| 1. |
- Agrell, J., et al.
(författare)
-
Production of hydrogen from methanol over Cu/ZnO catalysts promoted by ZrO2 and Al2O3
- 2003
-
Ingår i: Journal of Catalysis. - : Elsevier BV. - 0021-9517 .- 1090-2694. ; 219:2, s. 389-403
-
Tidskriftsartikel (refereegranskat)abstract
- Production of H-2 from methanol by steam reforming, partial oxidation, or a combination thereof was studied over Cu/ZnO-based catalysts. The catalysts were characterized by a variety of techniques, including N2O chemisorption, X-ray photoelectron spectroscopy, X-ray diffraction, and temperature-programmed reduction/oxidation. The influence of feed composition, reaction temperature, and catalyst formulation on H-2 production rate, product distribution, and catalyst lifetime was investigated. Distinct differences between the processes were observed with respect to catalyst behavior. ZrO2-containing catalysts, especially Cu/ZnO/ZrO2/Al2O3, exhibit the best performance in the steam reforming reaction. During partial oxidation, however, a binary Cu/ZnO catalyst exhibits the lowest light-off temperature and the lowest level of CO by-product. The redox properties of the catalyst appear to play a key role in determining the pathway for H-2 production. In particular. the extent of methanol and/or H-2 combustion at differential O-2 conversion is strongly dependent on the ease of copper oxidation in the catalyst.
|
|
| 2. |
- Escudero, M. J., et al.
(författare)
-
Development and performance characterisation of new electrocatalysts for PEMFC
- 2002
-
Ingår i: Journal of Power Sources. - 0378-7753 .- 1873-2755. ; 106:1-2, s. 206-214
-
Konferensbidrag (refereegranskat)abstract
- New electrocatalysts based on Pt, Pt-Ru and Pt-Pd have been prepared by the microemulsion method. This method allows the production of a very narrow size distribution of metal particles, with an average size smaller than that of conventional electrocatalysts prepared by impregnation. Eight membrane electrode assemblies (MEAs) with an active surface area of 50 cm(2) were characterised in a single fuel cell. The MEAs consist of Nation 117 as membrane and a commercial electrocatalyst (40% Pt/C from E-TEK) on the cathode side, Four MEAs have electrocatalysts prepared by the microemulsion technique and the other four have commercial electrocatalysts on the anode side. The performance of the eight MEAs was evaluated by measuring the fuel cell polarisation curves and the internal resistance with H-2/O-2 and H-2/air, at 60 T and pressure in the range from I to 3 bar. The MEAs with the electrocatalysts prepared by microemulsion showed a performance comparable to that of the MEAs with commercial electrocatalysts. The satisfactory results obtained show that microemulsion is a promising method for the preparation of electrocatalysts for fuel cells. Further effort will be devoted to the optimisation of the method, mainly, the deposition of the metal particles on the carbon support, which it is expected to enhance the fuel cell performance.
|
|
| 3. |
- Ojeda, M., et al.
(författare)
-
Synthesis of Rh nano-particles by the microemulsion technology - Particle size effect on the CO+H-2 reaction
- 2004
-
Ingår i: Applied Catalysis A. - : Elsevier BV. - 0926-860X .- 1873-3875. ; 274:1-2, s. 33-41
-
Tidskriftsartikel (refereegranskat)abstract
- Several alumina-supported rhodium-based catalysts have been prepared using the microemulsion technology. The change of microemulsion properties led to catalysts with different Rh particle size and narrow size distribution while keeping the same metal loading. The metal particle size was determined by XRD and TEM. These catalysts were tested in the CO hydrogenation reaction in order to investigate the influence of the Rh particle size. The catalytic results indicated that turnover frequency (TOF) increased about four times when the Rh particle size increased approximately from
|
|
