| 1. |
- Abidakun, Olatunde, et al.
(författare)
-
Impacts of fuel nonequidiffusivity on premixed flame propagation in channels with open ends
- 2021
-
Ingår i: Physics of fluids. - : American Institute of Physics (AIP). - 1070-6631 .- 1089-7666. ; 33
-
Tidskriftsartikel (refereegranskat)abstract
- The present study scrutinizes premixed flame dynamics in micro-channels, thereby shedding light on advanced miniature micro-combustion technologies. While equidiffusive burning (when the Lewis number Le = 1) is a conventional approach adopted in numerous theoretical studies, real premixed flames are typically non-equidiffusive (Le ≠ 1), which leads to intriguing effects, such as diffusional-thermal instability. An equidiffusive computational study [V. Akkerman et al., Combust. Flame 145, 675–687 (2006)] reported regular oscillations of premixed flames spreading in channels having nonslip walls and open extremes. Here, this investigation is extended to nonequidiffusive combustion in order to systematically study the impact of the Lewis number on the flame in this geometry. The analysis is performed by means of computational simulations of the reacting flow equations with fully-compressible hydrodynamics and onestep Arrhenius chemical kinetics in channels with adiabatic and isothermal walls. In the adiabatic channels, which are the main case of study, it is found that the flames oscillate at low Lewis numbers, with the oscillation frequency decreasing with Le, while for the Le > 1 flames, a tendency to steady flame propagation is observed. The oscillation parameters also depend on the thermal expansion ratio and the channel width, although the impacts are rather quantitative than qualitative. The analysis is subsequently extended to the isothermal channels. It is shown that the role of heat losses to the walls is important and may potentially dominate over that of the Lewis number. At the same time, the impact of Le on burning in the isothermal channels is qualitatively weaker than that in the adiabatic channels.
|
|
| 2. |
- Chen, Canruo, et al.
(författare)
-
On the stabilization mechanism of high-speed deflagrations in narrow channels with heat loss
- 2024
-
Ingår i: Proceedings of the Combustion Institute. - : Elsevier. - 1540-7489 .- 1873-2704. ; 40:1-4
-
Tidskriftsartikel (refereegranskat)abstract
- Statistically steady supersonic deflagrations are numerically investigated in narrow channels with strong thermal expansion and heat loss. Four modes of flame propagation are observed, namely, extinction, low-speed deflagration, high-speed deflagration, and DDT. It is determined that larger thermal expansion facilitates initiation of high-speed deflagrations while the heat loss can suppress the transition to detonation. The high-speed deflagration mode is shown to be the result of the dynamic balance between thermal expansion and wall heat loss. The limits of high-speed deflagration in terms of the thermal expansion and heat loss coefficients are determined. The statistically steady oscillatory high-speed deflagrations propagate at average velocities close to half of the CJ detonation velocity. The dynamics of the flame front and shock waves are visualized using numerical schlieren. Periodic acceleration and deceleration of the leading shock are identified, and the mechanism of DDT suppression is elucidated.
|
|
| 3. |
- Dion, Claude, et al.
(författare)
-
Dynamics of flame extinction in narrow channels with cold walls: Heat loss vs acceleration
- 2021
-
Ingår i: Physics of Fluids. - : AIP Publishing. - 1070-6631 .- 1089-7666. ; 33:3
-
Tidskriftsartikel (refereegranskat)abstract
- Propagation of a premixed flame from a closed to an open end in micro-channels with smooth non-slip isothermal walls is considered in the context of flame extinction dynamics. Powerful exponential flame acceleration in micro-channels with adiabatic walls has been demonstrated at the initial quasi-isobaric stage of the process [Bychkov et al., Phys. Rev. E 72, 046307 (2005)]. In contrast to the previous studies, here we investigate flame propagation in channels with isothermal walls. The problem is solved by means of high-fidelity laminar numerical simulations of the complete set of the Navier-Stokes combustion equations. For most of the problem parameter sets chosen, we obtain initial flame acceleration after ignition at the closed channel end. This acceleration resembles qualitatively the adiabatic case, but it develops noticeably slower, in an approximately linear regime instead of the exponential one and persists only for a limited time interval. Subsequently, heat loss to the walls reduces the temperature and hence the volume of the burnt gas behind the flame front, which produces a reverse flow in the direction of the closed channel end. When the amount of the burnt gas becomes sufficiently large, the reverse flow stops the acceleration process and drives the flame backwards with modifications of the flame front shape from convex to concave. Eventually, the flame extinguishes. Qualitatively, the process obtained reproduces a possible combustion failure during deflagration-to-detonation transition observed in previous experiments. We investigate the key characteristics of initial flame acceleration such as the acceleration rate and the maximum speed of the flame tip.
|
|
| 4. |
- Feng, Ruixue, et al.
