| 1. |
- Ericson, Marica, 1974, et al.
(författare)
-
Photodynamic therapy of actinic keratosis at varying fluence rates : Assessment of photobleaching, pain and primary clinical outcome
- 2004
-
Ingår i: British Journal of Dermatology. - : Oxford University Press (OUP). - 0007-0963 .- 1365-2133. ; 151, s. 1204-1212
-
Tidskriftsartikel (refereegranskat)abstract
- Background: Although photodynamic therapy (PDT) is becoming an important treatment method for skin lesions such as actinic keratosis (AK) and superficial basal cell carcinoma, there are still discussions about which fluence rate and light dose are preferable. Recent studies in rodents have shown that a low fluence rate is preferable due to depletion of oxygen at high fluence rates. However, these results have not yet been verified in humans. Objectives: The objective was to investigate the impact of fluence rate and spectral range on primary treatment outcome and bleaching rate in AK using aminolaevulinic acid PDT. In addition, the pain experienced by the patients has been monitored during treatment. Patients/methods Thirty-seven patients (mean age 71 years) with AK located on the head, neck and upper chest were treated with PDT, randomly allocated to four groups: two groups with narrow filter (580-650 nm) and fluence rates of 30 or 45 mW cm-2, and two groups with broad filter (580-690 nm) and fluence rates of 50 or 75 mW cm-2. The total cumulative light dose was 100 J cm-2 in all treatments. Photobleaching was monitored by fluorescence imaging, and pain experienced by the patients was registered by using a visual analogue scale graded from 0 (no pain) to 10 (unbearable pain). The primary treatment outcome was evaluated at a follow-up visit after 7 weeks. Results: Our data showed a significant correlation between fluence rate and initial treatment outcome, where lower fluence rate resulted in favourable treatment response. Moreover, the photo-bleaching dose (1/e) was found to be related to fluence rate, ranging from 4.5 ± 1.0 J cm -2 at 30 mW cm-2, to 7.3 ± 0.7 J cm-2 at 75 mW cm-2, indicating higher oxygen levels in tissue at lower fluence rates. After a cumulative light dose of 40 J cm-2 no further photobleaching took place, implying that higher doses are excessive. No significant difference in pain experienced by the patients during PDT was observed in varying the fluence rate from 30 to 75 mW cm-2. However, the pain was found to be most intense up to a cumulative light dose of 20 J cm-2. Conclusions: Our results imply that the photobleaching rate and primary treatment outcome are dependent on fluence rate, and that a low fluence rate (30 mW cm-2) seems preferable when performing PDT of AK using noncoherent light sources.
|
|
| 2. |
|
|
| 3. |
- Iregren, A, et al.
(författare)
-
Effects on the nervous system in different groups of workers exposed to aluminium
- 2001
-
Ingår i: Occupational and Environmental Medicine. ; 58, s. 453-60
-
Tidskriftsartikel (refereegranskat)abstract
- OBJECTIVE - To investigate possible neurotoxic effects in groups of aluminium pot room and foundry workers, aluminium welders, and a small group of workers exposed to aluminium in the production of flake powder.METHODS - Exposure to aluminium was evaluated with aluminium concentrations in blood and urine as well as a questionnaire. The groups exposed to aluminium were compared with a group of mild steel welders. Neurotoxic effects were studied with mood and symptom questionnaires and several psychological and neurophysiological tests.RESULTS - The pot room and foundry workers showed very low aluminium uptake as their aluminium concentrations in blood and urine were close to normal, and no effects on the nervous system were detected. The group of workers exposed to flake powder had high concentrations of aluminium in blood and urine, even higher than those of the aluminium welders. However, aluminium could not be shown to affect the functioning of the nervous system in flake powder producers. Although significant effects could not be shown in the present analysis of the data on welders, the performance of the welders exposed to high concentrations of aluminium was affected according to the analyses in the original paper from this group.CONCLUSIONS - For the pot room and foundry workers no effects related to the exposure to aluminium could be found. For the group of flake powder producers exposed for a short term no effects on the nervous systems were evident despite high levels of exposure. Due to the high concentrations of aluminium in the biological samples of this group, measures to reduce the exposure to aluminium are recommended, as effects on the central nervous system might develop after protracted exposures. However, this assumption needs to be verified in further studies.
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
- Engman, M., et al.
(författare)
-
Some design considerations of high density base metal tailings handling systems
- 2004
-
Ingår i: Proceedings of the 12th international conference on Transport & sedimentation of solid particles joined with 12th international symposium on Freight pipelines. - Prague : Institute of Hydrodynamics, Academy of Sciences of the Czech Republic. - 8023934651 ; , s. 307-318
-
Konferensbidrag (refereegranskat)
|
|
