| 1. |
|
|
| 2. |
- Andrean, Stefio Y., et al.
(författare)
-
Measurements of sensor radiation damage in the ATLAS inner detector using leakage currents
- 2021
-
Ingår i: Journal of Instrumentation. - : IOP Publishing Ltd. - 1748-0221. ; 16:8
-
Tidskriftsartikel (refereegranskat)abstract
- Non-ionizing energy loss causes bulk damage to the silicon sensors of the ATLAS pixel and strip detectors. This damage has important implications for data-taking operations, charged-particle track reconstruction, detector simulations, and physics analysis. This paper presents simulations and measurements of the leakage current in the ATLAS pixel detector and semiconductor tracker as a function of location in the detector and time, using data collected in Run 1 (2010–2012) and Run 2 (2015–2018) of the Large Hadron Collider. The extracted fluence shows a much stronger |z|-dependence in the innermost layers than is seen in simulation. Furthermore, the overall fluence on the second innermost layer is significantly higher than in simulation, with better agreement in layers at higher radii. These measurements are important for validating the simulation models and can be used in part to justify safety factors for future detector designs and interventions.
|
|
| 3. |
- Andrean, Stefio Y., 1991-, et al.
(författare)
-
The ATLAS Fast TracKer system
- 2021
-
Ingår i: Journal of Instrumentation. - : Institute of Physics Publishing (IOPP). - 1748-0221. ; 16:7
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS Fast TracKer (FTK) was designed to provide full tracking for the ATLAS high-level trigger by using pattern recognition based on Associative Memory (AM) chips and fitting in high-speed field programmable gate arrays. The tracks found by the FTK are based on inputs from all modules of the pixel and silicon microstrip trackers. The as-built FTK system and components are described, as is the online software used to control them while running in the ATLAS data acquisition system. Also described is the simulation of the FTK hardware and the optimization of the AM pattern banks. An optimization for long-lived particles with large impact parameter values is included. A test of the FTK system with the data playback facility that allowed the FTK to be commissioned during the shutdown between Run 2 and Run 3 of the LHC is reported. The resulting tracks from part of the FTK system covering a limited eta-phi region of the detector are compared with the output from the FTK simulation. It is shown that FTK performance is in good agreement with the simulation.
|
|
| 4. |
- del Rio, J. S., et al.
(författare)
-
CEPA: A LaBr 3 (Ce)/LaCl 3 (Ce) phoswich array for simultaneous detection of protons and gamma radiation emitted in reactions at relativistic energies
- 2014
-
Ingår i: EPJ Web of Conferences. - : EDP Sciences. - 2101-6275 .- 2100-014X. ; 66
-
Konferensbidrag (refereegranskat)abstract
- A prototype CEPA4, made of four optically isolated phoswich-crystals of LaBr3(Ce)+LaCl3(Ce) packed together in one can of Al, was tested with high energy protons (70-230 MeV) at the cyclotron of Krakow. Further, the response to different gamma radiation standard sources and cosmic muons was determined. Shape analysis of the pulses derived from the four individually coupled PM-tubes was performed and were used as input functions for Monte Carlo simulations in order to simulate the efficiencies and resolutions of a final detector design consisting of 750 such phoswich crystals arranged in a cylindrical disc. © Owned by the authors, published by EDP Sciences, 2014.
|
|
| 5. |
- del Rio, J. S., et al.
(författare)
-
CEPA: A LaBr3(Ce)/LaCl3(Ce) Phoswich array for simultaneous detection of protons and gamma radiation emitted in reactions at relativistic energies
- 2014
-
Ingår i: International Journal of Modern Physics: Conference Series. Applications of Nuclear Techniques (CRETE13). - 2010-1945. ; 27, s. 1460143-
-
Konferensbidrag (refereegranskat)abstract
- A sophisticated design of 750 LaBr3(Ce):LaCl3(Ce) phoswich crystals (CEPA10) with a segmentation determined by the Doppler correction and an energy resolution of 5% at 1 MeV is presented. Monte Carlo simulations have been performed for high energy protons (50–500 MeV) and gamma radiation (0.5–30 MeV) to determine the length and shape of the crystals for optimum performance of the detector. In the case of protons, the two-layer detector can be used as a ΔELaBr3 − ETot telescope or, for very high energies, as a double energy loss detector (ΔELaBr3 + ΔELaCl3), in order to determine the initial energy. In addition, an experimental test with high energy protons (70–230 MeV) was performed at the cyclotron center in Krakow, Poland with a first prototype of 2 x 2 phoswich rectangular crystals (CEPA4) packed in an aluminum can (0.5 mm case). To simulate CEPA10 efficiencies and resolutions, optical pulses detected in CEPA4 by photomultiplier tubes with a DAQ system were used as energy input functions in Monte Carlo simulations.
|
|
| 6. |
- Machado, J., et al.
(författare)
-
Performance of timing Resistive Plate Chambers with protons from 200 to 800 MeV
- 2015
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 10:1, s. C01043-
-
Tidskriftsartikel (refereegranskat)abstract
- A prototype composed of four resistive plate chamber layers has been exposed to quasi-monoenergetic protons produced from a deuteron beam of varying energy (200 to 800 AMeV) in experiment S406 at GSI, Darmstadt, Germany. The aim of the experiment is to characterize the response of the prototype to protons in this energy range, which deposit from 1.75 to 6 times more energy than minimum ionizing particles. Each layer, with an active area of about 2000 × 500 mm 2 , is made of modules containing the active gaps, all in multigap construction. Each gap is defined by 0.3 mm nylon mono-filaments positioned between 2.85 mm thick float glass electrodes. The modules are operated in avalanche mode with a non-flammable gas mixture composed of 90% C 2 H 2 F 4 and 10% SF 6 . The signals are readout by a pick-up electrode formed by 15 copper strips (per layer), spaced at a pitch of 30 mm, connected at both sides to timing front end electronics. Results show an uniform efficiency close to 100% along with a timing resolution of around 60 ps on the entire 2000 × 500 mm 2 area.
|
|
| 7. |
- Mårtensson, Thomas, et al.
(författare)
-
Epitaxial Growth of Indium Arsenide Nanowires on Silicon Using Nucleation Templates Formed by Self-Assembled Organic Coatings
- 2007
-
Ingår i: Advanced Materials. - : Wiley. - 1521-4095 .- 0935-9648. ; 19, s. 1801-1801
-
Tidskriftsartikel (refereegranskat)abstract
- Indium arsenide nanowires are grown directly on silicon substrates (see figure and cover) using a method employing self-assembled organic coatings to create oxide-based growth templates. High-performance materials, such as InAs, could have great impact on future nanoelectronics if integrated with Si, but integration has so far been hard to realize with other methods.
|
|
| 8. |
- Nacher, E., et al.
(författare)
-
Proton response of CEPA4: A novel LaBr3(Ce)-LaCl3(Ce) phoswich array for high-energy gamma and proton spectroscopy
- 2015
-
Ingår i: Nuclear Instruments and Methods in Physics Research, Section A: Accelerators, Spectrometers, Detectors and Associated Equipment. - : Elsevier BV. - 0168-9002. ; 769, s. 105-111
-
Tidskriftsartikel (refereegranskat)abstract
- A new phoswich array, for the detection of high-energy protons and gamma rays from nuclear reactions, has been built. This new detector consists of four individual closely packed scintillator detectors, each of them made of 4 cm of LaBr3(Ce) and G cm of LaCl3(Ce) in phoswich configuration (optically coupled and with a common readout). In this paper we report on the results of a beam test performed at the Bronowice Cyclotron Centre (CCB) in Krakow, showing the response of this versatile instrument to high energy protons (70-230 MeV). Furthermore, for the first time we prove that we can reconstruct the original energy of fast protons (E > 200 MeV) which pass through the total length of the crystal while still retaining a good energy resolution.
|
|
| 9. |
- Aad, G, et al.
(författare)
-
Search for dark matter in events with missing transverse momentum and a Higgs boson decaying into two photons in pp collisions at √s = 13 TeV with the ATLAS detector
- 2021
-
Ingår i: Journal of High Energy Physics. - : Springer. - 1029-8479 .- 1126-6708. ; 2021:10
-
Tidskriftsartikel (refereegranskat)abstract
- A search for dark-matter particles in events with large missing transverse momentum and a Higgs boson candidate decaying into two photons is reported. The search uses 139 fb−1 of proton-proton collision data collected at s = 13 TeV with the ATLAS detector at the CERN LHC between 2015 and 2018. No significant excess of events over the Standard Model predictions is observed. The results are interpreted by extracting limits on three simplified models that include either vector or pseudoscalar mediators and predict a final state with a pair of dark-matter candidates and a Higgs boson decaying into two photons.
|
|
| 10. |
- Aad, G, et al.
(författare)
-
Search for new phenomena in final states with b-jets and missing transverse momentum in √s = 13 TeV pp collisions with the ATLAS detector
- 2021
-
Ingår i: Journal of High Energy Physics. - : Springer. - 1029-8479 .- 1126-6708.
-
Tidskriftsartikel (refereegranskat)abstract
- The results of a search for new phenomena in final states with b-jets and missing transverse momentum using 139 fb−1 of proton-proton data collected at a centre-of-mass energy s = 13 TeV by the ATLAS detector at the LHC are reported. The analysis targets final states produced by the decay of a pair-produced supersymmetric bottom squark into a bottom quark and a stable neutralino. The analysis also seeks evidence for models of pair production of dark matter particles produced through the decay of a generic scalar or pseudoscalar mediator state in association with a pair of bottom quarks, and models of pair production of scalar third-generation down-type leptoquarks. No significant excess of events over the Standard Model background expectation is observed in any of the signal regions considered by the analysis. Bottom squark masses below 1270 GeV are excluded at 95% confidence level if the neutralino is massless. In the case of nearly mass-degenerate bottom squarks and neutralinos, the use of dedicated secondary-vertex identification techniques permits the exclusion of bottom squarks with masses up to 660 GeV for mass splittings between the squark and the neutralino of 10 GeV. These limits extend substantially beyond the regions of parameter space excluded by similar ATLAS searches performed previously. [Figure not available: see fulltext.] © 2021, The Author(s).
|
|