(författare)
-
Influence of gas expansion on the propagation of a premixed flame in a spatially periodic shear flow
- 2021
-
Ingår i: Combustion and Flame. - : Elsevier. - 0010-2180 .- 1556-2921. ; 227, s. 421-427
-
Tidskriftsartikel (refereegranskat)abstract
- It has been previously demonstrated that thermal gas expansion might have a role in boundary layer flashback of premixed turbulent flames [Gruber et al., J Fluid Mech 2012], inducing local flow-reversal in the boundary layer's low-velocity streaks on the reactants’ side of the flame and facilitating its upstream propagation. We perform a two-dimensional numerical investigation of the interaction between a periodic shear flow and a laminar premixed flame. The periodic shear is a simplified model for the oncoming prolonged streamwise velocity streaks with alternating regions of high and low velocities found in turbulent boundary layers in the vicinity of the walls. The parametric study focuses on the amplitude and wavelength of the periodic shear flow and on the gas expansion ratio (unburnt-to-burnt density ratio). With the increase of the amplitudes of the periodic shear flow and of the gas expansion, the curved flame velocity increases monotonically. The flame velocity dependence on the periodic shear wavelength is non-monotonic, which is consistent with previous theoretical studies of curved premixed flame velocity. The flame shape that is initially formed by the oncoming periodic shear appears to be metastable. At a later stage of the flame propagation, the flame shape transforms into the stationary one dominated by the Darrieus-Landau instability.
|
|
| 5. |
- Huang, Kai, et al.
(författare)
-
Combined impact of the Lewis number and thermal expansion on laminar flame flashback in tubes
- 2024
-
Ingår i: Fluids. - : MDPI. - 2311-5521. ; 9:1
-
Tidskriftsartikel (refereegranskat)abstract
- The understanding of the boundary layer flame flashback (BLF) has considerably improved in recent decades, driven by the increasing focus on clean energy and the need to address the operational issues associated with flashback. This study investigates the influence of the Lewis number (Le) on symmetric flame shapes under the critical conditions for a laminar boundary layer flashback in cylindrical tubes. It has been found that the transformation of the flame shape from a mushroom to a tulip happens in a tube of a given radius, as the thermal expansion coefficient and Le are modified. A smaller Lewis number results in a local increase in the burning rate at the flame tip, with the flame being able to propagate closer to the wall, which significantly increases the flashback propensity, in line with previous findings. In cases with a Lewis number smaller than unity, a higher thermal expansion results in a flame propagation happening closer to the wall, thus facing a weaker oncoming flow and, consequently, becoming more prone to flashback. For Le > 1, the effect of the increase in the thermal expansion coefficient on the flashback tendency is much less pronounced.
|
|
| 6. |
- Huang, Kai, et al.
(författare)
-
Numerical study of the influence of the thermal gas expansion on the boundary layer flame flashback in channels with different wall thermal conditions
- 2023
-
Ingår i: Energies. - : MDPI. - 1996-1073. ; 16:4
-
Tidskriftsartikel (refereegranskat)abstract
- In recent years, boundary layer flame flashback (BLF) has re-emerged as a technological and operational issue due to the more widespread use of alternative fuels as a part of a global effort to promote carbon neutrality. While much understanding has been achieved in experiments and simulations of BLF in the past decades, the theoretical modeling of BLF still largely relies on the progress made as early as the 1940s, when the critical gradient model (CGM) for the laminar flame flashback was proposed by Lewis and von Elbe. The CGM does not account for the modification of the upstream flow by the flame, which has been recently shown to play a role in BLF. The aim of the present work is to gain additional insight into the effects of thermal gas expansion and confinement on the flame-flow interaction in laminar BLF. Two-dimensional simulations of the confined laminar BLF in a channel are performed in this work. The parametric study focuses on the channel width, the thermal gas expansion coefficient, and the heat losses to the wall. This study evaluates the influence of these factors on the critical condition for the flame flashback. By varying the channel width, it is demonstrated that at the critical condition, the incoming flow in narrow channels is modified globally by the thermal gas expansion, while in wider channels, the flow modification by the flame tends to be more local. In narrow channels, a non-monotonic dependence of the critical-condition centerline velocity on the channel width has been identified. The variation of the heat loss to the wall confirms that the wall’s thermal conditions can significantly alter the flashback limit, with the flashback propensity being larger when the thermal resistance of the wall is high. To assess the general applicability of the CGM, the flame consumption speed and the flow velocity near the wall are quantified. The results confirm that the assumption of flame having no influence on the upstream flow, employed in the CGM, is not fulfilled under confinement for a realistic thermal gas expansion. This results in a general disagreement between the simulations and the CGM, which implies that the thermal expansion effects should be accounted for when considering the confined boundary layer flashback limits. It is shown that the critical velocity gradient increases with the gas expansion coefficient for the given channel width and wall thermal condition.
|
|
| 7. |
- Kodakoglu, Furkan, et al.
