| 11. |
- Aaboud, M., et al.
(författare)
-
Measurement of the relative Bc± /B± production cross section with the ATLAS detector at s =8 TeV MEASUREMENT of the RELATIVE Bc± /B± ... AABOUD M. et al.
- 2021
-
Ingår i: Physical Review D. - 2470-0010. ; 104:1
-
Tidskriftsartikel (refereegranskat)abstract
- The total cross section and differential cross sections for the production of Bc± mesons, times their branching fraction to J/ψπ±, are measured relative to those for the production of B± mesons, times their branching fraction to J/ψK±. The data used for this study correspond to an integrated luminosity of 20.3 fb-1 of pp collisions recorded by the ATLAS detector at the Large Hadron Collider in 2012 at a center-of-mass energy of s=8 TeV. The measurement is performed differentially in bins of transverse momentum pT for 13 GeV22 GeV and in bins of rapidity y for |y|13 GeV and |y|
|
|
| 12. |
- Aacharya, Ananta, et al.
(författare)
-
Development of a novel solar dryer with an incorporated heat exchanger
- 2024
-
Ingår i: Solar Energy. - 0038-092X. ; 269
-
Tidskriftsartikel (refereegranskat)abstract
- This study analyzes the thermal performance of an indirect-type solar dryer incorporated with a heat exchanger to recover heat from the exhaust. Data were recorded for 8 h from 9:00 to 17:00 from November to January to determine the drying rate for varying airflows from 2 l/s to 12 l/s under the weather conditions of Nepal and Bhutan. The air temperatures in multiple locations in the dryer were recorded and logged for 30-second intervals. The results indicated that incorporating a simple heat exchanger can achieve 78 % and 81 % effectiveness for the lowest tested airflow of 2.5 l/s and 2 l/s in Nepal and Bhutan. The heat transfer effectiveness increases with decreasing flow, resulting in a higher cold side outlet temperature of the heat exchanger for lower airflows. The solar air collector demonstrated efficient performance, achieving 80 % and 90 % efficiencies for the highest tested airflows of 12 l/s and 10 l/s in Nepal and Bhutan, respectively. Due to an increased heat transfer coefficient, the incoming air can effectively remove the accumulated heat from the absorber plate for higher airflows. The drying rates were observed to be the highest for 12 l/s, with a value of 85 g/(h × m2) for apples and 10 l/s, with a value of 56 g/(h × m2) for gingers in Nepal and Bhutan, respectively. From both cases, it can be concluded that the highest tested airflows provide higher air circulation for effective heat and mass transfer from the product to the surrounding air for drying.
|
|
| 13. |
- Aad, G, et al.
(författare)
-
Alignment of the ATLAS Inner Detector in Run 2
- 2020
-
Ingår i: European Physical Journal C. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 80:12
-
Tidskriftsartikel (refereegranskat)abstract
- The performance of the ATLAS Inner Detector alignment has been studied using pp collision data at s=13TeV collected by the ATLAS experiment during Run 2 (2015–2018) of the Large Hadron Collider (LHC). The goal of the detector alignment is to determine the detector geometry as accurately as possible and correct for time-dependent movements. The Inner Detector alignment is based on the minimization of track-hit residuals in a sequence of hierarchical levels, from global mechanical assembly structures to local sensors. Subsequent levels have increasing numbers of degrees of freedom; in total there are almost 750,000. The alignment determines detector geometry on both short and long timescales, where short timescales describe movements within an LHC fill. The performance and possible track parameter biases originating from systematic detector deformations are evaluated. Momentum biases are studied using resonances decaying to muons or to electrons. The residual sagitta bias and momentum scale bias after alignment are reduced to less than ∼0.1TeV-1 and 0.9 × 10 - 3, respectively. Impact parameter biases are also evaluated using tracks within jets. © 2020, The Author(s).
|
|
| 14. |
- Aad, G., et al.
(författare)
-
Anomaly detection search for new resonances decaying into a Higgs boson and a generic new particle X in hadronic final states using √s=13 TeV pp collisions with the ATLAS detector
- 2023
-
Ingår i: Physical Review D. - : AMER PHYSICAL SOC. - 2470-0010 .- 2470-0029. ; 108:5
-
Tidskriftsartikel (refereegranskat)abstract
- A search is presented for a heavy resonance Y decaying into a Standard Model Higgs boson H and a new particle X in a fully hadronic final state. The full Large Hadron Collider run 2 dataset of proton-proton collisions at √s=13 TeV collected by the ATLAS detector from 2015 to 2018 is used and corresponds to an integrated luminosity of 139 fb−1. The search targets the high Y-mass region, where the H and X have a significant Lorentz boost in the laboratory frame. A novel application of anomaly detection is used to define a general signal region, where events are selected solely because of their incompatibility with a learned background-only model. It is constructed using a jet-level tagger for signal-model-independent selection of the boosted X particle, representing the first application of fully unsupervised machine learning to an ATLAS analysis. Two additional signal regions are implemented to target a benchmark X decay into two quarks, covering topologies where the X is reconstructed as either a single large-radius jet or two small-radius jets. The analysis selects Higgs boson decays into , and a dedicated neural-network-based tagger provides sensitivity to the boosted heavy-flavor topology. No significant excess of data over the expected background is observed, and the results are presented as upper limits on the production cross section for signals with mY between 1.5 and 6 TeV and mX between 65 and 3000 GeV.
|
|
| 15. |
- Aad, G, et al.
