| 1. |
- Ongena, J., et al.
(författare)
-
Recent progress on JET towards the ITER reference mode of operation at high density
- 2001
-
Ingår i: Plasma Physics and Controlled Fusion. - 0741-3335 .- 1361-6587. ; 43, s. A11-A30
-
Tidskriftsartikel (refereegranskat)abstract
- Recent progress towards obtaining high density and high confinement in JET as required for the ITER reference scenario at Q = 10 is summarized. Plasmas with simultaneous confinement H-98(y.2) = 1 and densities up to n/n(Gw) similar to 1 are now routinely obtained. This has been possible (i) by using plasmas at high (delta similar to 0.5) and medium (delta similar to 0.3-0.4) triangularity with sufficient heating power to maintain Type I ELMs, (ii) with impurity seeded plasmas at high (delta similar to 0.5) and low (delta less than or equal to 0.2) triangularity, (iii) with an optimized pellet injection sequence, maintaining the energy confinement and raising the density, and (iv) by carefully tuning the gas puff rate leading to plasmas with peaked density profiles and good confinement at long time scales. These high performance discharges exhibit Type I ELMs, with a new and more favourable behaviour observed at high densities, requiring further studies. Techniques for a possible mitigation of these ELMs are discussed, and first promising results are obtained with impurity seeding in discharges at high triangularity. Scaling studies using the new data of this year show a strong dependence of confinement on upper triangularity, density and proximity to the Greenwald limit. Observed MHD instabilities and methods to avoid these in high density and high confinement plasmas are discussed.
|
|
| 2. |
- Westerhof, E., et al.
(författare)
-
Control of sawteeth and triggering of NTMs with ion cyclotron resonance frequency waves in JET
- 2002
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 42:11, s. 1324-1334
-
Tidskriftsartikel (refereegranskat)abstract
- A new scenario to delay or prevent neoclassical tearing mode (NTM) onset is presented. By active sawtooth destabilization, short period and low amplitude sawteeth are generated, such that the sawtooth produced NTM seed island is reduced and the threshold normalized plasma pressure for triggering of NTMs, beta(Nonset), is increased. The scenario has been explored experimentally in the Joint European Torus (JET). Ion cyclotron resonance frequency (ICRF) waves tuned to the 2nd harmonic H-minority resonance have been used for sawtooth control. Whereas ICRF waves generally induce sawtooth stabilization, favouring the triggering of NTMs and reducing beta(Nonset), the present experiments show that by toroidally directed waves, ion cyclotron current drive is produced, and that sawteeth can be destabilized by careful positioning of the 2nd harmonic H resonance layer with respect to the sawtooth inversion radius. As a result, NTM onset is delayed and beta(Nonset) is increased above its value obtained in discharges with additional heating from neutral beam injection alone.
|
|
| 3. |
- Mantsinen, M. J., et al.
(författare)
-
Analysis of ion cyclotron heating and current drive at omega approximate to 2 omega(cH) for sawtooth control in JET plasmas
- 2002
-
Ingår i: Plasma Physics and Controlled Fusion. - : IOP Publishing. - 0741-3335 .- 1361-6587. ; 44:8, s. 1521-1542
-
Tidskriftsartikel (refereegranskat)abstract
- Ion cyclotron heating and current drive at omega approximate to 2omega(cH) in JET deuterium plasmas with a hydrogen concentration n(H)/(n(D)+n(H)) in the range of 5-15% are analysed, comparing results of numerical computer modelling with experiments. Second harmonic hydrogen damping is found to be maximized by placing the resonance on the, low-field side (LFS) of the torus, which minimizes competing direct electron damping and parasitic high-harmonic D damping in the presence of D beams. The shape of the calculated current perturbation and the radial localization of the heating power density for the LFS resonance are consistent with the experimentally observed evolution of the sawtooth period when the resonance layer moves near the q = 1 surface. Since the calculated driven current is dominated by a current of diamagnetic type caused by finite orbit widths of trapped resonating ions, it is not too sensitive to the ICRF phasing. Control of sawteeth with ion cyclotron current drive using the LFS omega approximate to 2omega(cH) resonance in the present experimental conditions can thus be best obtained by varying the resonance location rather than the ICRF phasing. Due to differences in fast ion orbits, collisional electron heating and fast ion pressure profiles are significantly more peaked for a LFS resonance than for a high-field side (HFS) resonance. For the HFS omega approximate to 2omega(cH) resonance, an enhanced neutron rate is observed in the presence of D beam ions, which is consistent with parasitic D damping at the omega approximate to 2omega(cD) resonance in the plasma centre.
|
|
| 4. |
- Sauter, O., et al.
(författare)
-
Control of neoclassical tearing modes by sawtooth control
- 2002
-
Ingår i: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 88:10
-
Tidskriftsartikel (refereegranskat)abstract
- The onset of a neoclassical tearing mode (NTM) depends on the existence of a large enough seed island. It is shown in the Joint European Torus that NTMs can be readily destabilized by long-period sawteeth, such as obtained by sawtooth stabilization from ion-cyclotron heating or current drive. This has important implications for burning plasma scenarios, as alpha particles strongly stabilize the sawteeth. It is also shown that, by adding heating and current drive just outside the inversion radius, sawteeth are destabilized, resulting in shorter sawtooth periods and larger beta values being obtained without NTMs.
|
|