(författare)
-
Analysis of Gaseous and Gaseous-Dusty, Premixed Flame Propagation in Obstructed Passages with Tightly Placed Obstacles
- 2020
-
Ingår i: Fluids. - : MDPI. - 2311-5521. ; 5:3
-
Tidskriftsartikel (refereegranskat)abstract
- A recent predictive scenario of premixed flame propagation in unobstructed passages is extended to account for obstructions that can be encountered in facilities dealing with explosive materials such as in coalmines. Specifically, the theory of globally-spherical, self-accelerating premixed expanding flames and that of flame acceleration in obstructed conduits are combined to form a new analytical formulation. The coalmining configuration is imitated by two-dimensional and cylindrical passages of high aspect ratio, with a comb-shaped array of tightly placed obstacles attached to the walls. It is assumed that the spacing between the obstacles is much less or, at least, does not exceed the obstacle height. The passage has one extreme open end such that a flame is ignited at a closed end and propagates to an exit. The key stages of the flame evolution such as the velocity of the flame front and the run-up distance are scrutinized for variety of the flame and mining parameters. Starting with gaseous methane-air and propane-air flames, the analysis is subsequently extended to gaseous-dusty environments. Specifically, the coal (combustible, i.e., facilitating the fire) and inert (such as sand, moderating the process) dust and their combinations are considered, and the impact of the size and concentration of the dust particles on flame acceleration is quantified. Overall, the influence of both the obstacles and the combustion instability on the fire scenario is substantial, and it gets stronger with the blockage ratio.
|
|
| 8. |
- Miao, Chengxi, et al.
(författare)
-
On the role of hydrodynamic instability and flame symmetry in flame-acoustic coupling in narrow channels
- 2024
-
Ingår i: Proceedings of the Combustion Institute. - : Elsevier. - 1540-7489 .- 1873-2704. ; 40:1-4
-
Tidskriftsartikel (refereegranskat)abstract
- In the present study, thermoacoustic oscillations of a flame propagating from an open to a closed endof an narrow channel with adiabatic walls are studied numerically. The study revisits the importance ofhydrodynamic instability and flame symmetry for both primary and secondary acoustic instabilities. For a nonsymmetric slanted flame, the primary instability is linked to the development of the hydrodynamic instability,resulting in a corrugated flame front. Spectral Proper Orthogonal Decomposition (SPOD) was employed todemonstrate that the mode at the fundamental frequency is closely associated with the nonlinear behavior ofthe hydrodynamic cells at the flame front. For the secondary instability of a non-symmetric flame, resonancebetween the acoustic waves at the fundamental mode and the hydrodynamic modes was observed, without aclear emergence of the parametric instability. For a symmetric flame, the parametric acoustic instability canbe more easily observed in a narrow channel. For a symmetric flame, SPOD of the fundamental frequencysuggests the formation of a mixture pocket at the centerline, that can potentially invert the flame front, whilethe first harmonic is related to the flame front inversion process.
|
|
| 9. |
- Thorin, Emil, et al.
(författare)
-
Simultaneous detection of K, KOH, and KCl in flames and released from biomass using photofragmentation TDLAS
- 2021
-
Ingår i: Optics Express. - : The Optical Society. - 1094-4087. ; 29:26
-
Tidskriftsartikel (refereegranskat)abstract
- Gaseous potassium (K) species released from biomass during thermochemicalconversion pose challenges to reactors and human health. Photofragmentation tunable diodelaser absorption spectroscopy (PF-TDLAS) was used for simultaneous, high-dynamic rangemeasurements of atomic K, potassium hydroxide (KOH) and potassium chloride (KCl) inflat flames seeded with KCl salt. An expression for the PF-TDLAS signal is presented andexperimentally verified. Axial K species concentration profiles recorded at fuel-air equivalenceratios of 0.8 and 1.3 are compared to 2D axisymmetric reacting flow simulations. An overallgood agreement is found, but KOH is over-predicted in simulations of fuel-rich flames at theexpense of atomic K. Quantification of K species close to softwood and wheat straw particlesconverted in the flames is demonstrated.
|
|