(författare)
-
Association with Lepton Pairs Produced via the Photon Fusion Mechanism at ATLAS
- 2020
-
Ingår i: Physical Review Letters. - 1079-7114. ; 125
-
Tidskriftsartikel (refereegranskat)abstract
- The observation of forward proton scattering in association with lepton pairs (e+e−+p or μ+μ−+p) produced via photon fusion is presented. The scattered proton is detected by the ATLAS Forward Proton spectrometer, while the leptons are reconstructed by the central ATLAS detector. Proton-proton collision data recorded in 2017 at a center-of-mass energy of √s=13 TeV are analyzed, corresponding to an integrated luminosity of 14.6 fb−1. A total of 57 (123) candidates in the ee+p (μμ+p) final state are selected, allowing the background-only hypothesis to be rejected with a significance exceeding 5 standard deviations in each channel. Proton-tagging techniques are introduced for cross-section measurements in the fiducial detector acceptance, corresponding to σee+p=11.0±2.6(stat)±1.2(syst)±0.3(lumi) and σμμ+p=7.2±1.6(stat)±0.9(syst)±0.2(lumi) fb in the dielectron and dimuon channel, respectively.
|
|
| 16. |
- Aad, G, et al.
(författare)
-
ATLAS data quality operations and performance for 2015-2018 data-taking
- 2020
-
Ingår i: Journal of Instrumentation. - : Institute of Physics Publishing (IOPP). - 1748-0221. ; 15:4
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS detector at the Large Hadron Collider reads out particle collision data from over 100 million electronic channels at a rate of approximately 100 kHz, with a recording rate for physics events of approximately 1 kHz. Before being certified for physics analysis at computer centres worldwide, the data must be scrutinised to ensure they are clean from any hardware or software related issues that may compromise their integrity. Prompt identification of these issues permits fast action to investigate, correct and potentially prevent future such problems that could render the data unusable. This is achieved through the monitoring of detector-level quantities and reconstructed collision event characteristics at key stages of the data processing chain. This paper presents the monitoring and assessment procedures in place at ATLAS during 2015-2018 data-taking. Through the continuous improvement of operational procedures, ATLAS achieved a high data quality efficiency, with 95.6% of the recorded proton-proton collision data collected at s=13 TeV certified for physics analysis.
|
|
| 17. |
- Aad, G., et al.
(författare)
-
ATLAS flavour-tagging algorithms for the LHC Run 2 pp collision dataset
- 2023
-
Ingår i: European Physical Journal C. - : Institute for Ionics. - 1434-6044 .- 1434-6052. ; 83:7
-
Tidskriftsartikel (refereegranskat)abstract
- The flavour-tagging algorithms developed by the ATLAS Collaboration and used to analyse its dataset of √s=13 TeV pp collisions from Run 2 of the Large Hadron Collider are presented. These new tagging algorithms are based on recurrent and deep neural networks, and their performance is evaluated in simulated collision events. These developments yield considerable improvements over previous jet-flavour identification strategies. At the 77% b-jet identification efficiency operating point, light-jet (charm-jet) rejection factors of 170 (5) are achieved in a sample of simulated Standard Model events; similarly, at a c-jet identification efficiency of 30%, a light-jet (b-jet) rejection factor of 70 (9) is obtained.
|
|
| 18. |
- Aad, G., et al.
(författare)
-
Calibration of the light-flavour jet mistagging efficiency of the b-tagging algorithms with Z+jets events using 139 fb−1 of ATLAS proton–proton collision data at √s=13 TeV
- 2023
-
Ingår i: European Physical Journal C. - : Institute for Ionics. - 1434-6044 .- 1434-6052. ; 83:8
-
Tidskriftsartikel (refereegranskat)abstract
- The identification of b-jets, referred to as b-tagging, is an important part of many physics analyses in the ATLAS experiment at the Large Hadron Collider and an accurate calibration of its performance is essential for high-quality physics results. This publication describes the calibration of the light-flavour jet mistagging efficiency in a data sample of proton–proton collision events at √s=13 TeV corresponding to an integrated luminosity of 139 fb−1. The calibration is performed in a sample of Z bosons produced in association with jets. Due to the low mistagging efficiency for light-flavour jets, a method which uses modified versions of the b-tagging algorithms referred to as flip taggers is used in this work. A fit to the jet-flavour-sensitive secondary-vertex mass is performed to extract a scale factor from data, to correct the light-flavour jet mistagging efficiency in Monte Carlo simulations, while simultaneously correcting the b-jet efficiency. With this procedure, uncertainties coming from the modeling of jets from heavy-flavour hadrons are considerably lower than in previous calibrations of the mistagging scale factors, where they were dominant. The scale factors obtained in this calibration are consistent with unity within uncertainties.
|
|
| 19. |
- Aad, G, et al.
(författare)
-
Combination of searches for Higgs boson pairs in pp collisions at s=13TeV with the ATLAS detector
- 2020
-
Ingår i: Physics Letters, Section B: Nuclear, Elementary Particle and High-Energy Physics. - : Elsevier BV. - 0370-2693 .- 1873-2445. ; 800
-
Tidskriftsartikel (refereegranskat)abstract
- This letter presents a combination of searches for Higgs boson pair production using up to 36.1 fb−1 of proton–proton collision data at a centre-of-mass energy s=13 TeV recorded with the ATLAS detector at the LHC. The combination is performed using six analyses searching for Higgs boson pairs decaying into the bb¯bb¯, bb¯W+W−, bb¯τ+τ−, W+W−W+W−, bb¯γγ and W+W−γγ final states. Results are presented for non-resonant and resonant Higgs boson pair production modes. No statistically significant excess in data above the Standard Model predictions is found. The combined observed (expected) limit at 95% confidence level on the non-resonant Higgs boson pair production cross-section is 6.9 (10) times the predicted Standard Model cross-section. Limits are also set on the ratio (κλ) of the Higgs boson self-coupling to its Standard Model value. This ratio is constrained at 95% confidence level in observation (expectation) to −5.0
|
|
| 20. |
|
|
