| 1. |
- Björn, Linnea, 1994, et al.
(författare)
-
Scanning Small-Angle X-ray Scattering of Injection-Molded Polymers: Anisotropic Structure and Mechanical Properties of Low-Density Polyethylene
- 2023
-
Ingår i: ACS Applied Polymer Materials. - 2637-6105. ; 5:8, s. 6429-6440
-
Tidskriftsartikel (refereegranskat)abstract
- Injection molding is known to create a layered anisotropicmorphologyacross the sample thickness due to varying shear and cooling ratesduring the manufacturing process. In this study, scanning small-angleX-ray scattering was used to visualize and quantify the distributionof hierarchical structures present in injection-molded parts of low-densitypolyethylene (LDPE) with varying viscosities. By combining scatteringdata with results from injection molding simulations and tensile testing,we find that oriented shish-kebab structures, as well as elongatedspherulite structures consisting of semicrystalline ellipsoids, contributeto high ultimate tensile strength along the flow direction. Furthermore,we show that a higher degree of orientation is found close to theinjection gate and in LDPE with higher viscosity, consequently fromelevated shear and cooling rates present during the injection moldingprocess.
|
|
| 2. |
- Lo Re, Giada, 1971, et al.
(författare)
-
Melt processable cellulose fibres engineered for replacing oil-based thermoplastics
- 2023
-
Ingår i: Chemical Engineering Journal. - : Elsevier BV. - 1385-8947 .- 1873-3212. ; 458
-
Tidskriftsartikel (refereegranskat)abstract
- If cellulosic materials are to replace materials derived from non-renewable resources, it is necessary to overcome intrinsic limitations such as fragility, permeability to gases, susceptibility to water vapour and poor three-dimensional shaping. Novel properties or the enhancement of existing properties are required to expand the applications of cellulosic materials and will create new market opportunities. Here we have overcome the well-known restrictions that impede melt-processing of high cellulose content composites. Cellulose fibres, partially derivatised to dialcohol cellulose, have been used to manufacture three-dimensional high-density materials by conventional melt processing techniques, with or without the addition of a thermoplastic polymer. This work demonstrates the use of melt processable chemically modified cellulose fibres in the preparation of a new generation of highly sustainable materials with tuneable properties that can be tailored for specific applications requiring complex three-dimensional parts.
|
|
