| 1. |
- Scherzinger, J., et al.
(författare)
-
The light-yield response of a NE-213 liquid-scintillator detector measured using 2–6 MeV tagged neutrons
- 2016
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 840, s. 121-127
-
Tidskriftsartikel (refereegranskat)abstract
- The response of a NE-213 liquid-scintillator detector has been measured using tagged neutrons from 2 to 6 MeV originating from an Am/Be neutron source. The neutron energies were determined using the time-of-flight technique. Pulse-shape discrimination was employed to discern between gamma-rays and neutrons. The behavior of both the fast (35 ns) and the combined fast and slow (475 ns) components of the neutron scintillation-light pulses were studied. Three different prescriptions were used to relate the neutron maximum energy-transfer edges to the corresponding recoil-proton scintillation-light yields, and the results were compared to simulations. The overall normalizations of parametrizations which predict the fast or total light yield of the scintillation pulses were also tested. Our results agree with both existing data and existing parametrizations. We observe a clear sensitivity to the portion and length of the neutron scintillation-light pulse considered.
|
|
| 2. |
- Dijulio, Douglas D., et al.
(författare)
-
Characterization of the radiation background at the Spallation Neutron Source
- 2016
-
Ingår i: VI European Conference On Neutron Scattering (ECNS2015). - : IOP Publishing. ; 746:1
-
Konferensbidrag (refereegranskat)abstract
- We present a survey of the radiation background at the Spallation Neutron Source (SNS) at Oak Ridge National Laboratory, TN, USA during routine daily operation. A broad range of detectors was used to characterize primarily the neutron and photon fields throughout the facility. These include a WENDI-2 extended range dosimeter, a thermoscientific NRD, an Arktis He-4 detector, and a standard Nal photon detector. The information gathered from the detectors was used to map out the neutron dose rates throughout the facility and also the neutron dose rate and flux profiles of several different beamlines. The survey provides detailed information useful for developing future shielding concepts at spallation neutron sources, such as the European Spallation Source (ESS), currently under construction in Lund, Sweden.
|
|
| 3. |
- Albani, Giorgia, et al.
(författare)
-
Evolution in boron-based GEM detectors for diffraction measurements : From planar to 3D converters
- 2016
-
Ingår i: Measurement science and technology. - : IOP Publishing. - 0957-0233 .- 1361-6501. ; 27:11
-
Tidskriftsartikel (refereegranskat)abstract
- The so-called '3He-crisis' has motivated the neutron detector community to undertake an intense R&D programme in order to develop technologies alternative to standard 3He tubes and suitable for neutron detection systems in future spallation sources such as the European spallation source (ESS). Boron-based GEM (gas electron multiplier) detectors are a promising '3He-free' technology for thermal neutron detection in neutron scattering experiments. In this paper the evolution of boron-based GEM detectors from planar to 3D converters with an application in diffraction measurements is presented. The use of 3D converters coupled with GEMs allows for an optimization of the detector performances. Three different detectors were used for diffraction measurements on the INES instrument at the ISIS spallation source. The performances of the GEM-detectors are compared with those of conventional 3He tubes installed on the INES instrument. The conceptual detector with the 3D converter used in this paper reached a count rate per unit area of about 25% relative to the currently installed 3He tube. Its timing resolution is similar and the signal-to-background ratio (S/B) is 2 times lower.
|
|
| 4. |
- Imam, Mewlude, et al.
(författare)
-
Trimethylboron as Single-Source Precursor for Boron-Carbon Thin Film Synthesis by Plasma Chemical Vapor Deposition
- 2016
-
Ingår i: The Journal of Physical Chemistry C. - : American Chemical Society (ACS). - 1932-7447 .- 1932-7455. ; 120:38, s. 21990-21997
-
Tidskriftsartikel (refereegranskat)abstract
- Boron carbon (BxC) thin films are potential neutron converting layers for B-10-based neutron detectors. However, as common material choices for such detectors do not tolerate temperatures above 500 degrees C, a low temperature deposition route is required. Here, we study trimethylboron B(CH3)(3) (TMB) as a single-source precursor for the deposition of BxC thin films by plasma CVD using Ar plasma. The effect of plasma power, TMB/Ar flow ratio and total pressure, on the film composition, morphology, chemical bonding, and microstructures are investigated. Dense and boron-rich films (B/C = 1.9) are achieved at high TMB flow under a low total pressure and high plasma power, which rendered an approximate substrate temperature of similar to 300 degrees C. Films mainly contain B-C bonds with the presence of B-O and C-C, which is attributed to be the origin of formed amorphous carbon in the films. The high H content 15 +/- 5 at. %) is almost independent of deposition parameters and contributed to lower the film density (2.16 g/cm(3)). The plasma compositional analysis shows that the TMB molecule decomposes to mainly atomic H, C-2, BH, and CH. A plasma chemical model for the decomposition of TMB with BH and CH as the plausible film depositing species in the plasma is proposed.
|
|
| 5. |
- Piscitelli, Francesco, et al.
(författare)
-
Neutron reflectometry on highly absorbing films and its application to (B4C)-B-10-based neutron detectors
- 2016
-
Ingår i: Royal Society of London. Proceedings A. Mathematical, Physical and Engineering Sciences. - : The Royal Society. - 1364-5021 .- 1471-2946. ; 472:2185
-
Tidskriftsartikel (refereegranskat)abstract
- Neutron reflectometry is a powerful tool used for studies of surfaces and interfaces. The absorption in the typical studied materials is neglected and this technique is limited only to the reflectivity measurement. For strongly absorbing nuclei, the absorption can be directly measured by using the neutron-induced fluorescence technique which exploits the prompt particle emission of absorbing isotopes. This technique is emerging from soft matter and biology where highly absorbing nuclei, in very small quantities, are used as a label for buried layers. Nowadays, the importance of absorbing layers is rapidly increasing, partially because of their application in neutron detection; a field that has become more active also due to the He-3-shortage. We extend the neutron-induced fluorescence technique to the study of layers of highly absorbing materials, in particular (B4C)-B-10. The theory of neutron reflectometry is a commonly studied topic; however, when a strong absorption is present the subtle relationship between the reflection and the absorption of neutrons is not widely known. The theory for a general stack of absorbing layers has been developed and compared to measurements. We also report on the requirements that a (B4C)-B-10 layer must fulfil in order to be employed as a converter in neutron detection.
|
|
