| 1. |
- Abdesselam, A., et al.
(författare)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
| 2. |
|
|
| 3. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
| 4. |
- Abdesselam, A., et al.
(författare)
-
The detector control system of the ATLAS SemiConductor Tracker during macro-assembly and integration
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3, s. P02007-
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is one of the largest existing semiconductor detectors. It is situated between the Pixel detector and the Transition Radiation Tracker at one of the four interaction points of the Large Hadron Collider (LHC). During 2006-2007 the detector was lowered into the ATLAS cavern and installed in its final position. For the assembly, integration and commissioning phase, a complete Detector Control System (DCS) was developed to ensure the safe operation of the tracker. This included control of the individual powering of the silicon modules, a bi-phase cooling system and various types of sensors monitoring the SCT environment and the surrounding test enclosure. The DCS software architecture, performance and operational experience will be presented in the view of a validation of the DCS for the final SCT installation and operation phase.
|
|
| 5. |
|
|
| 6. |
- Brorson, Håkan, et al.
(författare)
-
Liposuction
- 2006
-
Ingår i: Lymphedema framework: Best practice for the management of lymphoedema. International consensus. ; , s. 50-50
-
Bokkapitel (refereegranskat)
|
|
| 7. |
|
|
| 8. |
- Gorgoi, M, et al.
(författare)
-
The high kinetic energy photoelectron spectroscopy facility at BESSY progress and first results
- 2009
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 601:1-2, s. 48-53
-
Tidskriftsartikel (refereegranskat)abstract
- Photoelectron spectroscopy at high kinetic energy is a research field that receives an increasing interest due to the possibility of studying bulk properties of materials and deeply buried interfaces. Recently the high kinetic energy electron (HIKE) spectroscopy facility at BESSY in Berlin has become operative at the bending magnet beamline KMC-1. The first results show very good performance. Electron spectra have been recorded using X-ray energies from 2 keV up to 12 keV. Using back-scattering conditions in the crystal monochromator, very high-resolution has been achieved for photon energies around 2, 6 and 8 keV. In the latter case, spectra with a resolving power from the monochromator of >= 80 000 have been achieved and it has been possible to perform electron spectroscopy with resolving power of >= 60 000, yielding a total instrument resolution of about 150 meV as determined directly from spectra. This paper describes the facility and reports some of the first results. (C) 2009 Elsevier B.V. All rights reserved.
|
|
| 9. |
|
|
| 10. |
|
|
| 11. |
- Zhang, W., et al.
(författare)
-
EULAR evidence-based recommendations for the diagnosis of hand osteoarthritis: report of a task force of ESCISIT
- 2009
-
Ingår i: Annals of the Rheumatic Diseases. - : BMJ. - 1468-2060 .- 0003-4967. ; 68:1, s. 8-17
-
Forskningsöversikt (refereegranskat)abstract
- Objectives: To develop evidence-based recommendations for the diagnosis of hand osteoarthritis (OA). Methods: The multidisciplinary guideline development group, representing 15 European countries, generated 10 key propositions regarding diagnosis using a Delphi consensus approach. For each recommendation, research evidence was searched for systematically. Whenever possible, the sensitivity, specificity and likelihood ratio (LR) were calculated; relative risk and odds ratios were estimated for risk factors for hand OA. Quality of evidence was categorised using the European League Against Rheumatism (EULAR) hierarchy, and strength of recommendation was assessed by the EULAR visual analogue scale. Results: Diagnostic topics included clinical manifestations, radiographic features, subgroups, differential diagnosis, laboratory tests, risk factors and comorbidities. The sensitivity, specificity and LR varied between tests depending upon the cut-off level, gold standard and controls. Overall, no single test could be used to define hand OA on its own (LR,10) but a composite of the tests greatly increased the chance of the diagnosis. The probability of a subject having hand OA was 20% when Heberden nodes alone were present, but this increased to 88% when in addition the subject was over 40 years old, had a family history of nodes and had joint space narrowing in any finger joint. Conclusion: Ten key recommendations for diagnosis of hand OA were developed using research evidence and expert consensus. Diagnosis of hand OA should be based on assessment of a composite of features.
|
|
| 12. |
- Zhang, W., et al.
