| 1. |
- Fredenberg, Erik, 1979-
(författare)
-
Spectral Mammography with X-Ray Optics and a Photon-Counting Detector
- 2009
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Early detection is vital to successfully treating breast cancer, and mammography screening is the most efficient and wide-spread method to reach this goal. Imaging low-contrast targets, while minimizing the radiation exposure to a large population is, however, a major challenge. Optimizing the image quality per unit radiation dose is therefore essential. In this thesis, two optimization schemes with respect to x-ray photon energy have been investigated: filtering the incident spectrum with refractive x-ray optics (spectral shaping), and utilizing the transmitted spectrum with energy-resolved photon-counting detectors (spectral imaging). Two types of x-ray lenses were experimentally characterized, and modeled using ray tracing, field propagation, and geometrical optics. Spectral shaping reduced dose approximately 20% compared to an absorption-filtered reference system with the same signal-to-noise ratio, scan time, and spatial resolution. In addition, a focusing pre-object collimator based on the same type of optics reduced divergence of the radiation and improved photon economy by about 50%. A photon-counting silicon detector was investigated in terms of energy resolution and its feasibility for spectral imaging. Contrast-enhanced tumor imaging with a system based on the detector was characterized and optimized with a model that took anatomical noise into account. Improvement in an ideal-observer detectability index by a factor of 2 to 8 over that obtained by conventional absorption imaging was found for different levels of anatomical noise and breast density. Increased conspicuity was confirmed by experiment. Further, the model was extended to include imaging of unenhanced lesions. Detectability of microcalcifications increased no more than a few percent, whereas the ability to detect large tumors might improve on the order of 50% despite the low attenuation difference between glandular and cancerous tissue. It is clear that inclusion of anatomical noise and imaging task in spectral optimization may yield completely different results than an analysis based solely on quantum noise.
|
|
| 2. |
- Stolen, Reidar, et al.
(författare)
-
Solcelleteknologi og brannsikkerhet
- 2018
-
Rapport (övrigt vetenskapligt/konstnärligt)abstract
- Bruken av solcelleteknologi er i stor vekst i Norge. I denne studien er branntekniske utfordringer ved bruk av solcelleteknologi undersøkt, med hensyn på brannstart, brannspredning og brannslokking. Studien danner et kunnskapsgrunnlag for å ivareta brannsikkerheten under montering, drift og under slokkeinnsats, samt for å utforme et enhetlig og tydelig regelverk. Resultatene fra studien viser:Brannstart: Solcelleinstallasjoner inneholder mange koblingspunkt, som kan være potensielle tennkilder, og en liten mengde brennbare materialer. Dermed er det som trengs til stede for å starte en brann. Det er viktig at alle kontaktpunkter i solcelleinstallasjonen er robuste og tåler den påkjenningen de blir utsatt for gjennom sin levetid uten at det oppstår dårlig kontakt som kan føre til brann.Brannspredning: For utenpåmonterte solcellemoduler er det ofte en åpen luftspalte mellom modul og bygning. Dersom det er en brann i denne luftspalten, vil varmen kunne bli akkumulert, noe som kan føre til raskere og større brannspredning enn om bygningsoverflaten ikke hadde vært tildekket. I fullskalaforsøk med solcellemoduler montert på tak spredte brannen seg under hele arealet som var dekket av moduler, men stoppet da den nærmet seg kanten av dette arealet. Dette illustrerer viktigheten av at områder med solceller utenpå en bygning blir seksjonert for å unngå brannspredning. Eventuelt kan det benyttes mindre brennbare materialer på taket under solcellemodulene for å motvirke den økte varmepåkjenningen som solcellemodulene gir. Luftspalten mellom modul og bygning kan potensielt også gi endringer i luftstrømningen langs bygget, som igjen kan påvirke brannspredningen.Brannslokking: Brannvesenet har behov for informasjon om det er solcelleinstallasjon i bygget og hvilke deler av det elektriske anlegget som kan være spenningssatt. Under slokkeinnsats må brannvesenet ta hensyn til berøringsfare, og fare for at det kan oppstå lysbuer og andre feil som kan føre til nye antennelsespunkt. Ferskvann kan brukes som slokkemiddel, dette må spyles fra minimum 1 meters avstand med spredt stråle og minimum 5 meters avstand med samlet stråle. Solcellemoduler kan komplisere brannslokking ved at de danner en fysisk barriere mellom brannvesenet og brannen, samt fordi det må tas hensyn til plassering av spenningssatte komponenter. Når disse punktene er tatt høyde for, bør ikke utenpåmonterte solcelleinstallasjoner være et problem.Videre arbeid: For utenpåmonterte solcelleinstallasjoner, er det lite forskning på vertikal montering (på fasader), og hvordan en eventuell endret branndynamikk kan påvirke brannspredning og slokking. Videre er det i dag økende bruk av bygningsintegrerte solcelleinstallasjoner, noe som gir mange mulige nye utfordringer for brannsikkerheten og for regelverk, ettersom solcellen da er en del av bygningskroppen, samtidig som den er en elektrisk komponent. Tysk statistikk tyder på at brannrisiko for slike installasjoner kan være større enn for utenpåmonterte solcelleinstallasjoner, og dette vil det derfor være viktig å undersøke nærmere.
|
|
| 3. |
- Amundin, Mats, et al.
