SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Boogaard H) srt2:(2016)"

Sökning: WFRF:(Boogaard H) > (2016)

  • Resultat 1-2 av 2
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  • Sigvant, Mats, et al. (författare)
  • Friction and lubrication modeling in sheet metal forming simulations of a Volvo XC90 inner door
  • 2016
  • Ingår i: IOP Conference Series.
  • Konferensbidrag (refereegranskat)abstract
    • The quality of sheet metal formed parts is strongly dependent on the tribology, friction and lubrication conditions that are acting in the actual production process. Although friction is of key importance, it is currently not considered in detail in stamping simulations. This paper presents a selection of results considering friction and lubrication modeling in sheet metal forming simulations of the Volvo XC90 right rear door inner. For this purpose, the TriboForm software is used in combination with the AutoForm software. Validation of the simulation results is performed using door inner parts taken from the press line in a full-scale production run. The results demonstrate the improved prediction accuracy of stamping simulations by accounting for accurate friction and lubrication conditions, and the strong influence of friction conditions on both the part quality and the overall production stability. © Published under licence by IOP Publishing Ltd.
  •  
2.
  • Sigvant, M., et al. (författare)
  • Friction and lubrication modelling in sheet metal forming simulations of the Volvo XC90 inner door
  • 2016
  • Ingår i: NUMISHEET 2016. - : IOP PUBLISHING LTD.
  • Konferensbidrag (refereegranskat)abstract
    • The quality of sheet metal formed parts is strongly dependent on the friction and lubrication conditions that are acting in the actual production process. Although friction is of key importance, it is currently not considered in detail in stamping simulations. This paper presents project results considering friction and lubrication modelling in stamping simulations of the Volvo XC90 inner door. For this purpose, the TriboForm software is used in combination with the AutoForm software. Validation of the simulation results is performed based on door-inner parts taken from the press line in a full-scale production run. The project results demonstrate the improved prediction accuracy of stamping simulations.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-2 av 2
Typ av publikation
konferensbidrag (2)
Typ av innehåll
refereegranskat (2)
Författare/redaktör
Pilthammar, Johan (2)
Wiebenga, J. H. (2)
Chezan, T. (2)
Van Den Boogaard, A. ... (2)
Carleer, B. (1)
Sigvant, M. (1)
visa fler...
Sigvant, Mats (1)
Hol, J (1)
Hol, Jeroen (1)
Carleer, Bart (1)
visa färre...
Lärosäte
Blekinge Tekniska Högskola (2)
Språk
Engelska (2)
Forskningsämne (UKÄ/SCB)
Teknik (2)
År
2016 (2)Ta bort avgränsningen

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy