| 1. |
- Groenen, M. A., et al.
(författare)
-
Analyses of pig genomes provide insight into porcine demography and evolution
- 2012
-
Ingår i: Nature. - : Springer Science and Business Media LLC. - 0028-0836 .- 1476-4687. ; 491:7424, s. 393-398
-
Tidskriftsartikel (refereegranskat)abstract
- For 10,000 years pigs and humans have shared a close and complex relationship. From domestication to modern breeding practices, humans have shaped the genomes of domestic pigs. Here we present the assembly and analysis of the genome sequence of a female domestic Duroc pig (Sus scrofa) and a comparison with the genomes of wild and domestic pigs from Europe and Asia. Wild pigs emerged in South East Asia and subsequently spread across Eurasia. Our results reveal a deep phylogenetic split between European and Asian wild boars approximately 1 million years ago, and a selective sweep analysis indicates selection on genes involved in RNA processing and regulation. Genes associated with immune response and olfaction exhibit fast evolution. Pigs have the largest repertoire of functional olfactory receptor genes, reflecting the importance of smell in this scavenging animal. The pig genome sequence provides an important resource for further improvements of this important livestock species, and our identification of many putative disease-causing variants extends the potential of the pig as a biomedical model.
|
|
| 2. |
- Li, T., et al.
(författare)
-
Effect of conditioning history on the characterization of hardness of thermo-mechanical densified and heat treated poplar wood
- 2017
-
Ingår i: Holzforschung. - : Walter de Gruyter. - 0018-3830 .- 1437-434X. ; 71:6, s. 515-520
-
Tidskriftsartikel (refereegranskat)abstract
- Poplar wood was modified by a combination of thermo-mechanical densification (TMD) and heat treatment (HT) process at five temperatures ranging from 170 to 210°C. A new two-step conditioning method (CM) is suggested, in the course of which the modified wood is submitted to 50°C/99% RH→25°C/65% RH, where RH means relative humidity in the climate chamber. The traditional one-step CM (25°C/65% RH) served as reference. The effects of conditioning history on hardness were observed and analyzed along with the change of dimensional stability. The hardness of the modified wood was lower in the case of the proposed CM due to more set-recovery release, but the extent of that decreased with the HT temperature. For a good hardness, HT200°C should be selected with the proposed CM, which is different from the optimization output of 180°C obtained from the traditional CM. In conclusion, a specific assessment method for the performance characterization of this type of modified wood would be beneficial for the combined TMD and HT processes.
|
|
| 3. |
|
|
| 4. |
- Suh, Ga Young, et al.
(författare)
-
Multiaxial pulsatile dynamics of the thoracic aorta and impact of thoracic endovascular repair
- 2021
-
Ingår i: European Journal of Radiology Open. - : Elsevier BV. - 2352-0477. ; 8
-
Tidskriftsartikel (refereegranskat)abstract
- Purpose: The thoracic aorta is a highly mobile organ whose dynamics are altered by thoracic endovascular aorta repair (TEVAR). The aim of this study was to quantify cardiac pulsatility-induced multi-axial deformation of the thoracic aorta before and after descending aortic TEVAR. Methods: Eleven TEVAR patients (8 males and 3 females, age 57–89) underwent retrospective cardiac-gated CT angiography before and after TEVAR. 3D geometric models of the thoracic aorta were constructed, and lumen centerlines, inner and outer surface curves, and cross-sections were extracted to measure aortic arclength, centerline, inner surface, and outer surface longitudinal curvatures, as well as cross-sectional effective diameter and eccentricity for the ascending and stented aortic portions. Results: From pre- to post-TEVAR, arclength deformation was increased at the ascending aorta from 5.9 ± 3.1 % to 8.8 ± 4.4 % (P < 0.05), and decreased at the stented aorta from 7.5 ± 5.1 % to 2.7 ± 2.5 % (P < 0.05). Longitudinal curvature and diametric deformations were reduced at the stented aorta. Centerline curvature, inner surface curvature, and cross-sectional eccentricity deformations were increased at the distal ascending aorta. Conclusions: Deformations were reduced in the stented thoracic aorta after TEVAR, but increased in the ascending aorta near the aortic arch, possibly as a compensatory mechanism to maintain overall thoracic compliance in the presence of reduced deformation in the stiffened stented aorta.
|
|
