| 1. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 2. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 3. |
- Anney, Richard, et al.
(författare)
-
A genome-wide scan for common alleles affecting risk for autism.
- 2010
-
Ingår i: Human Molecular Genetics. - : Oxford University Press (OUP). - 0964-6906 .- 1460-2083. ; 19:20, s. 4072-4082
-
Tidskriftsartikel (refereegranskat)abstract
- Although autism spectrum disorders (ASDs) have a substantial genetic basis, most of the known genetic risk has been traced to rare variants, principally copy number variants (CNVs). To identify common risk variation, the Autism Genome Project (AGP) Consortium genotyped 1558 rigorously defined ASD families for 1 million single-nucleotide polymorphisms (SNPs) and analyzed these SNP genotypes for association with ASD. In one of four primary association analyses, the association signal for marker rs4141463, located within MACROD2, crossed the genome-wide association significance threshold of P < 5 × 10(-8). When a smaller replication sample was analyzed, the risk allele at rs4141463 was again over-transmitted; yet, consistent with the winner's curse, its effect size in the replication sample was much smaller; and, for the combined samples, the association signal barely fell below the P < 5 × 10(-8) threshold. Exploratory analyses of phenotypic subtypes yielded no significant associations after correction for multiple testing. They did, however, yield strong signals within several genes, KIAA0564, PLD5, POU6F2, ST8SIA2 and TAF1C.
|
|
| 4. |
- Pinto, Dalila, et al.
(författare)
-
Functional impact of global rare copy number variation in autism spectrum disorders.
- 2010
-
Ingår i: Nature. - : Springer Science and Business Media LLC. - 0028-0836 .- 1476-4687. ; 466:7304, s. 368-372
-
Tidskriftsartikel (refereegranskat)abstract
- The autism spectrum disorders (ASDs) are a group of conditions characterized by impairments in reciprocal social interaction and communication, and the presence of restricted and repetitive behaviours. Individuals with an ASD vary greatly in cognitive development, which can range from above average to intellectual disability. Although ASDs are known to be highly heritable ( approximately 90%), the underlying genetic determinants are still largely unknown. Here we analysed the genome-wide characteristics of rare (<1% frequency) copy number variation in ASD using dense genotyping arrays. When comparing 996 ASD individuals of European ancestry to 1,287 matched controls, cases were found to carry a higher global burden of rare, genic copy number variants (CNVs) (1.19 fold, P = 0.012), especially so for loci previously implicated in either ASD and/or intellectual disability (1.69 fold, P = 3.4 x 10(-4)). Among the CNVs there were numerous de novo and inherited events, sometimes in combination in a given family, implicating many novel ASD genes such as SHANK2, SYNGAP1, DLGAP2 and the X-linked DDX53-PTCHD1 locus. We also discovered an enrichment of CNVs disrupting functional gene sets involved in cellular proliferation, projection and motility, and GTPase/Ras signalling. Our results reveal many new genetic and functional targets in ASD that may lead to final connected pathways.
|
|
| 5. |
|
|
| 6. |
- Anney, Richard, et al.
(författare)
-
Individual common variants exert weak effects on the risk for autism spectrum disorders.
- 2012
-
Ingår i: Human Molecular Genetics. - : Oxford University Press (OUP). - 0964-6906 .- 1460-2083. ; 21:21, s. 4781-92
-
Tidskriftsartikel (refereegranskat)abstract
- While it is apparent that rare variation can play an important role in the genetic architecture of autism spectrum disorders (ASD), the contribution of common variation to ASD risk is less clear. To produce a more comprehensive picture, we report Stage 2 of the Autism Genome Project genome-wide association study, adding 1301 ASD families and bringing the total to 2705 families analysed (Stages 1 and 2). In addition to evaluating association of individual SNPs, we also sought evidence that common variants, en masse, might affect risk. Despite genotyping over a million SNPs covering the genome, no single SNP shows significant association with ASD or selected phenotypes at a genome-wide level. The SNP that achieves the smallest p-value from secondary analyses is rs1718101. It falls in CNTNAP2, a gene previously implicated in susceptibility for ASD. This SNP also shows modest association with age of word/phrase acquisition in ASD subjects, of interest because features of language development are also associated with other variation in CNTNAP2. By contrast, allele-scores derived from the transmission of common alleles to Stage 1 cases significantly predict case-status in the independent Stage 2 sample. Despite being significant, the variance explained by these allele scores was small (Vm< 1%). Based on results from individual SNPs and their en masse effect on risk, as inferred from the allele-score results, it is reasonable to conclude that common variants affect ASD risk but their individual effects are modest.
|
|
| 7. |
- Rasmussen, Morten K., et al.