(författare)
-
EULAR evidence based recommendations for the management of hand osteoarthritis: report of a task force of the EULAR standing committee for international clinical studies including therapeutics (ESCISIT)
- 2007
-
Ingår i: Annals of the Rheumatic Diseases. - : BMJ. - 1468-2060 .- 0003-4967. ; 66:3, s. 377-388
-
Tidskriftsartikel (refereegranskat)abstract
- Objectives: To develop evidence based recommendations for the management of hand osteoarthritis (OA). Methods: The multidisciplinary guideline development group comprised 16 rheumatologists, one physiatrist, one orthopaedic surgeon, two allied health professionals, and one evidence based medicine expert, representing 15 different European countries. Each participant contributed up to 10 propositions describing key clinical points for management of hand OA. Final recommendations were agreed using a Delphi consensus approach. A systematic search of Medline, Embase, CINAHL, Science Citation Index, AMED, Cochrane Library, HTA, and NICE reports was used to identify the best available research evidence to support each proposition. Where possible, the effect size and number needed to treat were calculated for efficacy. Relative risk or odds ratio was estimated for safety, and incremental cost effectiveness ratio was used for cost effectiveness. The strength of recommendation was provided according to research evidence, clinical expertise, and perceived patient preference. Results: Eleven key propositions involving 17 treatment modalities were generated through three Delphi rounds. Treatment topics included general considerations (for example, clinical features, risk factors, comorbidities), non-pharmacological (for example, education plus exercise, local heat, and splint), pharmacological (for example, paracetamol, NSAIDs, NSAIDs plus gastroprotective agents, COX-2 inhibitors, systemic slow acting disease modifying drugs, intra-articular corticosteroids), and surgery. Of 17 treatment modalities, only six were supported by research evidence (education plus exercise, NSAIDs, COX-2 inhibitors, topical NSAIDs, topical capsaicin, and chondroitin sulphate). Others were supported either by evidence extrapolated from studies of OA affecting other joint sites or by expert opinion. Strength of recommendation varied according to level of evidence, benefits and harms/costs of the treatment, and clinical expertise. Conclusion: Eleven key recommendations for treatment of hand OA were developed using a combination of research based evidence and expert consensus. The evidence was evaluated and the strength of recommendation was provided.
|
|
| 13. |
- Zhang, W, et al.
(författare)
-
EULAR evidence based recommendations for the management of hip osteoarthritis: report of a task force of the EULAR Standing Committee for International Clinical Studies Including Therapeutics (ESCISIT)
- 2005
-
Ingår i: Annals of the Rheumatic Diseases. - : BMJ. - 1468-2060 .- 0003-4967. ; 64:5, s. 669-681
-
Forskningsöversikt (refereegranskat)abstract
- Objective: To develop evidence based recommendations for the management of hip osteoarthritis (OA). Methods: The multidisciplinary guideline development group comprised 18 rheumatologists, 4 orthopaedic surgeons, and 1 epidemiologist, representing 14 European countries. Each participant contributed up to 10 propositions describing key clinical aspects of hip OA management. Ten final recommendations were agreed using a Delphi consensus approach. Medline, Embase, CINAHL, Cochrane Library, and HTA reports were searched systematically to obtain research evidence for each proposition. Where possible, outcome data for efficacy, adverse effects, and cost effectiveness were abstracted. Effect size, rate ratio, number needed to treat, and incremental cost effectiveness ratio were calculated. The quality of evidence was categorised according to the evidence hierarchy. The strength of recommendation was assessed using the traditional A - D grading scale and a visual analogue scale. Results: Ten key treatment propositions were generated through three Delphi rounds. They included 21 interventions, such as paracetamol, NSAIDs, symptomatic slow acting disease modifying drugs, opioids, intra-articular steroids, non-pharmacological treatment, total hip replacement, osteotomy, and two general propositions. 461 studies were identified from the literature search for the proposed interventions of efficacy, side effects, and cost effectiveness. Research evidence supported 15 interventions in the treatment of hip OA. Evidence specific for the hip was strikingly lacking. Strength of recommendation varied according to category of research evidence and expert opinion. Conclusion: Ten key recommendations for the treatment of hip OA were developed based on research evidence and expert consensus. The effectiveness and cost effectiveness of these recommendations were evaluated and the strength of recommendation was scored.
|
|
