| 1. |
|
|
| 2. |
|
|
| 3. |
- Liang, Z P, et al.
(författare)
-
Electrochemical study of the XNA on Gold (TM) microarray
- 2004
-
Ingår i: Biosensors & Bioelectronics. - : Elsevier BV. - 1873-4235 .- 0956-5663. ; 20:2, s. 211-216
-
Tidskriftsartikel (refereegranskat)abstract
- A novel electrode array was developed based on the XNA on Gold(TM) microarray platform. The platform combines self-assembling monolayers, thick film patterning and streptavidin based immobilization to provide a robust, versatile platform capable of analysing virtually any biomolecule including nucleic acids, proteins, carbohydrates and lipids. Electrochemical analysis of the self-assembling monolayer/streptavidin (SAMS) XNA on Gold(TM) coating revealed that the ferrocene redox current for the SAMS modified electrode was greater than that with a bare Gold(TM) electrode. The electrochemical reaction of K4Fe(CN)(6) was inhibited by the SAMS coating, but was reactivated upon addition of ferrocene. These results indicate that ferrocene is involved as a mediator in the electron transfer of K4Fe(CN)(6) to the SAMS modified electrode. Addition of DNA to the SAMS resulted in only a minor change in the electrochemical signal, indicating that XNA on Gold(TM) can be used for electrochemical based bioanalysis. After cycling a SAMS electrode 50 times, no signs of deterioration were detected showing that coating has excellent stability. In addition to the biosensing applications, the scheme provides a non-invasive method for accessing the quality of the SAMS coatings which is of industrial interest. These studies show that the XNA on Gold(TM) microarray platform can be used for electrochemical studies, thus providing an additional alternative for developing multianalyte biosensors as well as expanding the range of detection methods available for microarray analysis. (C) 2004 Elsevier B.V. All rights reserved.
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
- Fu, Q. X., et al.
(författare)
-
Doped ceria-chloride composite electrolyte for intermediate temperature ceramic membrane fuel cells
- 2002
-
Ingår i: Materials letters (General ed.). - 0167-577X .- 1873-4979. ; 53:3, s. 186-192
-
Tidskriftsartikel (refereegranskat)abstract
- A kind of oxide-salt composite electrolyte, gadolinium-doped ceria (GDC)-LiCl-SrCl2, prepared with hot-press technique, shows superior ionic conductivity, which is 2-10 times higher than that of GDC itself at the temperature range of 400-600 degreesC. More interestingly, not like the GDC electrolyte, which has some extent of electronic conduction under reducing atmosphere, the composite electrolyte is almost a pure ionic conductor, evidenced by the fuel cell's (FC) open circuit voltage (OCV) close to the theoretical one. The fuel cells based on this composite electrolyte show excellent power density output even at temperature as low as 500 degreesC (240 mW cm(-2)) in spite of the relatively thick electrolyte (0.4 mm). Such high performance, in combination with its low cost in both raw materials and fabrication process, make this kind of composite electrolyte a good candidate electrolyte material for future ultra-low-cost intermediate temperature ceramic membrane fuel cells (IT-CMFCs).
|
|
| 7. |
- Fu, Q. X., et al.
(författare)
-
Intermediate temperature fuel cells based on doped ceria-LiCl-SrCl2 composite electrolyte
- 2002
-
Ingår i: Journal of Power Sources. - 0378-7753 .- 1873-2755. ; 104:1, s. 73-78
-
Tidskriftsartikel (refereegranskat)abstract
- A new type of oxide-salt composite electrolyte, gadolinium-doped ceria (GDC)-LiCl-SrCl2, was developed and demonstrated its promising use for intermediate temperature (400-700 degreesC) fuel cells (ITFCs). The dc electrical conductivity of this composite electrolyte (0.09-0.13 S cm(-1) at 500-650 degreesC) was 3-10 times higher than that of the pure GDC electrolyte, indicating remarkable proton or oxygen ion conduction existing in the LiCl-SrCl2 chloride salts or at the interface between GDC and the chloride salts. Using this composite electrolyte, peak power densities of 260 and 510 mW cm(-2), with current densities of 650 and 1250 mA cm(-2) were achieved at 550 and 625 degreesC, respectively. This makes the new material a good candidate electrolyte for future low-cost ITFCs.
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
|
|
