| 21. |
- Baveja, P. P., et al.
(författare)
-
Impact of photon lifetime on thermal rollover in 850-nm high-speed VCSELs
- 2012
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819489197 ; 8276
-
Konferensbidrag (refereegranskat)abstract
- We present an empirical thermal model for VCSELs based on extraction of temperature dependence of macroscopic VCSEL parameters from CW measurements. We apply our model to two, oxide-confined, 850-nm VCSELs, fabricated with a 9-mu m inner-aperture diameter and optimized for high-speed operation. We demonstrate that for both these devices, the power dissipation due to linear heat sources dominates the total self-heating. We further show that reducing photon lifetime down to 2 ps drastically reduces absorption heating and improves device static performance by delaying the onset of thermal rollover. The new thermal model can identify the mechanisms limiting the thermal performance and help in formulating the design strategies to ameliorate them.
|
|
| 22. |
- Davani, Hooman A., et al.
(författare)
-
Polarization investigation of a tunable high-speed short-wavelength bulk-micromachined MEMS-VCSEL
- 2012
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819489197 ; 8276, s. Art. no. 82760T-
-
Konferensbidrag (refereegranskat)abstract
- We report the investigation of the state of polarization (SOP) of a tunable vertical-cavity surface-emitting laser (VCSEL) operating near 850 nm with a mode-hop free single-mode tuning range of about 12 nm and an amplitude modulation bandwidth of about 5 GHz. In addition, the effect of a sub-wavelength grating on the device and its influence on the polarization stability and polarization switching has been investigated. The VCSEL with an integrated sub-wavelength grating shows a stable SOP with a polarization mode suppression ratio (PMSR) more than 35 dB during the tuning.
|
|
| 23. |
- Gierl, Christian, et al.
(författare)
-
Tuneable VCSEL aiming for the application in interconnects and short haul systems
- 2011
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819484963 ; 7959
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
- Widely tunable vertical cavity surface emitting lasers (VCSEL) are of high interest for optical communications, gas spectroscopy and fiber-Bragg-grating measurements. In this paper we present tunable VCSEL operating at wavelength around 850 nm and 1550 nm with tuning ranges up to 20 nm and 76 nm respectively. The first versions of VCSEL operating at 1550 nm with 76 nm tuning range and an output power of 1.3mW were not designed for high speed modulation, but for applications where only stable continious tuning is essential (e.g. gas sensing). The next step was the design of non tunable VCSEL showing high speed modulation frequencies of 10 GHz with side mode supression ratios beyond 50 dB. The latest version of these devices show record output powers of 6.7mW at 20 °C and 3mW at 80 °C. The emphasis of our present and future work lies on the combination of both technologies. The tunable VCSEL operating in the 850 nm-region reaches a modulation bandwidth of 5.5GHz with an output power of 0.8mW.
|
|
| 24. |
- Gustavsson, Johan, 1974, et al.
(författare)
-
High-speed 850-nm VCSELs for 40 Gb/s transmission
- 2010
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
- We have explored the possibility to extend the data transmission rate for standard 850-nm GaAs-based VCSELs beyond the 10 Gbit/s limit of today's commercially available directly-modulated devices. By sophisticated tailoring of the design for high-speed performance we demonstrate that 10 Gb/s is far from the upper limit. For example, the thermal conductivity of the bottom mirror is improved by the use of binary compounds, and the electrical parasitics are kept at a minimum by incorporating a large diameter double layered oxide aperture in the design. We also show that the intrinsic high speed performance is significantly improved by replacing the traditional GaAs QWs with strained InGaAs QWs in the active region. The best overall performance is achieved for a device with a 9 μm diameter oxide aperture, having in a threshold current of 0.6 mA, a maximum output power of 9 mW, a thermal resistance of 1.9 °C/mW, and a differential resistance of 80 Ω. The measured 3dB bandwidth exceeds 20 GHz, and we experimentally demonstrate that the device is capable of error-free transmission (BER
|
|
| 25. |
- Hashemi, Seyed Ehsan, 1986, et al.
(författare)
-
Analysis of structurally sensitive loss in GaN-based VCSEL cavities and its effect on modal discrimination
- 2014
-
Ingår i: Optics Express. - 1094-4087 .- 1094-4087. ; 22:1, s. 411-426
-
Tidskriftsartikel (refereegranskat)abstract
- Lateral loss causes optical energy to leave the laser cavity in the transverse, lateral, direction, and is sometimes neglected to simplify the numerical simulations. However, in contrast to outcoupling and absorption losses, we show that the lateral loss can change drastically with only nanometer-sized changes of the cavity structure, from being virtually zero to becoming the major source of cavity loss, since the cavity becomes antiguiding. This can be explained as the opening of a channel of efficient resonant lateral leakage of optical power at a certain oblique propagation angle. A number of different realizations of current apertures and top mirror designs in GaN-based VCSEL cavities, which have been suggested for realization of microcavity lasers emitting in the blue wavelength range, are simulated. Many of these are shown to lead to unintentional antiguiding, which can more than double the threshold gain for lasing. Notably, for strong enough antiguiding the resonant lateral leakage decreases so that the threshold gain values might again be tolerable. This regime has been suggested for robust single-mode operation since earlier predictions, building on analogies with slab waveguides, hinted at a very strong suppression of higher order modes. However, our simulations indicate that for the VCSEL cavities the derived formulas grossly overestimate the modal discrimination.
|
|
| 26. |
- Hashemi, Seyed Ehsan, 1986, et al.