(författare)
-
A proposal to use distributional models to analyse dolphin vocalisation
- 2017
-
Ingår i: Proceedings of the 1st International Workshop on Vocal Interactivity in-and-between Humans, Animals and Robots, VIHAR 2017. - 9782956202905 ; , s. 31-32
-
Konferensbidrag (refereegranskat)abstract
- This paper gives a brief introduction to the starting points of an experimental project to study dolphin communicative behaviour using distributional semantics, with methods implemented for the large scale study of human language.
|
|
| 4. |
- Chen, Zhe, et al.
(författare)
-
Nano-scale characterization of white layer in broached Inconel 718
- 2017
-
Ingår i: Materials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing. - Amsterdam : Elsevier BV. - 0921-5093 .- 1873-4936. ; 684, s. 373-384
-
Tidskriftsartikel (refereegranskat)abstract
- The formation mechanism of white layers during broaching and their mechanical properties are not well investigated and understood to date. In the present study, multiple advanced characterization techniques with nano-scale resolution, including transmission electron microscopy (TEM), transmission Kikuchi diffraction (TKD), atom probe tomography (APT) as well as nano-indentation, have been used to systematically examine the microstructural evolution and corresponding mechanical properties of a surface white layer formed when broaching the nickel-based superalloy Inconel 718.TEM observations showed that the broached white layer consists of nano-sized grains, mostly in the range of 20–50 nm. The crystallographic texture detected by TKD further revealed that the refined microstructure is primarily caused by strong shear deformation. Co-located Al-rich and Nb-rich fine clusters have been identified by APT, which are most likely to be γ′ and γ′′ clusters in a form of co-precipitates, where the clusters showed elongated and aligned appearance associated with the severe shearing history. The microstructural characteristics and crystallography of the broached white layer suggest that it was essentially formed by adiabatic shear localization in which the dominant metallurgical process is rotational dynamic recrystallization based on mechanically-driven subgrain rotations. The grain refinement within the white layer led to an increase of the surface nano-hardness by 14% and a reduction in elastic modulus by nearly 10% compared to that of the bulk material. This is primarily due to the greatly increased volume fraction of grain boundaries, when the grain size was reduced down to the nanoscale.
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
- Schötz, Susanne, et al.
(författare)
-
Phonetic Characteristics of Domestic Cat Vocalisations
- 2017
-
Ingår i: Proceedings of the 1st International Workshop on Vocal Interactivity in-and-between Humans, Animals and Robots, VIHAR 2017. - 9782956202905 ; , s. 5-6
-
Konferensbidrag (refereegranskat)abstract
- The cat (Felis catus, Linneaus 1758) has lived around or with humans for at least 10,000 years, and is now one of the most popular pets of the world with more than 600 millionindividuals. Domestic cats have developed a more extensive, variable and complex vocal repertoire than most other members of the Carnivora, which may be explained by their social organisation, their nocturnal activity and the long period of association between mother and young. Still, we know surprisingly little about the phonetic characteristics of these sounds, and about the interaction between cats and humans.Members of the research project Melody in human–cat communication (Meowsic) investigate the prosodic characteristics of cat vocalisations as well as the communication between human and cat. The first step includes a categorisation of cat vocalisations. In the next step it will be investigated how humans perceive the vocal signals of domestic cats. This paper presents an outline of the project which has only recently started.
|
|
| 9. |
- Hosseini Bab Anari, Elham, 1982, et al.
(författare)
-
Fluorine-free salts for aqueous lithium-ion and sodium-ion battery electrolytes
- 2016
-
Ingår i: RSC Advances. - : Royal Society of Chemistry (RSC). - 2046-2069. ; 6:88, s. 6, 85194-85201
-
Tidskriftsartikel (refereegranskat)abstract
- A first generation of fluorine-free lithium and sodium salts based on the concept of pseudo-delocalized anions has been synthesized with both high purity and yield using water as the solvent in the reaction medium. The salts have been fully characterized by Raman and FT-IR spectroscopies, thermogravimetry, and X-ray crystallography to reveal both basic properties in terms of thermal stability and solubility as well as the local, mainly ion–ion interaction dictated, coordination details and by ionic conductivity and electrochemical stability window measurements as aqueous electrolytes. Together a picture is created of the salts' promise as components in electrolytes – primarily aiming at application in low voltage fluorinefree aqueous lithium-ion batteries (LIBs) and sodium-ion batteries (SIBs).
|
|
| 10. |
-
INNOTRACK: Concluding technical report
- 2010
-
Samlingsverk (redaktörskap) (refereegranskat)abstract
- The track structure, rails, switches and crossings account for more than 50% of maintenance and renewal costs for the rail industry. To improve the competitiveness of rail transportation, the cost-efficiency of these areas needs to be addressed.This the background to INNOTRACK, an integrated research project funded by the European Commission’s 6th research framework pro- gramme. Running from September 2006 to December 2009, INN- OTRACK has developed a multitude of innovative solutions in the areas of track substructure, rails & welds, and switches & crossings. The solutions have been assessed from technical, logistics and life cycle cost point of views.This Concluding Technical Report of INNOTRACK includes an overview of the project. It further details implementable results, and clusters them into ”highlight” areas. In addition, the book acts as a ”key” to the vast amount of information from INNOTRACK: All sections refer to project reports where more information can be found.
|
|
