| 51. |
- Fonnesu, N., et al.
(författare)
-
Shutdown dose rate measurements after the 2016 Deuterium-Deuterium campaign at JET
- 2018
-
Ingår i: Fusion engineering and design. - : ELSEVIER SCIENCE SA. - 0920-3796 .- 1873-7196. ; 136, s. 1348-1353
-
Tidskriftsartikel (refereegranskat)abstract
- The EUROfusion Work Package JET3 programme, established to enable the technological exploitation of the JET experiments over the next years, includes, within the NEXP subproject, a novel Shutdown Dose Rate (SDR) experiment. Considering its ITER-relevance, SDR experiments at JET represent a unique opportunity to validate the numerical tools for ITER nuclear analysis, through the comparison between numerical predictions and measured quantities (C/E). Within this framework, two active gamma dosimeters based on spherical air-vented ionization chambers (ICs) have been installed in ex-vessel positions close to the horizontal ports of the tokamak in Octants 1 and 2. The first JET campaign exploited in the novel SDR experiment is the latest 5-week Deuterium-Deuterium campaign (c36b), which achieved the best results in recent years in terms of high power operation. The present work is dedicated to the analysis of dose rate measurements carried out during this campaign and after shutdown. Proper correction factors are evaluated and applied to the instrument reading, while influence quantities and error sources are analyzed in order to calculate the overall experimental uncertainty.
|
|
| 52. |
|
|
| 53. |
|
|
| 54. |
- Garcia, J., et al.
(författare)
-
First principles and integrated modelling achievements towards trustful fusion power predictions for JET and ITER
- 2019
-
Ingår i: Nuclear Fusion. - : Institute of Physics Publishing (IOPP). - 0029-5515 .- 1741-4326. ; 59:8
-
Tidskriftsartikel (refereegranskat)abstract
- Predictability of burning plasmas is a key issue for designing and building credible future fusion devices. In this context, an important effort of physics understanding and guidance is being carried out in parallel to JET experimental campaigns in H and D by performing analyses and modelling towards an improvement of the understanding of DT physics for the optimization of the JET-DT neutron yield and fusion born alpha particle physics. Extrapolations to JET-DT from recent experiments using the maximum power available have been performed including some of the most sophisticated codes and a broad selection of models. There is a general agreement that 11-15 MW of fusion power can be expected in DT for the hybrid and baseline scenarios. On the other hand, in high beta, torque and fast ion fraction conditions, isotope effects could be favourable leading to higher fusion yield. It is shown that alpha particles related physics, such as TAE destabilization or fusion power electron heating, could be studied in ITER relevant JET-DT plasmas.
|
|
| 55. |
- Garcia, J., et al.
(författare)
-
On the universality of power laws for tokamak plasma predictions
- 2018
-
Ingår i: Plasma Physics and Controlled Fusion. - : IOP PUBLISHING LTD. - 0741-3335 .- 1361-6587. ; 60:2
-
Tidskriftsartikel (refereegranskat)abstract
- Significant deviations from well established power laws for the thermal energy confinement time, obtained from extensive databases analysis as the IPB98(y, 2), have been recently reported in dedicated power scans. In order to illuminate the adequacy, validity and universality of power laws as tools for predicting plasma performance, a simplified analysis has been carried out in the framework of a minimal modeling for heat transport which is, however, able to account for the interplay between turbulence and collinear effects with the input power known to play a role in experiments with significant deviations from such power laws. Whereas at low powers, the usual scaling laws are recovered with little influence of other plasma parameters, resulting in a robust power low exponent, at high power it is shown how the exponents obtained are extremely sensitive to the heating deposition, the q-profile or even the sampling or the number of points considered due to highly non-linear behavior of the heat transport. In particular circumstances, even a minimum of the thermal energy confinement time with the input power can be obtained, which means that the approach of the energy confinement time as a power law might be intrinsically invalid. Therefore plasma predictions with a power law approximation with a constant exponent obtained from a regression of a broad range of powers and other plasma parameters which can non-linearly affect and suppress heat transport, can lead to misleading results suggesting that this approach should be taken cautiously and its results continuously compared with modeling which can properly capture the underline physics, as gyrokinetic simulations.
|
|
| 56. |
- Gaspar, J., et al.
(författare)
-
Heat flux analysis of Type-I ELM impact on a sloped, protruding surface in the JET bulk tungsten divertor
- 2018
-
Ingår i: Nuclear Materials and Energy. - : ELSEVIER. - 2352-1791. ; 17, s. 182-187
-
Tidskriftsartikel (refereegranskat)abstract
- Tungsten (W) melting due to transient power loads, for example those delivered by edge localised modes (ELMs), is a major concern for next step fusion devices. A series of experiments has been performed on JET to investigate the dynamics of Type-I ELM-induced transient melting. Following initial exposures in 2013 of a W-lamella with sharp leading edge in the bulk W outer divertor, new experiments have been performed in 2016-2017 on a protruding W-lamella with a 15 degrees slope, allowing direct and spatially resolved (0.85 mm/pixel) observation of the top surface using the IR thermography system viewing from the top of the poloidal cross-section. Thermal and IR analysis have already been conducted assuming the geometrical projection of the parallel heat flux on the W-lamellas, thus ignoring the gyro-radius orbit of plasma particles. Although it is well justified during L-mode or inter-ELM period, the hypothesis becomes questionable during ELM when the ion Larmor radius is larger. The goal of this paper is to extend the previous analysis based on the forward approach to the H-mode discharges and investigate in particular the gyro-radius effect during the Type-I ELMs, those used to achieve transient melting on the slope of the protruding W-lamella. Surface temperatures measured by the IR camera are compared with reconstructed synthetic data from 3D thermal modelling using heat loads derived from optical projection of the parallel heat flux (ignoring the gyro-radius orbit), 2D gyro-radius orbit and particle-in-cell (PIC) simulations describing the influence of finite Larmor-radius effects and electrical potential on the deposited power flux. Results show that the ELM power deposition behaves differently than the optical projection of the parallel heat flux, contrary to the L-mode observations, and may thus be due to the much larger gyro-orbits of the energetic ELM ions in comparison to L-mode or inter-ELM conditions.
