| 1. |
- Ahlgren Cederlöf, Ebba
(författare)
-
The short, excited life of tellurium : Lifetime analysis of excited states in the Te midshell region
- 2024
-
Licentiatavhandling (övrigt vetenskapligt/konstnärligt)abstract
- In this licentiate thesis, lifetimes of low lying excited states in the midshell region of tellurium isotopes are discussed. The nuclear lifetimes are interesting properties to study, since they are inversely proportional to the transition probabilities, which contain information on the underlying structure of the nucleus. By measuring the lifetime of a transition, information can be gained on e.g. the collectivity of the state.The main results presented in this thesis are the lifetime measurements of the 2+ → 0+ and 4+ → 2+ transitions in 118Te described in Paper I. The principal aim of this paper was to reduce the relative uncertainty in the 2+ lifetime, to better see the trend of the 2+ → 0+ transition probabilities over the tellurium isotopic chain.The work presented in Paper I is based on data from an experiment conducted in 2017 at the JYFL accelerator facility in Jyväskylä, Finland. In this experiment, excited states of were populated in the fusion-evaporation reaction 100Mo(22Ne,4n)118Te at a beam energy of 75 MeV. The lifetimes were extracted using the Recoil Distance Doppler Shift (RDDS) technique, with the Jurogam II γ-ray spectrometer coupled to the Differential Plunger for Unbound Nuclear States (DPUNS). Data analysis was performed using the Differential Decay Curve Method (DDCM) in coincidence mode. The lifetimes were determined to be τ2+ = 7.46(19) ps and τ4+ = 4.25(23) ps, in agreement with previous measurements, but with reduced uncertainty. In the case of the 2+ lifetime, the new result reduces the relative uncertainty of the lifetime from 16% to 2.5%, allowing for more precise tests of theoretical predictions.In addition to 118Te, an analysis of lifetimes of low-lying excited states in the odd-A nuclei 117Te and 119Te is ongoing and an experiment aiming to measure lifetimes in 116Te has been accepted. These nuclides will also be discussed in this thesis.
|
|
| 2. |
- Aho-Mantila, L., et al.
(författare)
-
Assessment of SOLPS5.0 divertor solutions with drifts and currents against L-mode experiments in ASDEX Upgrade and JET
- 2017
-
Ingår i: Plasma Physics and Controlled Fusion. - : IOP PUBLISHING LTD. - 0741-3335 .- 1361-6587. ; 59:3
-
Tidskriftsartikel (refereegranskat)abstract
- The divertor solutions obtained with the plasma edge modelling tool SOLPS5.0 are discussed. The code results are benchmarked against carefully analysed L-mode discharges at various density levels with and without impurity seeding in the full-metal tokamaks ASDEX Upgrade and JET. The role of the cross-field drifts and currents in the solutions is analysed in detail, and the improvements achieved by fully activating the drift and current terms in view of matching the experimental signals are addressed. The persisting discrepancies are also discussed.
|
|
| 3. |
- Aiba, N., et al.
(författare)
-
Analysis of ELM stability with extended MHD models in JET, JT-60U and future JT-60SA tokamak plasmas
- 2018
-
Ingår i: Plasma Physics and Controlled Fusion. - : IOP Publishing. - 0741-3335 .- 1361-6587. ; 60:1
-
Tidskriftsartikel (refereegranskat)abstract
- The stability with respect to a peeling-ballooning mode (PBM) was investigated numerically with extended MHD simulation codes in JET, JT-60U and future JT-60SA plasmas. The MINERVA-DI code was used to analyze the linear stability, including the effects of rotation and ion diamagnetic drift (omega(*i)), in JET-ILW and JT-60SA plasmas, and the JOREK code was used to simulate nonlinear dynamics with rotation, viscosity and resistivity in JT-60U plasmas. It was validated quantitatively that the ELM trigger condition in JET-ILW plasmas can be reasonably explained by taking into account both the rotation and omega(*i) effects in the numerical analysis. When deuterium poloidal rotation is evaluated based on neoclassical theory, an increase in the effective charge of plasma destabilizes the PBM because of an acceleration of rotation and a decrease in omega(*i). The difference in the amount of ELM energy loss in JT-60U plasmas rotating in opposite directions was reproduced qualitatively with JOREK. By comparing the ELM affected areas with linear eigenfunctions, it was confirmed that the difference in the linear stability property, due not to the rotation direction but to the plasma density profile, is thought to be responsible for changing the ELM energy loss just after the ELM crash. A predictive study to determine the pedestal profiles in JT-60SA was performed by updating the EPED1 model to include the rotation and w*i effects in the PBM stability analysis. It was shown that the plasma rotation predicted with the neoclassical toroidal viscosity degrades the pedestal performance by about 10% by destabilizing the PBM, but the pressure pedestal height will be high enough to achieve the target parameters required for the ITER-like shape inductive scenario in JT-60SA.
|
|
| 4. |
- Aiba, N., et al.
(författare)
-
Numerical analysis of ELM stability with rotation and ion diamagnetic drift effects in JET
- 2017
-
Ingår i: Nuclear Fusion. - : IOP PUBLISHING LTD. - 0029-5515 .- 1741-4326. ; 57:12
-
Tidskriftsartikel (refereegranskat)abstract
- Stability to the type-I edge localized mode (ELM) in JET plasmas was investigated numerically by analyzing the stability to a peeling-ballooning mode with the effects of plasma rotation and ion diamagnetic drift. The numerical analysis was performed by solving the extended Frieman-Rotenberg equation with the MINERVA-DI code. To take into account these effects in the stability analysis self-consistently, the procedure of JET equilibrium reconstruction was updated to include the profiles of ion temperature and toroidal rotation, which are determined based on the measurement data in experiments. With the new procedure and MINERVA-DI, it was identified that the stability analysis including the rotation effect can explain the ELM trigger condition in JET with ITER like wall (JET-ILW), though the stability in JET with carbon wall (JET-C) is hardly affected by rotation. The key difference is that the rotation shear in JET-ILW plasmas analyzed in this study is larger than that in JET-C ones, the shear which enhances the dynamic pressure destabilizing a peeling-ballooning mode. In addition, the increase of the toroidal mode number of the unstable MHD mode determining the ELM trigger condition is also important when the plasma density is high in JET-ILW. Though such modes with high toroidal mode number are strongly stabilized by the ion diamagnetic drift effect, it was found that plasma rotation can sometimes overcome this stabilizing effect and destabilizes the peeling-ballooning modes in JET-ILW.
|
|
| 5. |
|
|
| 6. |
- Andersson Sundén, Erik, et al.
(författare)
-
An assessment of nitrogen concentrations from spectroscopic measurements in the JET and ASDEX upgrade divertor
- 2019
-
Ingår i: Nuclear Materials and Energy. - : Elsevier. - 2352-1791. ; 18, s. 147-152
-
Tidskriftsartikel (refereegranskat)abstract
- The impurity concentration in the tokamak divertor plasma is a necessary input for predictive scaling of divertor detachment, however direct measurements from existing tokamaks in different divertor plasma conditions are limited. To address this, we have applied a recently developed spectroscopic N II line ratio technique for measuring the N concentration in the divertor to a range of H-mode and L-mode plasma from the ASDEX Upgrade and JET tokamaks, respectively. The results from both devices show that as the power crossing the separatrix, P-sep, is increased under otherwise similar core conditions (e.g. density), a higher N concentration is required to achieve the same detachment state. For example, the N concentrations at the start of detachment increase from approximate to 2% to approximate to 9% as P-sep, is increased from approximate to 2.5 MW to approximate to 7 MW. These results tentatively agree with scaling law predictions (e.g. Goldston et al.) motivating a further study examining the parameters which affect the N concentration required to reach detachment. Finally, the N concentrations from spectroscopy and the ratio of D and N gas valve fluxes agree within experimental uncertainty only when the vessel surfaces are fully-loaded with N.
|
|
| 7. |
|
|
| 8. |
- Andersson Sundén, Erik, et al.
