| 1. |
- Cai, Yixiao, et al.
(författare)
-
Bioderived Calcite as Electrolyte for Solid Oxide Fuel Cells : A Strategy toward Utilization of Waste Shells
- 2017
-
Ingår i: ACS Sustainable Chemistry and Engineering. - : American Chemical Society (ACS). - 2168-0485. ; 5:11, s. 10387-10395
-
Tidskriftsartikel (refereegranskat)abstract
- The excessive consumption of synthesized materials and enhanced environmental protection protocols necessitate the exploitation of desirable functionalities to handle our solid waste. Through a simple calcination and composite strategy, this work envisages the first application of biocalcite derived from the waste of crayfish shells as an electrolyte for solid oxide fuel cells (SOFCs), which demonstrates encouraging performances within a low temperature range of 450-550 degrees C. The single cell device, assembled from calcined waste shells at 600 degrees C (CWS600), enables a peak power density of 166 mW cm(-2) at 550 degrees C, and further renders 330 and 256 mW cm(-2) after compositing with perovskite La0.6Sr0.4Co0.8Fe0.2O3-delta (LSCF) and layer-structured LiNi0.8Co0.15Al0.05O2 (LNCA), respectively. Notably, an oxygen-ion blocking fuel cell is used to confirm the proton-conducting property of CWS600 associated electrolytes. The practical potential of the prepared fuel cells is also validated when the cell voltage of the cell is kept constant value over 10 h during a galvanostatic operation using a CWS600-LSCF electrolyte. These interesting findings may increase the likelihood of transforming our solid municipal waste into electrochemical energy devices, and also importantly, provide an underlying approach for discovering novel electrolytes for low-temperature SOFCs.
|
|
| 2. |
- Liu, Yanyan, et al.
(författare)
-
Superionic Conductivity of Sm3+, Pr3+, and Nd3+ Triple-Doped Ceria through Bulk and Surface Two-Step Doping Approach
- 2017
-
Ingår i: ACS Applied Materials and Interfaces. - : American Chemical Society (ACS). - 1944-8244 .- 1944-8252. ; 9:28, s. 23614-23623
-
Tidskriftsartikel (refereegranskat)abstract
- Sufficiently high oxygen ion conductivity of electrolyte is critical for good performance of low-temperature solid oxide fuel cells (LT-SOFCs). Notably, material conductivity, reliability, and manufacturing cost are the major barriers hindering LT-SOFC commercialization. Generally, surface properties control the physical and chemical functionalities of materials. Hereby, we report a Sm3+, Pr3+, and Nd3+ triple-doped ceria, exhibiting the highest ionic conductivity among reported doped-ceria oxides, 0.125 S cm(-1) at 600 degrees C. It was designed using a two-step wet-chemical coprecipitation method to realize a desired doping for Sm3+ at the bulk and Pr3+/Nd3+ at surface domains (abbreviated as PNSDC). The redox couple Pr3+ Pr4+ contributes to the extraordinary ionic conductivity. Moreover, the mechanism for ionic conductivity enhancement is demonstrated. The above findings reveal that a joint bulk and surface doping methodology for ceria is a feasible approach to develop new oxide-ion conductors with high impacts on advanced LT-SOFCs.
|
|
| 3. |
- Wang, Baoyuan, et al.
(författare)
-
Semiconductor-ionic Membrane of LaSrCoFe-oxide-doped Ceria Solid Oxide Fuel Cells
- 2017
-
Ingår i: Electrochimica Acta. - : Elsevier BV. - 0013-4686 .- 1873-3859. ; 248, s. 496-504
-
Tidskriftsartikel (refereegranskat)abstract
- A novel semiconductor-ionic La0.6Sr0.4Co0.2Fe0.8O3-delta (LSCF)-Sm/Ca co-doped CeO2 (SCDC) nanocomposite has been developed as a membrane, which is sandwiched between two layers of Ni0.8Co0.15Al0.05Li-oxide (NCAL) to construct semiconductor-ion membrane fuel cell (SIMFC). Such a device presented an open circuit voltage (OCV) above 1.0 V and maximum power density of 814 mW cm(-2) at 550 degrees C, which is much higher than 0.84 V and 300 mW cm(-2) for the fuel cell using the SCDC membrane. Moreover, the SIMFC has a relatively promising long-term stability, the voltage can maintain at 0.966 V for 60 hours without degradation during the fuel cells operation and the open-circuit voltage (OCV) can return to 1.06 V after long-term fuel cell operation. The introduction of LSCF electronic conductor into the membrane did not cause any short circuit but brought significant enhancement of fuel cell performances. The Schottky junction is proposed to prevent the internal electrons passing thus avoiding the device short circuiting problem.
|
|
| 4. |
- Xia, Chen, et al.
(författare)
-
Electrochemical properties of LaCePr-oxide/K2WO4 composite electrolyte for low-temperature SOFCs
- 2017
-
Ingår i: Electrochemistry communications. - : ELSEVIER SCIENCE INC. - 1388-2481 .- 1873-1902. ; 77, s. 44-48
-
Tidskriftsartikel (refereegranskat)abstract
- In this study, we introduced tungstate into solid oxide fuel cells (SOFCs) for the first time by using a La/Pr-doped CeO2 (LCP)/K2WO4 composite as the electrolyte, which exhibited remarkably enhanced grain boundary conduction compared to that of single-phase LCP. The composition dependence of the electrical conductivity was investigated. As a result, the composite with 10 wt% K2WO4 was proven to be the optimum ratio, revealing a significantly higher ionic conductivity than LCP, along with a negligible electronic conductivity. The fuel cell using the LCP/K2WO4 electrolyte displayed an encouraging performance of 500 mW cm(-2) at 550 degrees C. These findings indicate that the LCP/K2WO4 composite is a promising electrolyte for low-temperature SOFCs.
|
|
| 5. |
- Xia, Chen, et al.
(författare)
-
Strategy towards cost-effective low-temperature solid oxide fuel cells : A mixed-conductive membrane comprised of natural minerals and perovskite oxide
- 2017
-
Ingår i: Journal of Power Sources. - : Elsevier. - 0378-7753 .- 1873-2755. ; 342, s. 779-786
-
Tidskriftsartikel (refereegranskat)abstract
- Our previous work has revealed the feasibility of natural hematite as an electrolyte material for solid oxide fuel cells (SOFCs), tailoring SOFCs to be a more economically competitive energy conversion technology. In the present work, with the aim of exploring more practical uses of natural minerals, a novel composite hematite/LaCePrOx-La0.6Sr0.4Co0.2Fe0.8O3-δ (hematite/LCP-LSCF) has been developed from natural hematite ore, rare-earth mineral LaCePr-carbonate, and perovskite oxide LSCF as a functional membrane in SOFCs. The heterogeneity, nanostructure and mixed-conductive property of the composite were investigated. The results showed that the hematite/LCP-30 wt% LSCF composite possessed balanced ionic and electronic conductivities, with an ionic conductivity as high as 0.153 S cm−1 at 600 °C. The as-designed fuel cell using the hematite/LCP-LSCF membrane exhibited encouraging power outputs of 303 – 662 mW cm−2 at 500 – 600 °C. These findings show that the hematite/LCP-LSCF based fuel cell is a viable strategy for developing cost-effective and practical low-temperature SOFCs (LTSOFCs).
|
|
