| 1. |
- Annamalai, Alagappan, et al.
(författare)
-
Influence of Sb5+ as a Double Donor on Hematite (Fe3+) Photoanodes for Surface-Enhanced Photoelectrochemical Water Oxidation
- 2018
-
Ingår i: ACS Applied Materials and Interfaces. - : American Chemical Society (ACS). - 1944-8244 .- 1944-8252. ; 10:19, s. 16467-16473
-
Tidskriftsartikel (refereegranskat)abstract
- To exploit the full potential of hematite (α-Fe2O3) as an efficient photoanode for water oxidation, the redox processes occurring at the Fe2O3/electrolyte interface need to be studied in greater detail. Ex situ doping is an excellent technique to introduce dopants onto the photoanode surface and to modify the photoanode/electrolyte interface. In this context, we selected antimony (Sb5+) as the ex situ dopant because it is an effective electron donor and reduces recombination effects and concurrently utilize the possibility to tuning the surface charge and wettability. In the presence of Sb5+ states in Sb-doped Fe2O3 photoanodes, as confirmed by X-ray photoelectron spectroscopy, we observed a 10-fold increase in carrier concentration (1.1 × 1020 vs 1.3 × 1019 cm–3) and decreased photoanode/electrolyte charge transfer resistance (∼990 vs ∼3700 Ω). Furthermore, a broad range of surface characterization techniques such as Fourier-transform infrared spectroscopy, ζ-potential, and contact angle measurements reveal that changes in the surface hydroxyl groups following the ex situ doping also have an effect on the water splitting capability. Theoretical calculations suggest that Sb5+ can activate multiple Fe3+ ions simultaneously, in addition to increasing the surface charge and enhancing the electron/hole transport properties. To a greater extent, the Sb5+- surface-doped determines the interfacial properties of electrochemical charge transfer, leading to an efficient water oxidation mechanism.
|
|
| 2. |
- Asres, Georgies Alene, et al.
(författare)
-
Ultrasensitive H2S gas sensors based on p-type WS2 hybrid materials
- 2018
-
Ingår i: Nano Reseach. - : Springer. - 1998-0124 .- 1998-0000. ; 11:8, s. 4215-4224
-
Tidskriftsartikel (refereegranskat)abstract
- Owing to their higher intrinsic electrical conductivity and chemical stability with respect to their oxide counterparts, nanostructured metal sulfides are expected to revive materials for resistive chemical sensor applications. Herein, we explore the gas sensing behavior of WS2 nanowire-nanoflake hybrid materials and demonstrate their excellent sensitivity (0.043 ppm-1) as well as high selectivity towards H2S relative to CO, NH3, H2, and NO (with corresponding sensitivities of 0.002, 0.0074, 0.0002, and 0.0046 ppm-1, respectively). Gas response measurements, complemented with the results of X-ray photoelectron spectroscopy analysis and first-principles calculations based on density functional theory, suggest that the intrinsic electronic properties of pristine WS2 alone are not sufficient to explain the observed high sensitivity towards H2S. A major role in this behavior is also played by O doping in the S sites of the WS2 lattice. The results of the present study open up new avenues for the use of transition metal disulfide nanomaterials as effective alternatives to metal oxides in future applications for industrial process control, security, and health and environmental safety.
|
|
| 3. |
- Behravesh, Erfan, et al.
(författare)
-
Synthesis and characterization of Au nano particles supported catalysts for partial oxidation of ethanol : Influence of solution pH, Au nanoparticle size, support structure and acidity
- 2017
-
Ingår i: Journal of Catalysis. - : Elsevier. - 0021-9517 .- 1090-2694. ; 353, s. 223-238
-
Tidskriftsartikel (refereegranskat)abstract
- Partial oxidation of ethanol to acetaldehyde was carried out over gold catalysts supported on various oxides and zeolites by deposition precipitation. The special focus of this work was on the influence of H-Y zeolite surface charge on Au cluster size and loading linking it to activity and selectivity in ethanol oxidation and comparing with other studied catalysts. The catalysts were characterized by nitrogen physisorption, transmission electron microscopy (TEM), scanning electron microscopy/energy dispersive X-ray analysis (SEM/EDXA), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), Fourier transform infrared spectroscopy (FTIR) and zeta potential measurements. pH of the solution governed the Au NPs size within the range of 5.8–13.2 nm with less negatively charged surfaces leading to formation of smaller clusters. Au loading on H-Y zeolite with silica to alumina ratio of 80 was increased by raising the pH. In fact, H-Y-12 and H-Beta-25 were selective towards diethyl ether while acetaldehyde was the prevalent product on less acidic H-Y-80. The results demonstrated strong dependency of the catalytic activity on the Au cluster size. Namely turn over frequency (TOF) decreased with an increase in metal size from 6.3 to 9.3 nm on H-Y-80. Selectivity towards acetaldehyde and ethyl acetate did not change significantly on H-Y-80 within 6.3–9.3 nm Au particle size range. On Al2O3 support, however, selectivity towards acetaldehyde increased considerably upon diminishing Au average particle size from 3.7 to 2.1 nm.