(författare)
-
Evaluation of neutron spectrometer techniques for ITER using synthetic data
- 2013
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 701, s. 62-71
-
Tidskriftsartikel (refereegranskat)abstract
- A neutron spectrometer at ITER is expected to provide estimates of plasma parameters such as ion temperature, Ti, fuel ion ratio, nt/nd, and Qthermal/Qtot, with 10-20% precision at a time resolution, Δt, of at least 100 ms. The present paper describes a method for evaluating different neutron spectroscopy techniques based on their instrumental response functions and synthetic measurement data. We include five different neutron spectrometric techniques with realistic response functions, based on simulations and measurements where available. The techniques are magnetic proton recoil, thin-foil proton recoil, gamma discriminating organic scintillator, diamond and time-of-flight. The reference position and line of sight of a high resolution neutron spectrometer on ITER are used in the study. ITER plasma conditions are simulated for realistic operating scenarios. The ITER conditions evaluated are beam and radio frequency heated and thermal deuterium-tritium plasmas. Results are given for each technique in terms of the estimated time resolution at which the parameter determination can be made within the required precision (here 10% for Ti and the relative intensities of NB and RF emission components). It is shown that under the assumptions made, the thin-foil techniques out-perform the other spectroscopy techniques in practically all measurement situations. For thermal conditions, the range of achieved Δt in the determination of Ti varies in time scales from ms (for the magnetic and thin-foil proton recoil) to s (for gamma discriminating organic scintillator).
|
|
| 9. |
- Andersson Sundén, Erik, et al.
(författare)
-
Instrumentation for neutron emission spectrometry in use at JET
- 2010
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 623:2, s. 681-685
-
Tidskriftsartikel (refereegranskat)abstract
- The present contribution discusses two neutron spectrometers: the time-of-flight spectrometer (TOFOR) and the magnetic proton recoil spectrometer (MPRu). TOFOR uses fast plastic scintillators equipped with digital time-stamping electronics to register the time of each eligible scintillation event. The time trace for each detector is acquired practically dead-time free. The detectors of the MPRu are of phoswich type and each detector is connected to a digital transient recorder card that stores the full waveform for an event. By using phoswich detectors, pulse-shape discrimination techniques can be applied offline to distinguish signal events from background. A future upgrade of TOFOR could be digital “hybrid” cards, which store correlated time and waveform information. This information can be used to decrease the background level in the ttof spectrum, thereby increasing the operating range.
|
|
| 10. |
- Andersson Sundén, Erik, et al.
(författare)
-
The thin-foil magnetic proton recoil neutron spectrometer MPRu at JET
- 2009
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 610:3, s. 682-699
-
Tidskriftsartikel (refereegranskat)abstract
- Neutrons are produced in fusion energy experiments with both deuterium (D) and deuterium–tritium (DT) plasmas. Neutron spectroscopy is a valuable tool in the study of the underlying fuel ion populations. The magnetic proton recoil neutron spectrometer, originally installed at JET in 1996 for 14-MeV neutron measurements, has been upgraded, with the main aim of improving its signal-to-background ratio (S/B), making measurements of the 2.5-MeV neutron emission in D plasmas possible. The upgrade includes a new focal-plane detector, based on the phoswich technique and consequently less sensitive to background, and a new custom-designed digital data acquisition system based on transient recorder cards. Results from JET show that the upgraded MPRu can measure 2.5-MeV neutrons with S/B=5, an improvement by a factor of 50 compared with the original MPR. S/B of 2.8×104 in future DT experiments is estimated. The performance of the MPRu is exemplified with results from recent D plasma operations at JET, concerning both measurements with Ohmic, ion cyclotron resonance (ICRH) and neutral beam injection (NBI) plasma heating, as well as measurements of tritium burn-up neutrons. The upgraded instrument allows for 2.5-MeV neutron emission and deuterium ion temperature measurements in plasmas with low levels of tritium, a feature necessary for the ITER experiment.
|
|
