films grown at higher temperatures. A large majority of the protonated amino groups receive the hydrogen through deprotonation of the thiol group (45%) and, in contrast, only a small fraction of the carboxylic groups (13%) is deprotonated. This shows, for the first time, the unconventional zwitterion to be the dominant species in L-cysteine. We believe the unusual growth parameters are responsible for this novel observation.
|
|
| 5. |
- Baran, J. D., et al.
(författare)
-
Theoretical and experimental comparison of SnPc, PbPc, and CoPc adsorption on Ag(111)
- 2010
-
Ingår i: Physical Review B (Condensed Matter and Materials Physics). - 1098-0121 .- 1550-235X. ; 81:7
-
Tidskriftsartikel (refereegranskat)abstract
- A combination of normal-incidence x-ray standing-wave (NIXSW) spectroscopy, x-ray photoelectron spectroscopy (XPS), scanning tunneling microscopy (STM), and density-functional theory (DFT) has been used to investigate the interaction of a number of phthalocyanine molecules (specifically, SnPc, PbPc, and CoPc) with the Ag(111) surface. The metal-surface distances predicted by the DFT calculations for SnPc/Ag(111) (2.48 angstrom) and CoPc/Ag(111) (2.88 angstrom) are in good agreement with our NIXSW experimental results for these systems (2.31 +/- 0.09 and 2.90 +/- 0.05 angstrom, respectively). Good agreement is also found between calculated partial density-of-states plots and STM images of CoPc on Ag(111). Although the DFT and Pb 4f NIXSW results for the Pb-Ag(111) distance are similarly in apparently good agreement, the Pb 4f core-level data suggest that a chemical reaction between PbPc and Ag(111) occurs due to the annealing procedure used in our experiments and that the similarity of the DFT and Pb 4f NIXSW values for the Pb-Ag(111) distance is likely to be fortuitous. We interpret the Pb 4f XPS data as indicating that the Pb atom can detach from the PbPc molecule when it is adsorbed in the "Pb-down" position, leading to the formation of a Pb-Ag alloy and the concomitant reduction in Pb from a Pb2+ state (in bulklike films of PbPc) to Pb-0. In contrast to SnPc, neither PbPc nor CoPc forms a well-ordered monolayer on Ag(111) via the deposition and annealing procedures we have used. Our DFT calculations show that each of the phthalocyanine molecules donate charge to the silver surface, and that back donation from Ag to the metal atom (Co, Sn, or Pb) is only significant for CoPc.
|
|
| 6. |
- Borck, O., et al.
(författare)
-
Adsorption of methylamine on Ni3Al(111) and NiAl(110)-a high resolution photoelectron spectroscopy and density functional theory study
- 2010
-
Ingår i: Journal of Physics: Condensed Matter. - : IOP Publishing. - 1361-648X .- 0953-8984. ; 22:39
-
Tidskriftsartikel (refereegranskat)abstract
- Methylamine adsorption on the ordered Ni3Al(111) and NiAl(110) surfaces has been investigated by high resolution photoelectron spectroscopy and density functional theory calculations. Methylamine adsorbs molecularly at both surfaces at low temperature (90 K). The experiments show that methylamine interacts with the surface aluminium atoms on both surfaces, resulting in a positive binding energy shift relative to the Al 2p bulk contributions. A shift towards lower binding energy is also observed on NiAl(110) attributed to first and second layer surface Al atoms not bonded to methylamine. According to total energy calculations methylamine binds through its N atom to Al on-top sites on NiAl(110) while the Ni on-top site is found to be slightly preferred over the Al on-top site on Ni3Al(111). Calculated adsorbate induced shifts are, however, in good agreement with the experimental values only when methylamine is situated in the Al on-top site on both surfaces. In both cases, a lone pair bonding mechanism is found.
|
|
| 7. |
- Britton, Andrew J., et al.
(författare)
-
Charge transfer between the Au(111) surface and adsorbed C-60: Resonant photoemission and new core-hole decay channels
- 2010
-
Ingår i: Journal of Chemical Physics. - : AIP Publishing. - 0021-9606 .- 1089-7690. ; 133:9
-
Tidskriftsartikel (refereegranskat)abstract
- The interaction of C-60 with the Au(111) surface has been investigated using synchrotron radiation-based electron spectroscopy. Resonant photoelectron spectroscopy and autoionization spectroscopy have been used to probe the coupling between the molecule and the substrate. Three distinct high energy spectator Auger features were observed that are only evident for a monolayer of C-60 chemisorbed to the Au (111) surface and not a multilayer or the clean surface itself. Combined with C 1s x-ray absorption and valence band spectra, the data suggest a decay process not previously reported for this system. This is a spectator decay channel involving electrons transferred from the gold substrate to the adsorbed molecule, either in the ground state or during the timescale of the core-hole lifetime. Both possibilities are considered in the interpretation of the results, which support, on balance, a ground state charge transfer. (C) 2010 American Institute of Physics. [doi:10.1063/1.3488299]
|
|
| 8. |
- Gerber, Timm, et al.
