SwePub
Sök i LIBRIS databas

  Utökad sökning

WFRF:(Sundvall Krister)
 

Sökning: WFRF:(Sundvall Krister) > (2008) > Seizure and wear ra...

Seizure and wear rate testing of wheel–rail contacts under lubricated conditions using pin-on-disc methodology

Sundh, Jon (författare)
KTH,Maskinkonstruktion (Avd.)
Olofsson, Ulf (författare)
KTH,Tribologi
Sundvall, Krister (författare)
KTH,Maskinkonstruktion (Avd.)
KTH Maskinkonstruktion (Avd(creator_code:org_t)
Elsevier BV, 2008
2008
Engelska.
Ingår i: Wear. - : Elsevier BV. - 0043-1648 .- 1873-2577. ; , s. 1425-1430
  • Tidskriftsartikel (refereegranskat)
Abstract Ämnesord
Stäng  
  • An increased wear rate and a shift of wear mechanism in the wheel-rail contact has been observed in tight curves, mainly due to the change from an almost pure rolling contact to more of a sliding contact. The wheel flange-rail gauge contact is commonly known to experience the toughest conditions of the overall wheel-rail contact in terms of contact pressure and sliding velocity. The wheel flange-rail gauge contact is preferably lubricated to reduce the wear rate and to minimise the risk of transition to severe wear or seizure. The amount and type of lubrication are therefore important parameters if one is to control the wear rate. In this study, a flange contact is experimentally simulated using pin-on-disc testing, to determine the difference in wear rate among a selection of lubricants under different contact conditions. The selection of lubricants consisted of environmentally adapted oils, mineral oils, and greases containing different amounts of EP and AW additives.The results of the pin-on-disc testing indicate that both the amount and type of lubrication applied is decisive for the wear rate and active wear mechanism. Tests have also been performed to simulate either on-board or wayside lubrication, by applying the lubricant at different intervals. A general observation is that under starved lubrication conditions a transition to severe wear is initiated and the wear rate increases rapidly, i.e., all tests indicate that the contact between wheel and rail must be lubricated to avoid high wear rates.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Materialteknik -- Bearbetnings-, yt- och fogningsteknik (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Materials Engineering -- Manufacturing, Surface and Joining Technology (hsv//eng)

Nyckelord

rail; wheel; wear rate; environmentally adapted; lubrication
Mechanical manufacturing engineering
Mekanisk tillverkningsteknik

Publikations- och innehållstyp

ref (ämneskategori)
art (ämneskategori)

Hitta via bibliotek

  • Wear (Sök värdpublikationen i LIBRIS)

Till lärosätets databas

Hitta mer i SwePub

Av författaren/redakt...
Sundh, Jon
Olofsson, Ulf
Sundvall, Kriste ...
Om ämnet
TEKNIK OCH TEKNOLOGIER
TEKNIK OCH TEKNO ...
och Materialteknik
och Bearbetnings yt ...
Artiklar i publikationen
Wear
Av lärosätet
Kungliga Tekniska Högskolan

Sök utanför SwePub

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy