| 1. |
- Fan, X., et al.
(författare)
-
Reliability of carbon nanotube bumps for chip on glass application
- 2014
-
Ingår i: Proceedings of the 5th Electronics System-Integration Technology Conference, ESTC 2014. - 9781479940264 ; , s. Art. no. 6962753-
-
Konferensbidrag (refereegranskat)abstract
- Carbon nanotubes (CNTs) are an ideal candidate material for electronic interconnects due to their extraordinary thermal, electrical and mechanical properties. In this study, densified CNT bumps utilizing the paper-mediated controlled method were applied as the interconnection for chip on glass (COG) applications, and the silicon chip with patterned CNT bumps was then flipped and bonded onto a glass substrate using anisotropic conductive adhesive (ACA) at a bonding pressure of 127.4 Mpa, 170°C for 8 seconds. The electrical properties of the COG were evaluated with the contact resistance of each bump measured using the four-point probe method. Three different structure traces, marked as Trace A, Trace B, and Trace C, were tested, respectively. Thermal cycling (-40 to 85°C, 800 cycles) and damp heat tests (85°C/85% RH, 1000 hours) were also conducted to evaluate the reliability of the CNT-COG structure. The average contact resistance of the samples was recorded during these tests, in which there was no obvious electrical failure observed after both the thermal cycling and damp heat tests. The results of these tests indicated that the COG has good reliability and the CNT bumps have promising potential applications in COG.
|
|
| 2. |
- Li, X., et al.
(författare)
-
Reliability of Carbon Nanotube Bumps for Chip on Film Application
- 2013
-
Ingår i: Proceedings of the IEEE Conference on Nanotechnology. - 1944-9399 .- 1944-9380. - 9781479906758 ; , s. 845-848
-
Konferensbidrag (refereegranskat)abstract
- Carbon nanotubes (CNTs) are an ideal candidate for electrical interconnects due to their extraordinary thermal, electrical and mechanical properties. In this work, as-densified CNT bumps were applied as chip on film (COF) interconnection material. A silicon chip with patterned CNT bumps was bonded onto a flexible substrate using anisotropic conductive adhesive (ACA) with bonding pressure, at 127.4 MPa, 170 °C and for 8 seconds. The electrical properties of this structure were evaluated by measuring the contact resistance of each bump using the four-point probe method. Thermal cycling (-40∼85°C, 1000 cycles) and damp heat tests (85°C/85% RH, 1000 hours) were conducted to evaluate the reliabilities of the CNT-COF structure bonded with ACA. The average contact resistances of two samples used for the reliability tests were 226 mΩ and 260mΩ. No electrical failure was observed after the damp heat test and only two were observed after the thermal cycling test. The average contact resistance was increased only 15.7% and 13.8%, respectively, after the thermal cycling and the damp heat tests. © 2013 IEEE.
|
|
