1. |
- Abazov, V. M., et al.
(författare)
-
The upgraded DO detector
- 2006
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 565:2, s. 463-537
-
Tidskriftsartikel (refereegranskat)abstract
- The DO experiment enjoyed a very successful data-collection run at the Fermilab Tevatron collider between 1992 and 1996. Since then, the detector has been upgraded to take advantage of improvements to the Tevatron and to enhance its physics capabilities. We describe the new elements of the detector, including the silicon microstrip tracker, central fiber tracker, solenoidal magnet, preshower detectors, forward muon detector, and forward proton detector. The uranium/liquid -argon calorimeters and central muon detector, remaining from Run 1, are discussed briefly. We also present the associated electronics, triggering, and data acquisition systems, along with the design and implementation of software specific to DO.
|
|
2. |
- Mapelli, A., et al.
(författare)
-
Development of a detector (ALFA) to measure the absolute LHC luminosity at ATLAS
- 2008
-
Ingår i: Astroparticle, Particle and Space Physics, Detectors and Medical Physics Applications - Proceedings of the 10th Conference. - 9812819088 - 9789812819086 ; , s. 984-988
-
Konferensbidrag (refereegranskat)abstract
- The ATLAS collaboration plans to determine the absolute luminosity of the CERN LHC at Interaction Point 1 by measuring the trajectory of protons elastically scattered at very small angles (μrad). A scintillating fibre tracker system called ALFA (Absolute Luminosity For ATLAS) is proposed for this measurement. Detector modules will be placed above and below the LHC beam axis in roman pot units at a distance of 240 m on cach side of the ATLAS interaction point. They allow the detectors to approach the beam axis to millimeter distance. Overlap detectors also based on the scintillating fibre technology, will measure the precise relative position of the two detector modules, Results obtained during beam tests at DESY and at CERN validate the detectors design and demonstrate the achievable resolution. We also report about radiation hardness studies of the scintillating fibres to estimate the lifetime of the ALFA system at different operating conditions of the LHC.
|
|
3. |
|
|
4. |
- Anghinolfi, F., et al.
(författare)
-
Hadron beam test of a scintillating fibre tracker system for elastic scattering and luminosity measurement in ATLAS
- 2007
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 2
-
Tidskriftsartikel (refereegranskat)abstract
- A scintillating fibre tracker is proposed to measure elastic proton scattering at very small angles in the ATLAS experiment at CERN. The tracker will be located in so-called Roman Pot units at a distance of 240 m on each side of the ATLAS interaction point. An initial validation of the design choices was achieved in a beam test at DESY in a relatively low energy electron beam and using slow off-the-shelf electronics. Here we report on the results from a second beam test experiment carried out at CERN, where new detector prototypes were tested in a high energy hadron beam, using the first version of the custom designed front-end electronics. With a spatial resolution of 25 mu m an adequate tracking performance was obtained, under conditions which are similar to the situation at the LHC. In addition, the alignment method using so-called overlap detectors was studied and shown to have the expected precision.
|
|
5. |
- Ask, S., et al.
(författare)
-
Luminosity measurement at ATLAS - Development, construction and test of scintillating fibre prototype detectors
- 2006
-
Ingår i: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - : Elsevier BV. - 0167-5087 .- 0168-9002. ; 568:2, s. 588-600
-
Tidskriftsartikel (refereegranskat)abstract
- We are reporting about a scintillating fibre tracking detector which is proposed for the precise determination of the absolute luminosity of the CERN LHC at interaction point 1 where the ATLAS experiment is located. The detector needs to track protons elastically scattered under mu rad angles in direct vicinity to the LHC beam. It is based on square shaped scintillating plastic fibres read out by multianode photomultiplier tubes and is housed in Roman Pots. We describe the design and construction of prototype detectors and the results of a beam test experiment at DESY. The excellent detector performance established in this test validates the detector design and supports the feasibility of the proposed challenging method of luminosity measurement. (c) 2006 Elsevier B.V. All rights reserved.
|
|