| 1. |
- Bixby, H., et al.
(författare)
-
Rising rural body-mass index is the main driver of the global obesity epidemic in adults
- 2019
-
Ingår i: Nature. - : Springer Science and Business Media LLC. - 0028-0836 .- 1476-4687. ; 569:7755, s. 260-4
-
Tidskriftsartikel (refereegranskat)abstract
- Body-mass index (BMI) has increased steadily in most countries in parallel with a rise in the proportion of the population who live in cities(.)(1,2) This has led to a widely reported view that urbanization is one of the most important drivers of the global rise in obesity(3-6). Here we use 2,009 population-based studies, with measurements of height and weight in more than 112 million adults, to report national, regional and global trends in mean BMI segregated by place of residence (a rural or urban area) from 1985 to 2017. We show that, contrary to the dominant paradigm, more than 55% of the global rise in mean BMI from 1985 to 2017-and more than 80% in some low- and middle-income regions-was due to increases in BMI in rural areas. This large contribution stems from the fact that, with the exception of women in sub-Saharan Africa, BMI is increasing at the same rate or faster in rural areas than in cities in low- and middle-income regions. These trends have in turn resulted in a closing-and in some countries reversal-of the gap in BMI between urban and rural areas in low- and middle-income countries, especially for women. In high-income and industrialized countries, we noted a persistently higher rural BMI, especially for women. There is an urgent need for an integrated approach to rural nutrition that enhances financial and physical access to healthy foods, to avoid replacing the rural undernutrition disadvantage in poor countries with a more general malnutrition disadvantage that entails excessive consumption of low-quality calories.
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
- Bentham, James, et al.
(författare)
-
A century of trends in adult human height
- 2016
-
Ingår i: eLIFE. - 2050-084X. ; 5
-
Tidskriftsartikel (refereegranskat)abstract
- Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.522.7) and 16.5 cm (13.319.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries.
|
|
| 6. |
|
|
| 7. |
- Bentham, James, et al.
(författare)
-
A century of trends in adult human height
- 2016
-
Ingår i: eLIFE. - : eLife Sciences Publications Ltd. - 2050-084X. ; 5
-
Tidskriftsartikel (refereegranskat)abstract
- Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.5–22.7) and 16.5 cm (13.3– 19.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8– 144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries.
|
|
| 8. |
|
|
| 9. |
- Yusof, H. H. M., et al.
(författare)
-
Low-Cost Integrated Zinc Oxide Nanorods Based Humidity Sensors for Arduino Platform
- 2019
-
Ingår i: IEEE Sensors Journal. - : IEEE. - 1530-437X. ; 9:7, s. 2442-2449
-
Tidskriftsartikel (refereegranskat)abstract
- Realization of a simple integrated and low-cost intensity modulation/direct detection-based humidity and vapor detection system utilizing zinc oxide (ZnO) nanorods as the active material is demonstrated. The sensing device comprises of ZnO nanorods optimally grown on a glass substrate and mounted on 3D printed platform for the alignment with a green light-emitting diode setup for an edge excitation. An Arduino platform was used for the signal processing of the detection of the transmitted light. Both forward and backward scattering are affected due to light leakage while propagating through the glass substrate which are further attenuated in the presence of humidity. In this paper, backward scattering was found to be dominant, and thus, with increasing humidity, a reduction in the transmitted light was monitored. When the sensor was tested in a humidity controlled environment, it was found that the output voltage drops by approximately 750 mV upon changing the relative humidity (RH) level from 35% to 90% in a non-linear fashion. The average sensitivity of the sensor was observed to be-12 mV/% throughout the tested RH levels. Sensitivity was found to be higher at-24.6 mV/% for RH's beyond 70%. An average response time of 3.8 s was obtained for RH levels of 85% with respect to the standard ambient humidity conditions (RH 50%), which showed a quicker recovery time of 2.2 s. The proposed sensor device provides numerous advantages, including low-cost production, simplicity in design, ease of use, and stability during handling.
|
|
| 10. |
|
|
