| 1. |
- Liang, Wenbiao, et al.
(författare)
-
Synthesis of single-crystal LiNi0.8Co0.1Mn0.1O2 materials for Li-ion batteries by microfluidic technology
- 2023
-
Ingår i: Chemical Engineering Journal. - : Elsevier. - 1385-8947 .- 1873-3212. ; 464
-
Tidskriftsartikel (refereegranskat)abstract
- Single-crystal LiNixMnyCo1-x-yO2 (SC-NMC) cathode with electro-chemo-mechanically compliant microstructure is regarded as a promising candidate for high-energy-density lithium ion battery. However, the research of Ni-rich SC-NCM still lags behind its corresponding polycrystalline cathode materials, mainly due to the difficulties in synthesis. Herein, the single-crystal LiNi0.8Mn0.1Co0.1O2 cathode (SC-NCM811) was successfully synthesized by microfluidic technology combined with the solid-state lithiation process. The nano-sized Ni0.8C- o0.1Mn0.1(OH)2 precursor prepared via microfluidic technology enhances its accessibility to lithium salts, thus exhibiting high chemical activity for lithiation reaction. As a result, the optimized SC-NCM811 cathode shows relatively small-scale grain size (<3 mu m), low cation mixing and well layered structure, which is beneficial to electrochemical kinetics and redox reversibility. The electrochemical characterization results further reveal that the optimized SC-NCM811 cathode can well balance the cycle performance and rate capability, showing good electrochemical performance. Overall, microfluidic technology is expected to provide a new strategy for pre-paring single-crystal Ni-rich cathode materials, which may extend to the commercial application of other cathode materials.
|
|
| 2. |
- Zhang, Meihong, et al.
(författare)
-
A simple and rapid route for synthesizing the nanosized g-C3N4 materials with narrow bandgap and their photocatalytic activity
- 2023
-
Ingår i: Surface and Interface Analysis. - : John Wiley & Sons. - 0142-2421 .- 1096-9918. ; 55:1, s. 63-70
-
Tidskriftsartikel (refereegranskat)abstract
- The graphitic carbon nitride (g-C3N4) materials with many intriguing properties have attracted much attention in photocatalysis. The photocatalytic activity of g-C3N4 is hindered by serious aggregation and limited exposed active sites. Herein is shown that nanosized g-C3N4 can be simply obtained by a superfast high-pressure homogenization approach. The high-pressure homogenization treatment can provide strong force to cut and/or to exfoliate the bulk g-C3N4 into nanosized g-C3N4 with good dispersion. Moreover, choosing different solvents during treatment can cause a different surface structure of as-prepared nanosized g-C3N4. In addition, the narrow bandgap properties, the high photogenerated charge carrier separation, and the transport abilities are achieved in as-prepared nanosized g-C3N4 because of the retaining conjugated C3N4 system. Specifically, the photocatalytic activities of as-prepared nanosized g-C3N4 have been significantly enhanced in terms of degradation of organic dye Rhodamine B (RhB) under visible light irradiation (10 times higher than that of bulk g-C3N4). These findings can provide a promising and simple approach to the exfoliation, nanonization, and surface functionalization of 2D layered materials.
|
|
