1. |
|
|
2. |
- Liu, Johan, 1960, et al.
(författare)
-
A General Weibull Model For Reliability Analysis Under Different Failure Criteria Application on Anisotropic conductive adhesive joining technology
- 2004
-
Ingår i: 2004 4th IEEE International Conference on Polymers and Adhesives in Microelectronics and Photonics; Portland, OR; United States; 12 September 2004 through 15 September 2004. - 9780780387447 ; , s. 191-197
-
Konferensbidrag (refereegranskat)abstract
- In this paper a generic four-parameter model has been developed and applied to the ACA flip-chip joining technology for electronics packaging applications. The model can also be used to predict any minimum failure cycles if the maximum acceptable failure criterion (in this case, a preset electrical resistance value) is set. The original reliability testing from which the test data was obtained was carried out on Flip-Chip anisotropically conductive adhesive joints on an FR-4 substrate. In the study, nine types of anisotropic conductive adhesive (ACA) and one non-conductive film (NCF) were used. In total, nearly one thousand single joints were subjected to reliability tests in terms of temperature cycling between -40°C and 125°C with a dwell time of 15 minutes and a ramp rate of 110°C/min. The reliability was characterized by single contact resistance measured using the four-probe method during temperature cycling testing up to 3000 cycles. A single Weibull model is used for two failure definitions defined as larger than 50mΩ and larger than 100 mΩ respectively using the in-situ electrical resistance measurement technique. The failure criteria are incorporated into this Weibull model. This study shows the flexibility and usefulness of Weibull distribution in this type of applications.
|
|
3. |
|
|