| 1. |
- Abazov, V. M., et al.
(författare)
-
The upgraded DO detector
- 2006
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 565:2, s. 463-537
-
Tidskriftsartikel (refereegranskat)abstract
- The DO experiment enjoyed a very successful data-collection run at the Fermilab Tevatron collider between 1992 and 1996. Since then, the detector has been upgraded to take advantage of improvements to the Tevatron and to enhance its physics capabilities. We describe the new elements of the detector, including the silicon microstrip tracker, central fiber tracker, solenoidal magnet, preshower detectors, forward muon detector, and forward proton detector. The uranium/liquid -argon calorimeters and central muon detector, remaining from Run 1, are discussed briefly. We also present the associated electronics, triggering, and data acquisition systems, along with the design and implementation of software specific to DO.
|
|
| 2. |
- Abate, E., et al.
(författare)
-
Combined performance tests before installation of the ATLAS Semiconductor and Transition Radiation Tracking Detectors
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS (A Toroidal LHC ApparatuS) Inner Detector provides charged particle tracking in the centre of the ATLAS experiment at the Large Hadron Collider (LHC). The Inner Detector consists of three subdetectors: the Pixel Detector, the Semiconductor Tracker (SCT), and the Transition Radiation Tracker (TRT). This paper summarizes the tests that were carried out at the final stage of SCT+TRT integration prior to their installation in ATLAS. The combined operation and performance of the SCT and TRT barrel and endcap detectors was investigated through a series of noise tests, and by recording the tracks of cosmic rays. This was a crucial test of hardware and software of the combined tracker detector systems. The results of noise and cross-talk tests on the SCT and TRT in their final assembled configuration, using final readout and supply hardware and software, are reported. The reconstruction and analysis of the recorded cosmic tracks allowed testing of the offline analysis chain and verification of basic tracker performance parameters, such as efficiency and spatial resolution, in combined operation before installation.
|
|
| 3. |
- Abazov, V. M., et al.
(författare)
-
Measurement of the isolated photon cross section in p(p)over-bar collisions at root s=1.96 TeV
- 2006
-
Ingår i: Physics Letters B. - : Elsevier BV. - 0370-2693 .- 1873-2445. ; 639:3-4, s. 151-158
-
Tidskriftsartikel (refereegranskat)abstract
- The cross section for the inclusive production of isolated photons has been measured in p (p) over bar collisions at root s = 1.96 TeV with the DO detector at the Fermilab Tevatron Collider. The photons span transverse momenta 23 to 300 GeV and have pseudorapidity vertical bar n vertical bar < 0.9. The cross section is compared with the results from two next-to-leading order perturbative QCD calculations. The theoretical predictions agree with the measurement within uncertainties.
|
|
| 4. |
- Abdesselam, A., et al.
(författare)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221 .- 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
| 5. |
- Abbasi, R., et al.
(författare)
-
The IceCube data acquisition system : Signal capture, digitization, and timestamping
- 2009
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 601:3, s. 294-316
-
Tidskriftsartikel (refereegranskat)abstract
- IceCube is a km-scale neutrino observatory under construction at the South Pole with sensors both in the deep ice (InIce) and on the surface (IceTop). The sensors, called Digital Optical Modules (DOMs). detect, digitize and timestamp the signals from optical Cherenkov-radiation photons. The DOM Main Board (MB) data acquisition subsystem is connected to the central DAQ in the IceCube Laboratory (ICL) by a single twisted copper wire-pair and transmits packetized data on demand. Time calibration is maintained throughout the array by regular transmission to the DOMs of precisely timed analog signals, synchronized to a central GPS-disciplined clock. The design goals and consequent features, functional capabilities, and initial performance of the DOM MB, and the operation of a combined array of DOMs as a system, are described here. Experience with the first InIce strings and the IceTop stations indicates that the system design and performance goals have been achieved. (c) 2009 Elsevier B.V. All rights reserved.
|
|
| 6. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
| 7. |
- Dammann, R., et al.