(författare)
-
Engineering the Lateral Optical Guiding in Gallium Nitride (GaN)-based Vertical-Cavity Surface-Emitting Laser (VCSEL) Cavities to Reach the Lowest Threshold Gain
- 2013
-
Ingår i: Japanese Journal of Applied Physics. - 1347-4065 .- 0021-4922. ; 52:8 PART 2, s. 08JG04 -
-
Tidskriftsartikel (refereegranskat)abstract
- In order to improve the current injection in GaN-based blue vertical-cavity surface-emitting lasers (VCSELs) a dielectric aperture is generally used in combination with an indium–tin-oxide (ITO) layer on the top intracavity p-contact layer. The most straightforward way to realize this introduces a depression of the structure near the optical axis and we show, by using a two-dimensional (2D) effective index method and a three-dimensional (3D) coupled-cavity beam propagation method, that this typically results in optically anti-guided structures with associated high optical losses and thus very high threshold gains. Remarkably, the threshold gain reduces with increased negative guiding, which is due to improved lateral confinement and reduction of lateral leakage. Still, moderately positively guided designs should be preferred to avoid the detrimental effect of lateral leakage and high diffraction loss. To ensure positive index guiding, we propose to planarize the structure or introduce an elevation near the optical axis by additional processing, with an associated reduction in threshold material gain from 6000 to 2000 cm-1 for the studied structures.
|
|
| 27. |
- Hashemi, Seyed Ehsan, 1986, et al.
(författare)
-
Engineering the transverse optical guiding in GaN-based VCSELs to avoid detrimental optical loss
- 2012
-
Ingår i: International Workshop on Nitride Semiconductors 2012, October 14-19, 2012, Sapporo, Japan, p. ThP-OD-33.
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
- In order to improve the current injection in GaN-based blue vertical cavity surface emitting lasers (VCSELs) a dielectric aperture is generally used in combination with an indium-tin-oxide (ITO) layer on the top intracavity p-contact layer. The most straightforward way to realize this introduces a depression of the structure near the optical axis and we show, by using a 2D effective index method and a 3D coupled-cavity beam propagation method, that this typically results in optically anti-guided structures with associated high optical losses and thus very high threshold gains. Remarkably, the threshold gain reduces with increased negative guiding, which is due to improved lateral confinement and reduction of lateral leakage. Still, moderately positively guided designs should be preferred to avoid the detrimental effect of lateral leakage and high diffraction loss. To ensure positive index guiding, we propose to planarize the structure or introduce an elevation near the optical axis by additional processing, with an associated reduction in threshold material gain from 6000 cm-1 to 2000 cm-1 for the studied structures.
|
|
| 28. |
- Hashemi, Seyed Ehsan, 1986, et al.
(författare)
-
Triggering of guiding and antiguiding effects in GaN-based VCSELs
- 2014
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. ; 9001
-
Konferensbidrag (refereegranskat)abstract
- We show numerically that many recently proposed GaN-based VCSEL cavities, with DBR mirrors deposited onto the current aperture, balance dangerously close to the border between the guided and antiguided regime. A guided cavity is often preferred because of its lower optical loss, but a strongly antiguided cavity offers built-in modal discrimination favoring single fundamental mode operation. We show that very small changes in the VCSEL structure are sufficient to strongly change the guiding character of the VCSEL cavity, and that thermal lensing caused by device self-heating under operation can dramatically reduce the optical loss but not the modal discrimination in the antiguided cavities.
|
|
| 29. |
- Healy, S. B., et al.
(författare)
-
Active Region Design for High-Speed 850-nm VCSELs
- 2010
-
Ingår i: IEEE Journal of Quantum Electronics. - 0018-9197 .- 1558-1713. ; 46:4, s. 506-512
-
Tidskriftsartikel (refereegranskat)abstract
- Higher speed short-wavelength (850 nm) VCSELs are required for future high-capacity, short-reach data communication links. The modulation bandwidth of such devices is intrinsically limited by the differential gain of the quantum wells (QWs) used in the active region. We present gain calculations using an 8-band k.p Hamiltonian which show that the incorporation of 10% In in an InGaAs/AlGaAs QW structure can approximately double the differential gain compared to a GaAs/AlGaAs QW structure, with little additional improvement achieved by further increasing the In composition in the QW. This improvement is confirmed by extracting the differential gain value from measurements of the modulation response of VCSELs with optimized InGaAs/AlGaAs QW and conventional GaAs/AlGaAs QW active regions. Excellent agreement is obtained between the theoretically and experimentally determined values of the differential gain, confirming the benefits of strained InGaAs QW structures for high-speed 850-nm VCSEL applications.
|
|
| 30. |
- Ingham, J.D., et al.
(författare)
-
32 Gb/s multilevel modulation of an 850 nm VCSEL for next-generation datacommunication standards
- 2011
-
Ingår i: 2011 Conference on Lasers and Electro-Optics, CLEO 2011; Baltimore, MD; 1 May 2011 through 6 May 2011. - Washington, D.C. : OSA. - 2162-2701. - 9781557529107
-
Konferensbidrag (refereegranskat)abstract
- An 850 nm vertical-cavity surface-emitting laser is modulated at 32 Gb/s using pulseamplitude modulation with four levels. Transmitter predistortion generates an optimized modulation waveform, which requires a receiver bandwidth of only 15 GHz.
|
|