|
|
| 4. |
- Biasi, P., et al.
(författare)
-
Revealing the role of bromide in the H2O2 direct synthesis with the catalyst wet pretreatment method (CWPM)
- 2017
-
Ingår i: AIChE Journal. - : American Institute of Chemical Engineers. - 0001-1541 .- 1547-5905. ; 63:1, s. 32-42
-
Tidskriftsartikel (refereegranskat)abstract
- A tailor-made Pd0/K2621 catalyst was subjected to post synthesis modification via a wet treatment procedure. The aimwas the understanding of the role of promoters and how—if any—improvements could be qualitatively related to the cat-alyst performance for the H2O2direct synthesis. The Catalyst Wet Pretreatment Method was applied in different metha-nolic solutions containing H2O2, NaBr, and H3PO4, either as single modifiers or as a mixture. The catalyst wascharacterized by Transmission Electron Microscopy and X-ray Photoelectron Spectroscopy. It was concluded that themodified catalysts give rise to higher selectivities compared to the pristi ne reference catalyst thus opening a possibilityto exclude the addit ion of the undesirable selectivity enhancers in the reaction medium. This work provides original evi-dence on the role of promoter s, especially bromide, allowing the formulation of a new reaction mechanism for one ofthe most challenging reactions recognized by the world.
|
|
| 5. |
- Borah, Raju Kumar, et al.
(författare)
-
Copper Oxide Nanoparticles as a Mild and Efficient Catalyst for N-Arylation of Imidazole and Aniline with Boronic Acids at Room Temperature
- 2017
-
Ingår i: Synlett. - : Georg Thieme Verlag KG. - 0936-5214 .- 1437-2096. ; 28:10, s. 1177-1182
-
Tidskriftsartikel (refereegranskat)abstract
- The present work describes the excellent catalytic activity of copper(II) oxide nanoparticles (NPs) towards N-arylation of aniline and imidazole at room temperature. The copper(II) oxide NPs were synthesized by a thermal refluxing technique and characterized by FT-IR spectroscopy; powder XRD, SEM, EDX, TEM, TGA, XPS, BET surface area analysis, and particle size analysis. The size of the NPs was found to be around 12 nm having a surface area of 164.180 m(2) g(-1). The catalytic system was also found to be recyclable and could be reused in subsequent catalytic runs without a significant loss of activity.
|
|
| 6. |
- Bukhanko, Natalia, et al.
(författare)
-
Gas phase synthesis of isopropyl chloride from isopropanol and HCl over alumina and flexible 3-D carbon foam supported catalysts
- 2017
-
Ingår i: Applied Catalysis A. - : Elsevier. - 0926-860X .- 1873-3875. ; 542:25, s. 212-225
-
Tidskriftsartikel (refereegranskat)abstract
- Isopropyl chloride synthesis from isopropanol and HCl in gas phase over ZnCl2 catalysts supported on Al2O3 as well as flexible carbon foam was studied in a continuous reactor. A series of catalytic materials were synthesised and characterised by BET, XPS, SEM, TEM, XRD and NH3-TPD methods. Catalytic activity tests (product selectivity and conversion of reactants) were performed for all materials and optimal reaction conditions (temperature and feedstock flow rates) were found. The results indicate that the highest yield of isopropyl chloride was obtained over 5 wt.% ZnCl2 on commercial Al2O3 (No. II) (95.3%). Determination of product mixture compositions and by-product identification were done using a GC-MS method. Carbon foam variant catalyst, 5 wt.% ZnCl2/C, was found to perform best out of the carbon-supported materials, achieving ∼75% yield of isopropyl chloride. The kinetic model describing the process in a continuous packed bed reactor was proposed and kinetic parameters were calculated. The activation energy for the formation of isopropyl chloride reaction directly from isopropanol and HCl was found to be ∼58 kJ/mol.
|
|
| 7. |
- Cano, A., et al.
