Sökning: WFRF:(Zhang Yihao)
> (2024) >
Effect of non-axisy...
Effect of non-axisymmetric endwall contouring and swirling inlet flow on film cooling performance of turbine endwall
-
- Du, Kun (författare)
- Northwestern Polytechnic University
-
- Zhang, Rongxia (författare)
- Northwestern Polytechnic University
-
- Jia, Yihao (författare)
- Northwestern Polytechnic University
-
visa fler...
-
- Liu, Cunliang (författare)
- Northwestern Polytechnic University
-
- Sunden, Bengt (författare)
- Lund University,Lunds universitet,Värmeöverföring,Institutionen för energivetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Heat Transfer,Department of Energy Sciences,Departments at LTH,Faculty of Engineering, LTH
-
visa färre...
-
(creator_code:org_t)
- 2024
- 2024
- Engelska.
-
Ingår i: International Journal of Heat and Mass Transfer. - 0017-9310. ; 229
- Relaterad länk:
-
http://dx.doi.org/10...
-
visa fler...
-
https://lup.lub.lu.s...
-
https://doi.org/10.1...
-
visa färre...
Abstract
Ämnesord
Stäng
- Non-axisymmetric endwall contouring (NEC) is one of the verified approaches to suppress secondary flows and improve aerodynamic performance. However, the design of NEC brings significant challenges to the design of endwall cooling structures. Herein, a pressure-sensitive paint experimental approach was used to obtain the film cooling effectiveness of the NEC endwall with a purge slot in this study. Three NEC types were adopted: NEC (COS), NEC (SIN), and NEC (−SIN). In addition, lean premixed combustion technology was used to achieve lower levels of NOx emissions. The turbine inlet was characterized by high turbulence and strong swirling. The effects of different swirling angles (±10, ±20, and ±30°) and densities were further explored. Due to the NEC profiling changing the secondary flow near the endwall area, coolant from the purge slot was better attached to the slot exit position, leading to a significant increase in the size of the high-cooling-efficiency region. With the mass flow ratio (MFR) varying from 0.5 to 2%, the film cooling effectiveness of the flat and NEC endwalls had similar variation characteristics. When the MFR = 0.5%, the area-averaged cooling efficiencies of the NEC (COS), NEC (SIN), and NEC (−SIN) endwalls could be improved by 2, 12.5, and 20%, respectively. Positive swirling and smaller negative swirling inflow could improve the film cooling effectiveness inside the channel. The case of SA = +20° had the best improvement, where the film cooling effectiveness of the NEC (COS), NEC (SIN), and NEC (−SIN) endwalls could reach up to 29, 35, 36, and 34%, respectively. The NEC (−SIN) endwall was less sensitive to the effects of the swirling inflow.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Maskinteknik -- Strömningsmekanik och akustik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Mechanical Engineering -- Fluid Mechanics and Acoustics (hsv//eng)
Nyckelord
- Gas Turbine
- Non-axisymmetric endwall
- PSP measurement
- Slot purge film cooling
- Swirling inlet flow
Publikations- och innehållstyp
- art (ämneskategori)
- ref (ämneskategori)
Hitta via bibliotek
Till lärosätets databas