(författare)
-
CO-Induced Smoluchowski Ripening of Pt Cluster Arrays on the Graphene/Ir(111) Moire
- 2013
-
Ingår i: ACS Nano. - : American Chemical Society (ACS). - 1936-086X .- 1936-0851. ; 7:3, s. 2020-2031
-
Tidskriftsartikel (refereegranskat)abstract
- Regular Pt cluster arrays grown on the moire template formed by graphene on Ir(111) were tested for their stability with respect to CO gas exposure. Cluster stability and adsorption-Induced processes were analyzed as a function of cluster size, with In situ scanning tunneling microscopy and X-ray photoelectron spectroscopy. Small clusters containing fewer than 10 atoms were unstable upon CO adsorption. They sintered through Smoluchowski ripening-cluster diffusion and coalescence rather than the frequently reported Ostwald ripening mediated by metal-adsorbate complexes. Larger dusters remained immobile upon CO adsorption but became more three-dimensional. Careful analysis of the experimental data complemented by ab initio density functional theory calculations provides insight Into the origin of the CO-induced Pt cluster ripening and shape transformations.
|
|
| 9. |
- Grånäs, Elin, et al.
(författare)
-
Oxygen Intercalation under Graphene on Ir(111): Energetics, Kinetics, and the Role of Graphene Edges.
- 2012
-
Ingår i: ACS Nano. - : American Chemical Society (ACS). - 1936-086X .- 1936-0851.
-
Tidskriftsartikel (refereegranskat)abstract
- Using X-ray photoemission spectroscopy (XPS) and scanning tunneling microscopy (STM) we resolve the temperature-, time-, and flake size-dependent intercalation phases of oxygen underneath graphene on Ir(111) formed upon exposure to molecular oxygen. Through the applied pressure of molecular oxygen the atomic oxygen created on the bare Ir terraces is driven underneath graphene flakes. The importance of substrate steps and of the unbinding of graphene flake edges from the substrate for the intercalation is identified. With the use of CO titration to selectively remove oxygen from the bare Ir terraces the energetics of intercalation is uncovered. Cluster decoration techniques are used as an efficient tool to visualize intercalation processes in real space.
|
|
| 10. |
- Hagleitner, Daniel R., et al.
(författare)
-
Bulk and surface characterization of In2O3(001) single crystals
- 2012
-
Ingår i: Physical Review B (Condensed Matter and Materials Physics). - 1098-0121. ; 85:11
-
Tidskriftsartikel (refereegranskat)abstract
- A comprehensive bulk and surface investigation of high-quality In2O3(001) single crystals is reported. The transparent-yellow, cube-shaped single crystals were grown using the flux method. Inductively coupled plasma mass spectrometry (ICP-MS) reveals small residues of Pb, Mg, and Pt in the crystals. Four-point-probe measurements show a resistivity of 2.0 +/- 0.5 x 10(5) Omega cm, which translates into a carrier concentration of approximate to 10(12) cm(-3). The results from x-ray diffraction (XRD) measurements revise the lattice constant to 10.1150(5) angstrom from the previously accepted value of 10.117 angstrom. Scanning tunneling microscopy (STM) images of a reduced (sputtered/annealed) and oxidized (exposure to atomic oxygen at 300 degrees C) surface show a step height of 5 angstrom, which indicates a preference for one type of surface termination. The surfaces stay flat without any evidence for macroscopic faceting under any of these preparation conditions. A combination of low-energy ion scattering (LEIS) and atomically resolved STM indicates an indium-terminated surface with small islands of 2.5 angstrom height under reducing conditions, with a surface structure corresponding to a strongly distorted indium lattice. Scanning tunneling spectroscopy (STS) reveals a pronounced surface state at the Fermi level (E-F). Photoelectron spectroscopy (PES) shows additional, deep-lying band gap states, which can be removed by exposure of the surface to atomic oxygen. Oxidation also results in a shoulder at the O 1s core level at a higher binding energy, possibly indicative of a surface peroxide species. A downward band bending of 0.4 eV is observed for the reduced surface, while the band bending of the oxidized surface is of the order of 0.1 eV or less.
|
|
