| 1. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 2. |
- Widdowson, A., et al.
(författare)
-
Removal of beryllium-containing films deposited in JET from mirror surfaces by laser cleaning
- 2011
-
Ingår i: Journal of Nuclear Materials. - : Elsevier BV. - 0022-3115 .- 1873-4820. ; 415:1, s. S1199-S1202
-
Tidskriftsartikel (refereegranskat)abstract
- A set of stainless steel (SS) and molybdenum mirror samples located in the divertor and at the outer mid-plane of the vessel were exposed in JET from 2005 to 2007. A selection of these mirror samples with well adhered deposits (i.e. not flaking) of up to a few hundred nanometers in thickness and with Be/C ratios ranging from 0 to similar to 1 have been cleaned using a laser system developed at CEA, Saclay. Following laser cleaning the recovered reflectivity was generally better in the infrared than the visible spectrum, with recovery of up to 90% of the initial reflectivity being obtained at 1600 nm for both Mo and SS mirrors falling as low as 20-30% of initial reflectivity at a wavelength of 400 nm for some SS mirrors, rising to similar to 80% for Mo mirrors. Some deposit remained on the mirrors after the cleaning trials.
|
|
