Dynamic failure of clamped circular plates subjected to an underwater shock

• Clamped circular copper plates have been subjected to exponentially decaying underwater blast waves with peak pressures in the range 10MPa to 300MPa and decay constants varying between 0.05ms to 1.1 ms. The deformation and failure modes were observed by high-speed photography. For the thin plates considered in this study, the failure modes were primarily governed by the peak pressures and were reasonably independent of the blast wave decay constant. Three modes of deformation and failure were identified. At low pressures, the plates undergo bending and stretching without rupture (mode I). At intermediate pressures a range of tensile tearing modes were observed, from petalling failures to tearing at the supports with increasing blast pressures. These tearing modes are referred to as mode II failures. At the highest pressures investigated here, the plate tears at the supports in a manner that is reminiscent of a shear-off failure. This failure is labeled as mode III. Scanning electron micrographs of the failure surfaces showed that in all cases, the local failure mechanism was tensile necking. Finite element (FE) simulations employing a local shear failure criterion are used to model the rupture of the material. Appropriately calibrated FE models capture all failure modes with sufficient fidelity.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Maskinteknik -- Strömningsmekanik och akustik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Mechanical Engineering -- Fluid Mechanics and Acoustics (hsv//eng)

Nyckelord

dynamic fracture

petalling

underwater blast

FE simulation

Fluid mechanics

Strömningsmekanik

Publikations- och innehållstyp

ref (ämneskategori)

art (ämneskategori)