1. |
- Nahalka, J, et al.
(författare)
-
Elicitation of plumbagin by chitin and its release into the medium in Drosophyllum lusitanicum Link. suspension cultures
- 1998
-
Ingår i: Biotechnology letters. - 0141-5492 .- 1573-6776. ; 20:9, s. 841-845
-
Tidskriftsartikel (refereegranskat)abstract
- Polysaccharides (chitin/pectin) that are involved in the interactions between plants and microorganisms were applied to the cultured cells of Drosophyllum lusitanicum. In the case of chitin addition, elicitation and crystallization of plumbagin in the medium were observed. N-Acetylchitooligosaccharides smaller than heptamers [(GlcNAc)(n) (n<7)] elicited the biosynthesis of plumbagin but did not increase the hypersensitive response (HR). On the other hand, carboxymethylchitin (DP similar to 200) led to the accumulation of plumbagin in cells and to HR death as well as to the lysis of the cells and release of plumbagin into the medium. The response of cultured cells to the N-Acetylchitosaccharides varied depending on the chemo/physiological conditions of the cells. Addition of pectin (1 g/l) resulted in enhanced HR and decreased biosynthesis of plumbagin.
|
|
2. |
|
|
3. |
- Undeland, Ingrid, 1968, et al.
(författare)
-
Comparison between methods using low-toxicity solvents for the extraction of lipids from herring (Clupea harengus)
- 1998
-
Ingår i: Food Chemistry. - 0308-8146 .- 1873-7072 .- 0346-718X. ; 61:3, s. 355-365
-
Tidskriftsartikel (refereegranskat)abstract
- Three alkane/alcohol/water-based lipid extraction systems were evaluated to determine which would be the best replacement for the frequently used chloroform/methanol/water system, nowadays known to be very toxic. All the methods were applied to samples of minced herring (Clupea harengus) differing in quality and composition. In addition to comparisons of total lipid yield, the extracted lipids were compared with respect to content of triglycerides, phospholipids, free fatty acids, ?-tocopherol, lipid hydroperoxides and conjugated dienes. The content of phospholipids was found to differ most between the lipids extracted by the four methods. Here, the chloroform/methanol/water system was the most efficient, followed by heptane/ethanol/water/sodium dodecyl sulphate (SDS) and then iso-propanol/hexane. However, by decreasing the level of SDS, the efficiency of the heptane/ethanol/water/SDS system in extracting phospholipids was increased to the same level as that of the chloroform/methanol/water system. This decrease in SDS also resulted in a higher recovery of free fatty acids. The lack of correlation between yields of phospholipids and yields of lipid oxidation products throughout this study was surprising because of the often-described susceptibility of phospholipids to oxidation.
|
|
4. |
|
|
5. |
|
|
6. |
|
|
7. |
|
|
8. |
- Marklund, S, et al.
(författare)
-
Molecular basis for the dominant white phenotype in the domestic pig.
- 1998
-
Ingår i: Genome research. - 1088-9051. ; 8:8, s. 826-33
-
Tidskriftsartikel (refereegranskat)abstract
- The change of phenotypic traits in domestic animals and crops as a response to selective breeding mimics the much slower evolutionary change in natural populations. Here, we describe that the dominant white phenotype in domestic pigs is caused by two mutations in the KIT gene encoding the mast/stem cell growth factor receptor (MGF), one gene duplication associated with a partially dominant phenotype and a splice mutation in one of the copies leading to the fully dominant allele. The splice mutation is a G to A substitution in the first nucleotide of intron 17 and leads to skipping of exon 17. The duplication is most likely a regulatory mutation affecting KIT expression, whereas the splice mutation is expected to cause a receptor with impaired or absent tyrosine kinase activity. Immunocytochemistry showed that this variant form is expressed in 17- to 19-day-old pig embryos. Hundreds of millions of white pigs around the world are assumed to be heterozygous or homozygous for the two mutations. [The EMBL accession numbers for porcine KIT1*0101, KIT1*0202, KIT2*0202, and KIT2*0101 are AJ223228-AJ223231, respectively.]
|
|