(författare)
-
Frequent promoter methylation of tumor-related genes in sporadic and men2-associated pheochromocytomas
- 2005
-
Ingår i: Experimental and clinical endocrinology & diabetes. - : Georg Thieme Verlag KG. - 0947-7349 .- 1439-3646. ; 113:1, s. 1-7
-
Tidskriftsartikel (refereegranskat)abstract
- Hypermethylation of CpG island promoters is associated with transcriptional inactivation of tumor suppressor genes in neoplasia. Inactivation of p16 and Pten was related to the development of pheochromocytomas. In this report, we investigated the methylation status of the p16INK4a cell cycle inhibitor gene and other prominent tumor-related genes ( PTEN, RASSF1 A, CDH1, MSH2, MLH1, VHL, and TIMP3) in sporadic and multiple endocrine neoplasia type 2 (MEN2) pheochromocytomas by methylation-specific PCR. Hypermethylation was detected in 48 % of pheochromocytomas for RASSF1 A, 24 % for p16, 36 % for MSH2, 16 % for CDH1, and 8 % for PTEN. No VHL, MLH1, and TIMP3 methylation was observed. Interestingly, the frequency of p16 inactivation in familial tumors was higher (5 out of 12, 42 %) than in sporadic tumors (1 out of 13, 8 %; p = 0.047) and RASSF1 A inactivation was more common in the hereditary tumors (58 %) compared to the sporadic tumors (38 %). Combined methylation of RASSF1 A and p16 was found only in MEN2-related pheochromocytomas. Thus, a subset of hereditary pheochromocytomas displays preferential methylation of p16 and RASSF1 A.
|
|
| 8. |
- Cao, J., et al.
(författare)
-
Error-free spectral encoding and decoding operation of InP O-CDMA encoder
- 2006
-
Ingår i: 2006 Optical Fiber Communication Conference, and the 2006 National Fiber Optic Engineers Conference. - : IEEE. - 1557528039 - 9781557528032
-
Konferensbidrag (refereegranskat)abstract
- We report error-free spectral encoding and decoding operation of an InP monolithic, ultra-compact optical-CDMA encoder/decoder photonic chip pair. The experimental results demonstrate the strong potential for realizing high performance O-CDMA networks with InP micro-systems.
|
|
| 9. |
- Lourdudoss, Sebastian, et al.
(författare)
-
Heteroepitaxy and selective epitaxy for discrete and integrated devices
- 2006
-
Ingår i: 2006 CONFERENCE ON OPTOELECTRONIC AND MICROELECTRONIC MATERIALS & DEVICES. - NEW YORK : IEEE. - 9781424405770 ; , s. 309-311
-
Konferensbidrag (refereegranskat)abstract
- We present first results on heteroepitaxy of InP on silicon on insulator (SOI). We also demonstrate InP nanopillar fabrication by means of selective epitaxy. Selective epitaxy is also exploited to fabricate advanced photonic integrated devices for Optical Code Division Multiplex Access (OCDMA) networking applications.
|
|
| 10. |
- Yoo, S. J. B., et al.
(författare)
-
Spectral phase encoded time spread optical code division multiple access technology for next generation communication networks Invited
- 2007
-
Ingår i: Journal of Optical Networking. - 1536-5379. ; 6:10, s. 1210-1227
-
Tidskriftsartikel (refereegranskat)abstract
- We overview and summarize the progress of the spectral phase encoded time spreading (SPECTS) optical code division multiple access (O-CDMA) technology. Recent progress included a demonstration of a 320 Gbit/s (32-user x 10 Gbit/s) all-optical passive optical network testbed based on the SPECTS O-CDMA technology and a theoretical prediction of the spectral efficiency at 100% and above. In particular, InP-based integrated photonics allows implementation of SPECTS O-CDMA transmitters and receivers monolithically integrated on a chip. The integrated InP chip technology not only allows robust and compact configurations for practical and low-cost O-CDMA network deployments but also offers code reconfigurations at rapid rates for secure communication applications.
|
|