|
|
| 57. |
- Ghani, Z., et al.
(författare)
-
Characterisation of neutron generators and monitoring detectors for the in-vessel calibration of JET
- 2018
-
Ingår i: Fusion engineering and design. - : ELSEVIER SCIENCE SA. - 0920-3796 .- 1873-7196. ; 136, s. 233-238
-
Tidskriftsartikel (refereegranskat)abstract
- A calibration of the JET neutron detectors was carried out prior to the upcoming deuterium-tritium experimental campaign. Two Compact DT neutron generators (NGs) were purchased for this purpose from VNIIA, Russia. These generators are capable of producing approximately 2 x 10(8) neutrons/s with a DT fusion energy spectrum. Preceding the in-vessel calibration measurements, these compact generators were tested and fully characterised at the UK's National Physical Laboratory (NPL). In order to support the characterisation measurements, detailed neutronics models were developed of the NGs, monitoring detectors and remote handling (RH) apparatus. Neutron spectra calculated from these models have been used to help determine NPL long counter efficiencies and effective centres, as well as NPL reference iron and aluminium activation foil reaction rates. The neutron emission rate has been measured for both generators as a function of angle using absolutely calibrated long counters and the relative emission rate by monitoring single crystal diamond detectors. The measured anisotropy profile is shown to be reproducible with a detailed NG MCNP model. Consequently, the neutron source routine and the MCNP model of the NGs can be reliably used for the analysis of the in-vessel calibration at JET.
|
|
| 58. |
- Giacomelli, L., et al.
(författare)
-
Neutron emission spectroscopy of D plasmas at JET with a compact liquid scintillating neutron spectrometer
- 2018
-
Ingår i: Review of Scientific Instruments. - : AMER INST PHYSICS. - 0034-6748 .- 1089-7623. ; 89:10
-
Tidskriftsartikel (refereegranskat)abstract
- Neutron emission spectroscopy is a diagnostic technique that allows for energy measurements of neutrons born in nuclear reactions. The JET tokamak fusion experiment (Culham, UK) has a special role in this respect as advanced spectrometers for 2.5 MeV and 14 MeV neutrons have been developed here for the first time for measurements of the neutron emission spectrum from D and DT plasmas with unprecedented accuracy. Twin liquid scintillating neutron spectrometers were built and calibrated at the Physikalisch-Technische Bundesanstalt (PTB) (Braunschweig, Germany) and installed on JET in the recent years with tangential-equatorial (KM12) and vertical-radial (KM13) view lines, with the latter only recently operational. This article reports on the performance of KM12 and on the development of the data analysis methods in order to extract physics information upon D ions kinematics in JET auxiliary-heated D plasmas from 2.5 MeV neutron measurements. The comparison of these results with the correspondents from other JET neutron spectrometers is also presented: their agreement allows for JET unique capability of multi-lines of sight neutron spectroscopy and for benchmarking other 14 MeV neutron spectrometers installed on the same lines of sight in preparation for the DT experimental campaign at JET.
|
|
| 59. |
- Giudicotti, L., et al.
(författare)
-
First observation of the depolarization of Thomson scattering radiation by a fusion plasma
- 2018
-
Ingår i: Nuclear Fusion. - : IOP PUBLISHING LTD. - 0029-5515 .- 1741-4326. ; 58:4
-
Tidskriftsartikel (refereegranskat)abstract
- We report the first experimental observation of the depolarization of the Thomson scattering (TS) radiation, a relativistic effect expected to occur in very high T-e plasmas and never observed so far in a fusion machine. A set of unused optical fibers in the collection optics of the high resolution Thomson scattering system of JET has been used to detect the depolarized TS radiation during a JET campaign with T-e <= 8 keV. A linear polarizer with the axis perpendicular to the direction of the incident E-field was placed in front of a fiber optic pair observing a region close to the plasma core, while another fiber pair with no polariser simultaneously observed an adjacent plasma region. The measured intensity ratio was found to be consistent with the theory, taking into account sensitivity coefficients of the two measurement channels determined with post-experiment calibrations and Raman scattering. This depolarization effect is at the basis of polarimetric TS, a different and complementary method for the analysis of TS spectra that can provide significant advantages for T-e measurements in very hot plasmas such as in ITER (T-e <= 40 keV).
|
|
| 60. |
|
|
