1. |
- Zhang, Shidong, et al.
(författare)
-
Simple and complex polymer electrolyte fuel cell stack models : A comparison
- 2018. - 13
-
Ingår i: ECS Transactions. - : The Electrochemical Society. - 1938-6737 .- 1938-5862. - 9781607685395 ; 86, s. 287-300
-
Konferensbidrag (refereegranskat)abstract
- In this paper, two distinct polymer electrolyte fuel cell stack models are constructed: a detailed numerical model (DNM) employing a fine-scale computational mesh and a coarse-mesh approach based on a distributed resistance analogy (DRA) where diffusion terms in the transport equations are replaced by rate terms. Both methods are applied to a 5-cell, high-temperature polymer electrolyte fuel cell stack with an active area of 200 cm2 per cell. The polarization curve and local current density distributions from both the DRA and DNM are compared with experimental data, finding good agreement. Temperature, pressure, Nernst potential, and species distributions are also exhibited. The DNM displays details of fine-scale local extrema not captured by the DRA; however, the latter requires orders of magnitude less computer processor power and memory for execution. Both methods provide much finer-scale results than present experimental techniques.
|
|
2. |
- Andersson, M., et al.
(författare)
-
Coupling of lattice boltzmann and volume of fluid approaches to study the droplet behavior at the gas diffusion layer/gas channel interface
- 2018. - 13
-
Ingår i: ECS Transactions. - : The Electrochemical Society. - 1938-6737 .- 1938-5862. - 9781607688600 ; 86, s. 329-336
-
Konferensbidrag (refereegranskat)abstract
- A typical polymer electrolyte fuel cell (PEFC) flow field consists of micro/minichannels. The continues removal of liquid water from the cathode channels is a critical topic, as water droplets forming in the channels may block the transport of gaseous oxygen to the active sites, which not only gives an uneven current distribution and substantial loss of performance, but also, increases degradation rates and unstable operation. Water generated by the electrochemical reactions condenses, depending on temperature mainly, into liquid form, potentially flooding various part of the PEFC. The aim of this work is to obtain an increased understanding of the droplet behavior at the gas diffusion layer (GDL) interface with the gas channels in PEFCs by the coupling of Lattice Boltzmann (LB) and Volume of Fluid (VOF) approaches. A multiscale environment is established with input parameters in the VOF model being extracted from in-house LB calculations. It is clear that the contact angle as well as the size of the liquid droplet vary with positions at the GDL surface, depending on the stochastic GDL geometry. A VOF model describing one straight channel with one gas inlet, one liquid inlet (at the GDL surface) and one two-phase outlet is employed.
|
|