(författare)
-
Stable Cation Inversion at the MgAl2O4(100) Surface
- 2011
-
Ingår i: Physical Review Letters. - 1079-7114. ; 107:3
-
Tidskriftsartikel (refereegranskat)abstract
- From an interplay of atom-resolved noncontact atomic force microscopy, surface x-ray diffraction experiments, and density functional theory calculations, we reveal the detailed atomic-scale structure of the (100) surface of an insulating ternary metal oxide, MgAl2O4 (spinel). We surprisingly find that the MgAl2O4(100) surface is terminated by an Al and O-rich structure with a thermodynamically favored amount of Al atoms interchanged with Mg. This finding implies that so-called Mg-Al antisites, which are defects in the bulk of MgAl2O4, become a thermodynamically stable and integral part of the surface.
|
|
| 8. |
- Vlad, A., et al.
(författare)
-
Hybrid synthesis and processing schemes for highly-ordered polyaniline nanoarchitectures
- 2010
-
Ingår i: INEC 2010 - 2010 3rd International Nanoelectronics Conference, Proceedings. - 9781424435449 ; , s. 429-430
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
- We report on a newly developed technology for the nanoscale processing of the conducting polyaniline (PANI) with an unprecedented areal patterning order and density control exceeding 0.25 teradot/inch 2 . A simple two-step process is put forward to hierarchically build a large variety of functional PANI nanostructures on virtually any type of flexible or rigid substrates. Using template confinement, through Pt catalyzed electroless growth, highly-ordered arrays of distinct PANI nanowires are produced. Complex three-dimensional (3D) structural control is achieved through a direct pattern transfer using a novel type of resist- and dose-modulated 3D electron beam lithography. The method is scalable and provides a generic approach for nanopatterning surfaces with functional polymers. Aspects of the nanoscale PANI growth mechanism are discussed and the highly controllable, sub-picogram scale fabrication is emphasized. Simple schemes for single PANI nanowire fabrication, processing and device integration are presented. ©2010 IEEE.
|
|
| 9. |
- Vlad, A., et al.
(författare)
-
Vertical single nanowire devices based on conducting polymers
- 2012
-
Ingår i: Nanotechnology. - : IOP Publishing. - 1361-6528 .- 0957-4484. ; 23:2
-
Tidskriftsartikel (refereegranskat)abstract
- A simple scheme for single conducting polymer nanowire fabrication and device integration is presented. We discuss a combined top-down and bottom-up approach for the sequential, precise manufacture of vertical polyaniline nanowires. The method is scalable and can be applied on rigid as well as on flexible substrates. The kinetics of the template-confined growth is presented and discussed. We further study the electrical behavior of single vertical polyaniline nanowires and address the fabrication of crossbar latches using a criss-cross arrangement of electrodes. The as-synthesized polyaniline nanowires display electric conductivities reaching values as high as 0.4 S cm(-1).
|
|
| 10. |
- Vlad, M. D., et al.
(författare)
-
Ultrasound monitoring of the setting of calcium-based bone cements
- 2012
-
Ingår i: Journal of materials science. Materials in medicine. - : Springer Science and Business Media LLC. - 0957-4530 .- 1573-4838. ; 23:7, s. 1563-1568
-
Tidskriftsartikel (refereegranskat)abstract
- In this study, the setting of calcium-sulphate (CS) and -phosphate (CP) based bone cements (BCs) was monitored by ultrasound. The objective was to link acoustic and material properties of ceramic-based BCs from the early stages of the cement curing process. The powder phase of the CS-cement consisted of CS hemihydrate; the CP-cement was a mixture of alpha-tricalcium phosphate, CS dihydrate and hydroxyapatite. For the CS-cement, the acoustic impedance z c(t), the speed of sound c c(t) and the density ρc(t) were measured at the interval of liquid-to-powder ratios LPRs from 0.20 to 3.00 ml/g. For the CP-cement, the acoustic characteristics obtained were the z c(t) and the reflection coefficient R p,c(t), and the LPRs ranged from 0.30 to 0.40 ml/g. The resulting acoustic properties indicated that CP- and CS-cements exhibited distinctly different curing behaviour; while CS-cement expanded, CP-cement shrank with time.
|
|