(författare)
-
Contribution to the coordination chemistry of transition metal nitroprussides : a cryo-XPS study
- 2019
-
Ingår i: New Journal of Chemistry. - : Royal Society of Chemistry. - 1144-0546 .- 1369-9261. ; 43:12, s. 4835-4848
-
Tidskriftsartikel (refereegranskat)abstract
- The series of coordination polymers under investigation was formed by the assembly of a pentacyanonitrosylferrate(ii) anionic block, [Fe(CN)(5)NO](2-), through monovalent and divalent transition metal ions, e.g. Mn2+, Fe2+, Co2+, Ni2+, Cu2+, Zn2+, Cd2+, Hg2+ and Ag+. For divalent ions, the resulting materials have a 3D porous framework with attractive features for applications in gas storage and separation, as electroactive solids, light-driven molecular magnets, and so on; in this study, we report the results obtained for a series of coordination polymers using the cryogenic X-ray photoelectron spectroscopy (cryo-XPS) data; comprehensive details regarding their coordination chemistries were obtained from the acquired spectra in addition to their comparison with the structural and spectroscopic information obtained from other techniques. The results discussed herein are original and contribute towards the understanding of the electronic structures and related properties for this family of coordination polymers. This series of solids was found to be highly susceptible to strong damage induced by X-ray beams throughout the conventional XPS experiment; therefore, the analysis was conducted under cryogenic conditions.
|
|
| 8. |
- Cano, A., et al.
(författare)
-
Intercalation of pyrazine in layered copper nitroprusside : synthesis, crystal structure and XPS study
- 2019
-
Ingår i: Journal of Solid State Chemistry. - : Elsevier. - 0022-4596 .- 1095-726X. ; 273, s. 1-10
-
Tidskriftsartikel (refereegranskat)abstract
- Hybrid inorganic–organic solids form an interesting family of functional materials, where their functionalities are determined by both, the inorganic and organic building blocks. This study reports the intercalation of pyrazine in 2D copper nitroprusside, the crystal structure of the resulting hybrid solid and explores the scope of cryogenic X-ray photoelectron spectroscopy (XPS) to shed light on its electronic structure. In this material, the pyrazine molecule appears coordinated to Cu atoms from neighboring layers, to form the columns in the resulting 3D porous framework. Its crystal structure was solved and refined from the corresponding XRD powder pattern. XPS data, recorded under cryogenic conditions, provided fine details on the electronic structure of this hybrid solid. The binding energy values for the ligand atoms and the involved metals show a definite correlation with the structural data and FT-IR spectra. When XPS spectra were recorded at room temperature, a significant sample decomposition was observed. Three possible mechanisms for the sample damage during the XPS experiment are considered. The hybrid material under study is representative of a wide series of nanoporous solids obtained by intercalation of organic pillars between 2D inorganic solids.
|
|
| 9. |
|
|
| 10. |
- Davidovich, P. B., et al.
(författare)
-
Synthesis and structure of dinitrosyl iron complexes with secondary thiolate bridging ligands [Fe-2(mμ-SCHR2)(2)(NO)(4)], R = Me, Ph
- 2015
-
Ingår i: Polyhedron. - : Elsevier. - 0277-5387 .- 1873-3719. ; 90, s. 197-201
-
Tidskriftsartikel (refereegranskat)abstract
- New dinitrosyl iron complexes of binuclear structure [Fe-2(mu-SCHMe2)(2)(NO)(4)] and [Fe-2(mu-SCHPh2)(2)(NO)(4)] were first synthesized employing new method from Fe(CO)(5), corresponding thiol, and EtONO. Complexes structures were determined by XRD technique. DFT calculations were performed to probe the cis-conformer structures in gas and solution phases. NO donor ability of the complex with isopropyl thiolate ligand was studied.
|
|
