| 1. |
- Fenstermacher, M.E., et al.
(författare)
-
DIII-D research advancing the physics basis for optimizing the tokamak approach to fusion energy
- 2022
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 62:4
-
Tidskriftsartikel (refereegranskat)abstract
- DIII-D physics research addresses critical challenges for the operation of ITER and the next generation of fusion energy devices. This is done through a focus on innovations to provide solutions for high performance long pulse operation, coupled with fundamental plasma physics understanding and model validation, to drive scenario development by integrating high performance core and boundary plasmas. Substantial increases in off-axis current drive efficiency from an innovative top launch system for EC power, and in pressure broadening for Alfven eigenmode control from a co-/counter-I p steerable off-axis neutral beam, all improve the prospects for optimization of future long pulse/steady state high performance tokamak operation. Fundamental studies into the modes that drive the evolution of the pedestal pressure profile and electron vs ion heat flux validate predictive models of pedestal recovery after ELMs. Understanding the physics mechanisms of ELM control and density pumpout by 3D magnetic perturbation fields leads to confident predictions for ITER and future devices. Validated modeling of high-Z shattered pellet injection for disruption mitigation, runaway electron dissipation, and techniques for disruption prediction and avoidance including machine learning, give confidence in handling disruptivity for future devices. For the non-nuclear phase of ITER, two actuators are identified to lower the L-H threshold power in hydrogen plasmas. With this physics understanding and suite of capabilities, a high poloidal beta optimized-core scenario with an internal transport barrier that projects nearly to Q = 10 in ITER at ∼8 MA was coupled to a detached divertor, and a near super H-mode optimized-pedestal scenario with co-I p beam injection was coupled to a radiative divertor. The hybrid core scenario was achieved directly, without the need for anomalous current diffusion, using off-axis current drive actuators. Also, a controller to assess proximity to stability limits and regulate β N in the ITER baseline scenario, based on plasma response to probing 3D fields, was demonstrated. Finally, innovative tokamak operation using a negative triangularity shape showed many attractive features for future pilot plant operation.
|
|
| 2. |
- Allen, D.H., et al.
(författare)
-
Modeling the viscoelastic response of GMT structural components
- 2001
-
Ingår i: Composites Science And Technology. - 0266-3538 .- 1879-1050. ; 61:4, s. 503-515
-
Tidskriftsartikel (refereegranskat)abstract
- A glass-mat-reinforced thermoplastic (GMT) composite material has been fabricated from randomly oriented continuous glass fibers embedded in a polypropylene matrix. The mechanical constitution of this composite has been characterized by using a linear viscoelastic micromechanically based material model. This material model has subsequently been implemented to several finite-element computer codes for analysis of structural components fabricated from polypropylene GMT. In this paper several example problems have been studied in order to determine the applicability of this modeling approach to predicting time-dependent deformations due to creep in GMT components. These example problems have been solved by utilizing two commercially available codes: ABAQUS, and ANSYS. Furthermore, results obtained with the codes have been compared to both analytic and experimental results, with varying degrees of success. The paper details these results for each of the example problems considered herein. © 2001 Elsevier Science Ltd. All rights reserved.
|
|
| 3. |
- Allen, S. L., et al.
(författare)
-
C-13 transport studies in L-mode divertor plasmas on DIII-D
- 2005
-
Ingår i: Journal of Nuclear Materials. - : Elsevier BV. - 0022-3115 .- 1873-4820. ; 337-39:03-jan, s. 30-34
-
Tidskriftsartikel (refereegranskat)abstract
- (CH4)-C-13 was injected with a toroidally-symmetric gas system into 22 identical lower-single-null L-mode discharges on DIII-D. The injection level was adjusted so that it did not significantly perturb the core or divertor plasmas, with a duration of similar to 3 s on each shot, for a total of similar to 300 T L of injected particles. The plasma shape remained very constant; the divertor strike points were controlled to similar to 1 cm at the divertor plate. At the beginning of the subsequent machine vent, 29 carbon tiles were removed for nuclear reaction analysis of C-13 content to determine regions of carbon deposition. It was found that only the tiles inboard of the inner strike point had appreciable 1 3 C above background. Visible spectroscopy measurements of the carbon injection and comparisons with modeling are consistent with carbon transport by means of scrape-off layer flow.
|
|
| 4. |
- Wiedorn, Max O., et al.
(författare)
-
Megahertz serial crystallography
- 2018
-
Ingår i: Nature Communications. - : Nature Publishing Group. - 2041-1723. ; 9
-
Tidskriftsartikel (refereegranskat)abstract
- The new European X-ray Free-Electron Laser is the first X-ray free-electron laser capable of delivering X-ray pulses with a megahertz inter-pulse spacing, more than four orders of magnitude higher than previously possible. However, to date, it has been unclear whether it would indeed be possible to measure high-quality diffraction data at megahertz pulse repetition rates. Here, we show that high-quality structures can indeed be obtained using currently available operating conditions at the European XFEL. We present two complete data sets, one from the well-known model system lysozyme and the other from a so far unknown complex of a beta-lactamase from K. pneumoniae involved in antibiotic resistance. This result opens up megahertz serial femtosecond crystallography (SFX) as a tool for reliable structure determination, substrate screening and the efficient measurement of the evolution and dynamics of molecular structures using megahertz repetition rate pulses available at this new class of X-ray laser source.
|
|
| 5. |
- Patil, S., et al.
(författare)
-
ARPES view on surface and bulk hybridization phenomena in the antiferromagnetic Kondo lattice CeRh2Si2
- 2016
-
Ingår i: Nature Communications. - : Springer Science and Business Media LLC. - 2041-1723. ; 7
-
Tidskriftsartikel (refereegranskat)abstract
- The hybridization between localized 4f electrons and itinerant electrons in rare-earth-based materials gives rise to their exotic properties like valence fluctuations, Kondo behaviour, heavy-fermions, or unconventional superconductivity. Here we present an angle-resolved photoemission spectroscopy (ARPES) study of the Kondo lattice antiferromagnet CeRh2Si2, where the surface and bulk Ce-4f spectral responses were clearly resolved. The pronounced 4f0 peak seen for the Ce terminated surface gets strongly suppressed in the bulk Ce-4f spectra taken from a Si-terminated crystal due to much larger f-d hybridization. Most interestingly, the bulk Ce-4f spectra reveal a fine structure near the Fermi edge reflecting the crystal electric field splitting of the bulk magnetic 4f15/2 state. This structure presents a clear dispersion upon crossing valence states, providing direct evidence of f-d hybridization. Our findings give precise insight into f-d hybridization penomena and highlight their importance in the antiferromagnetic phases of Kondo lattices.
|
|
