| 1. |
- Moss, B, et al.
(författare)
-
The determination of ecological status in shallow lakes - a tested system (ECOFRAME) for implementation of the European Water Framework Directive
- 2003
-
Ingår i: Aquatic Conservation: Marine and Freshwater Ecosystems. - : Wiley. - 1052-7613. ; 13:6, s. 507-549
-
Tidskriftsartikel (refereegranskat)abstract
- 1. The European Water Framework Directive requires the determination of ecological status in European fresh and saline waters. This is to be through the establishment of a typology of surface water bodies, the determination of reference (high status) conditions in each element (ecotype) of the typology and of lower grades of status (good, moderate, poor and bad) for each ecotype. It then requires classification of the status of the water bodies and their restoration to at least 'good status' in a specified period. 2. Though there are many methods for assessing water quality, none has the scope of that defined in the Directive. The provisions of the Directive require a wide range of variables to be measured and give only general guidance as to how systems of classification should be established. This raises issues of comparability across States and of the costs of making the determinations. 3. Using expert workshops and subsequent field testing, a practicable pan-European typology and classification system has been developed for shallow lakes, which can easily be extended to all lakes. It is parsimonious in its choice of determinands, but based on current limnological understanding and therefore as cost-effective as possible. 4. A core typology is described, which can be expanded easily in particular States to meet local conditions. The core includes 48 ecotypes across the entire European climate gradient and incorporates climate, lake area, geology of the catchment and conductivity. 5. The classification system is founded on a liberal interpretation of Annexes in the Directive and uses variables that are inexpensive to measure and ecologically relevant. The need for taxonomic expertise is minimized. 6. The scheme has been through eight iterations, two of which were tested in the field on tranches of 66 lakes. The final version, Version 8, is offered for operational testing and further refinement by statutory authorities.
|
|
| 2. |
- Behm, Mårten, et al.
(författare)
-
Influence of structure and composition upon performance of tin phosphate based negative electrodes for lithium batteries
- 2002
-
Ingår i: Electrochimica Acta. - 0013-4686 .- 1873-3859. ; 47:11, s. 1727-1738
-
Tidskriftsartikel (refereegranskat)abstract
- Tin oxide and amorphous tin borophosphates have recently received significant attention as possible new negative electrode materials for lithium batteries. In this study. we have carefully investigated a number of different well-characterised tin phosphates as electrodes in Li-ion cells, in order to better understand the mode of operation of these materials and how their performance is related to structure and composition. The materials that were investigated were crystalline cubic and layered SnP2O7, LiSn2(PO4)(3). Sn2P2O7, and Sn-3(PO4)(2). and amorphous Sn2BPO6. Cubic SnP2O7 showed the best performance with a reversible specific charge capacity of > 360 mA h g(-1) and a capacity retention of 96% over 50 cycles when cycled between 0.02 and 1.2 V versus Li-m. The three Sn(IV) materials showed lower initial reversible capacity but better capacity retention than the three Sn(II) materials in the study. Their higher proportion of inert matrix material can partly explain this. However. cubic SnP2O7 cycled significantly better than its layered polymorph. which shows that the structure of the starting material is also of great importance. Another important conclusion drawn front the results is that it is not necessary for the starting material to be amorphous, or if crystalline, to have small grain size, to cycle well. The three pyrophosphates all show an initial reduction capacity that corresponds to around 2 Li per P2O74- unit more than is predicted by theory. This might be explained by reductive break-up of the P 0 P bond.
|
|
| 3. |
|
|
| 4. |
- Noges, P, et al.
(författare)
-
Factors controlling hydrochemical and trophic state variables in 86 shallow lakes in Europe
- 2003
-
Ingår i: Hydrobiologia. - 1573-5117 .- 0018-8158. ; 506:1-3, s. 51-58
-
Konferensbidrag (refereegranskat)abstract
- In order to disentangle the causes of variations in water chemistry among European shallow lakes, we performed standardised sampling programs in 86 lakes along a latitudinal gradient from southern Spain to northern Sweden. Lakes with an area of 0.1 to 27000 ha and mean depth of 0.4-5.6 m located in low to high altitudes were investigated within the EC project ECOFRAME 1-4 times during June-October 2000-2001. Several variables like conductivity, alkalinity, abundance of submerged plants, concentrations of suspended solids, total nitrogen and phosphorus were latitude-dependent decreasing from south to north. Secchi depth, concentrations of total nitrogen, total phosphorus, suspended solids, and chlorophyll a correlated strongly with the presumed quality classes of the lakes. We came to the conclusion that the variability of shallow lakes in Europe is still mostly dependent on natural differences. Variables connected to lake morphometry, seasonality, basin geology and climate explained altogether nearly half of the total variability of lakes. The trophic state factor, describing mostly the human influence on lakes, was the strongest single factor responsible for nearly a quarter of the total variability of the studied European lakes.
|
|
